Developing thermoelectric materials with superior performance means tailoring interrelated thermoelectric physical parameters – electrical conductivities, Seebeck coefficients, and thermal conductivities – for a crystalline system. High electrical conductivity, low thermal conductivity, and a high Seebeck coefficient are desirable for thermoelectric materials. Therefore, knowledge of the relation between electrical conductivity and thermal conductivity is essential to improve thermoelectric properties. In general, research in recent years has focused on developing thermoelectric structures and materials of high efficiency. The importance of this parameter is universally recognized; it is an established, ubiquitous, routinely used tool for material, device, equipment and process characterization both in the thermoelectric industry and in research. In this paper, basic knowledge of thermoelectric materials and an overview of parameters that affect the figure of merit ZT are provided. The prospects for the optimization of thermoelectric materials and their applications are also discussed.

A review on thermoelectric renewable energy: Principle parameters that affect their performance

Review on battery thermal management system for electric vehicles

Recent development and application of thermoelectric generator and cooler

Thermoelectric (TE) materials have the capability of converting heat into electricity, which can improve fuel efficiency, as well as providing robust alternative energy supply in multiple applications by collecting wasted heat, and therefore, assisting in finding new energy solutions. In order to construct high performance TE devices, superior TE materials have to be targeted via various strategies. The development of high performance TE devices can broaden the market of TE application and eventually boost the enthusiasm of TE material research. This review focuses on major novel strategies to achieve high-performance TE materials and their applications. Manipulating the carrier concentration and band structures of materials are effective in optimizing the electrical transport properties, while nanostructure engineering and defect engineering can greatly reduce the thermal conductivity approaching the amorphous limit. Currently, TE devices are utilized to generate power in remote missions, solar-thermal systems, implantable or/wearable devices, the automotive industry, and many other fields; they are also serving as temperature sensors and controllers or even gas sensors. The future tendency is to synergistically optimize and integrate all the effective factors to further improve the TE performance, so that highly efficient TE materials and devices can be more beneficial to daily lives.

https://espace.library.uq.edu.au/view/UQ:722903/UQ722903_OA.pdf

High Performance Thermoelectric Materials: Progress and Their Applications

Review of organic Rankine cycles for internal combustion engine exhaust waste heat recovery

Exhaust energy conversion by thermoelectric generator: Two case studies

Testing was conducted on a prototype automobile exhaust thermoelectric generator (AETEG) installed in a 1999 GMC Sierra pick-up truck. The system consisted of the generator, its power conditioning unit, and the interfaces to the test truck's engine coolant and exhaust systems. The objective of the test was to measure the AETEG's performance and its effect on the truck systems as well as to determine which factors are important for optimizing an AETEG design. Testing was performed in a dynamometer-equipped wind tunnel at Delphi Corporation's Harrison Thermal Systems Division in Lockport, New York. The first tests established the benchmark data set. Then the prototype AETEG was installed and three configurations of the system were tested in succession: the AETEG alone, the AETEG with portions of the exhaust pipes leading to it insulated, and the AETEG with insulated upstream exhaust pipes and with a pre-cooling heat exchanger operating to lower the inlet coolant temperature to the generator. Some of the important outcomes of the tests were: insulating the exhaust and lowering the coolant temperature had a significant positive effect on the power, parasitic losses resulting from the AETEG weight and the coolant pumping power were significant but manageable, and the increased exhaust flow resistance and the additional heat load from the AETEG were not significant effects.

E.F. Thacher

Papers

Exhaust energy conversion by thermoelectric generator: Two case studies

Testing of an automobile exhaust thermoelectric generator in a light truck

Heat loss and thermoelectric generator design