http://ieeexplore.ieee.org/iel5/5610941/5624686/05624745.pdf

Power electronics

Traditional electric power systems are designed in large part to utilize large baseload power plants, with limited ability to rapidly ramp output or reduce output below a certain level. The increase in demand variability created by intermittent sources such as photovoltaic (PV) presents new challenges to increase system flexibility. This paper aims to investigate and emphasize the importance of the grid-connected PV system regarding the intermittent nature of renewable generation, and the characterization of PV generation with regard to grid code compliance. The investigation was conducted to critically review the literature on expected potential problems associated with high penetration levels and islanding prevention methods of grid tied PV. According to the survey, PV grid connection inverters have fairly good performance. They have high conversion efficiency and power factor exceeding 90% for wide operating range, while maintaining current harmonics THD less than 5%. Numerous large-scale projects are currently being commissioned, with more planned for the near future. Prices of both PV and balance of system components (BOS) are decreasing which will lead to further increase in use. The technical requirements from the utility power system side need to be satisfied to ensure the safety of the PV installer and the reliability of the utility grid. Identifying the technical requirements for grid interconnection and solving the interconnect problems such as islanding detection, harmonic distortion requirements and electromagnetic interference are therefore very important issues for widespread application of PV systems. The control circuit also provides sufficient control and protection functions like maximum power tracking, inverter current control and power factor control. Reliability, life span and maintenance needs should be certified through the long-term operation of PV system. Further reduction of cost, size and weight is required for more utilization of PV systems. Using PV inverters with a variable power factor at high penetration levels may increase the number of balanced conditions and subsequently increase the probability of islanding. It is strongly recommended that PV inverters should be operated at unity power factor.

Grid-connected photovoltaic power systems: Technical and potential problems—A review

A phase-locked loop (PLL) is a nonlinear negative-feedback control system that synchronizes its output in frequency as well as in phase with its input PLLs are now widely used for the synchronization of power-electronics-based converters and also for monitoring and control purposes in different engineering fields In recent years, there have been many attempts to design more advanced PLLs for three-phase applications The aim of this paper is to provide overviews of these attempts, which can be very useful for engineers and academic researchers

/pdf/three-phase-plls-a-review-of-recent-advances-lyks7vfgc3.pdf

Three-Phase PLLs: A Review of Recent Advances

Synchronous reference frame (SRF) phase-locked loop (PLL) is a critical component for the control and grid synchronization of three-phase grid-connected power converters. The PLL behaviors, especially its low-frequency dynamics, influenced by different grid and load impedances as well as operation mode have not been investigated yet, which may not be captured by conventional linear PLL models. In this paper, we propose a state-feedback quasi-static SRF-PLL model, which can identify and quantify the inherent frequency self-synchronization mechanism in the converter control system. This self-synchronization effect is essentially due to the converter interactions with grid impedance and power flow directions. The low-frequency nonlinear behaviors of the PLL under different grid impedance conditions are then analyzed, which forms the framework of evaluating the impacts of the large penetration level of distributed generation units, weak grid, microgrid, and large reactive power consumption in terms of the frequency stability of PLL. Specifically, the PLL behavior of the converter system under islanded condition is investigated to explain the PLL instability issues and the related islanding-detection methods in early publications and industry reports.

Analysis of Phase-Locked Loop Low-Frequency Stability in Three-Phase Grid-Connected Power Converters Considering Impedance Interactions

The modern electric power systems are going through a revolutionary change because of increasing demand of electric power worldwide, developing political pressure and public awareness of reducing carbon emission, incorporating large scale renewable power penetration, and blending information and communication technologies with power system operation. These issues initiated in establishing microgrid concept which has gone through major development and changes in last decade, and recently got a boost in its growth after being blessed by smart grid technologies. The objective of this paper is to presents a detailed technical overview of microgrid and smart grid in light of present development and future trend. First, it discusses microgrid architecture and functions. Then, smart features are added to the microgrid to demonstrate the recent architecture of smart grid. Finally, existing technical challenges, communication features, policies and regulation, etc. are discussed from where the future smart grid architecture can be visualized.

