Parametric investigation of low pressure dual-fuel direct injection on the combustion performance and emissions characteristics in a RCCI engine fueled with diesel and CH4

Experimental study on the spray characteristics of an air-assisted fuel injection system using kerosene and gasoline

Spray performance of air-assisted kerosene injection in a constant volume chamber under various in-cylinder GDI engine conditions

Advances in emission control technologies have seen the introduction of Selective Catalyst Reduction (SCR) systems as a method for NOx decontamination in light and heavy duty vehicles. SCR systems make use of a ureawater solution (UWS) injected directly into the exhaust gas stream for the reduction of NOx contaminants to Nitrogen (N2) over a monolith catalyst [2]. The effectiveness of an SCR system depends on many factors including the type of catalysts, the injection and mixing pattern of the UWS, temperature and more [1].Spray analysis involves multi-phase flow phenomena and requires the numerical solution of the conservation and transport equations for the gas and the liquid phase simultaneously. Spray/wall interaction mechanisms such as droplet splash, spread, rebound or stick are complex to model and directly affected by the injection parameters [4]. The accurate modelling of the UWS injector can help in the prediction of phenomena such as wall film formation, droplet evaporation and urea crystallization [7].This study presents a series of multi-phase numerical analyses, computed with the commercial software AVL Fire 2014 v, to measure the impact of injection velocity, spray angle and droplet size, in the overall performance of an SCR system. The analysis consisted of a completely mixed turbulent flow, solved using a two equations turbulence model (kzetaf). The interaction of the injected particles was solved with an Euler/Lagrange approach, the liquid phase calculation was based on the statistical Discrete Droplet Method interacting with the numerical solution of the conservation equations of the flow pattern.It was found that the injection parameters had an impact on the final results of the ammonia uniformity index (NH3UI) and wall film formation on the SCR system. The method applied in this work successfully predicted the performance of an SCR system. Moreover, a series of response surfaces were created based on a linear regression model which allowed for further design optimization outside of the initial experimental space.

Multiphase injector modelling for automotive SCR systems

Experimental investigation on the spray characteristic of air-assisted hollow-cone gasoline injector

Transient Spray Characteristics of Air Assisted Fuel Injection

Analysis of In-Cylinder Air Motion in a DI Diesel Engine with Four Different Piston Bowl Configuration - A CFD and PIV Comparison

3-D Numerical Study of Effect of Injection Parameters Upon the Uniformity of Ammonia in Urea-SCR

Study on Effect of Engine Operating Parameters on Flame Characteristics

CFD prediction of combustion on direct injection diesel engine with two different combustion chamber configurations

Ganesan Venkitachalam

Papers

Transient Spray Characteristics of Air Assisted Fuel Injection

Analysis of In-Cylinder Air Motion in a DI Diesel Engine with Four Different Piston Bowl Configuration - A CFD and PIV Comparison

3-D Numerical Study of Effect of Injection Parameters Upon the Uniformity of Ammonia in Urea-SCR

Study on Effect of Engine Operating Parameters on Flame Characteristics

CFD prediction of combustion on direct injection diesel engine with two different combustion chamber configurations