Enhancing smart grid with microgrids: Challenges and opportunities

In order to improve the efficiency and reduce the cost of a photovoltaic system, the use of transformerless photovoltaic inverters is an alternative of increasing interest. However, this topology needs to be studied in detail, as it presents some problems related to the galvanic connection between the grid and the photovoltaic generator (e.g. efficiency degradation and safety problems). In this paper, a review of grid-connected single-phase photovoltaic inverters based on transformerless topologies has been carried out. On the one hand, some alternatives based on classical topologies have been presented. On the other hand, alternatives based on multi-level inverter topologies have been studied, showing up that no leakage current is generated in comparison to classical topologies.

/pdf/transformerless-topologies-for-grid-connected-single-phase-3gu51aprh1.pdf

Transformerless topologies for grid-connected single-phase photovoltaic inverters

The high penetration of distributed generators, most of them based on renewable energy sources, is modifying the traditional structure of the electric distribution grid. If the power of distributed generators is high enough to feed the loads of a certain area, this area could be disconnected from the main grid and operate in islanded mode. Microgrids are composed by distributed generators, energy storage devices, intelligent circuit breakers and local loads. In this paper, a review of the main microgrid architectures proposed in the literature has been carried out. The microgrid architectures are first classified regarding their AC or DC distribution buses. Besides, more complex microgrid architectures are shown. Both advantages and disadvantages of each one of the microgrid families are discussed.

Microgrid architectures for low voltage distributed generation

The proportional + resonant (PR) controller has been proposed in the past as a suitable method to control the current generated by the grid-connected photovoltaic voltage source inverters. Due to the fact that information regarding the frequency of the grid is needed to use this control technique, the synchronous reference frame phase-locked loop (SRF-PLL) is commonly used. To assure that the total harmonic distortion of the injected current (THDi) meets the appropriate standards, even if the grid voltage is polluted and its frequency varies, an adaptive control strategy is presented in this paper. This control strategy can improve the behavior of both, the conventional SRF-PLL and the conventional PR controller, when they are used in a polluted grid with a time varying frequency. The experimental results obtained by means of a digitally controlled 10-kVA inverter, show up that the THDi of the injected current is improved when the proposed adaptive control strategy replaces the conventional one.

/pdf/an-adaptive-control-system-for-three-phase-photovoltaic-1avdb1gsyv.pdf

An Adaptive Control System for Three-Phase Photovoltaic Inverters Working in a Polluted and Variable Frequency Electric Grid

In testing maximum power point tracking (MPPT) algorithms running on electronic power converters for photovoltaic (PV) applications, either a PV energy source (PV module or PV array) or a PV emulator is required. With a PV emulator, it is possible to control the testing conditions with accuracy so that it is the preferred option. The PV source is modeled as a current source; thus, the emulator has to work as a current source dependent on its output voltage. The proposed emulator is a buck converter with an average current mode control loop, which allows testing the static and dynamic performance of PV facilities up to 3 kW. To validate the concept, the emulator is used to evaluate the MPPT algorithm of a 230-W experimental microinverter working from a single PV module. Copyright © 2012 John Wiley & Sons, Ltd.

/pdf/a-low-cost-photovoltaic-emulator-for-static-and-dynamic-3m1n5ksgxg.pdf

A low-cost photovoltaic emulator for static and dynamic evaluation of photovoltaic power converters and facilities

This study presents a transformerless topology for a grid-tied single-phase inverter capable of performing the simultaneous maximum power point tracking of two independent and series connected photovoltaic sources. This topology is derived from the neutral point clamped multilevel inverter in half-bridge configuration. The use of a half-bridge topology reduces the leakage current to very low values, whereas the multilevel topology presents an output voltage quality similar to that of a full-bridge inverter. To simultaneously track the maximum power of both photovoltaic sources, a generation control circuit is used. With this topology, it is possible to improve the performance of the converter under partial shadowing conditions, very common in photovoltaic facilities operating in residential areas. A 5 kW prototype of this topology has been implemented and tested in the laboratory.

Iván Patrao

Papers

Transformerless topologies for grid-connected single-phase photovoltaic inverters

Microgrid architectures for low voltage distributed generation

An Adaptive Control System for Three-Phase Photovoltaic Inverters Working in a Polluted and Variable Frequency Electric Grid

A low-cost photovoltaic emulator for static and dynamic evaluation of photovoltaic power converters and facilities

Grid-tie inverter topology with maximum power extraction from two photovoltaic arrays