A significant increase in the research activity dedicated to high manganese TWIP steels has occurred during the past five years, motivated by the breakthrough combination of strength and ductility possessed by these alloys. Here a review of the relations between microstructure and mechanical properties is presented focusing on plasticity mechanisms, strain-hardening, yield stress, texture, fracture and fatigue. This summarized knowledge explains why TWIP steel metallurgy is currently a topic of great practical interest and fundamental importance. Finally, this publication indicates some of the main avenues for future investigations required in order to sustain the quality and the dynamism in this field.

High manganese austenitic twinning induced plasticity steels: A review of the microstructure properties relationships

Twinning-induced plasticity (TWIP) steels

The tensile properties of carbon-containing twinning induced plasticity (TWIP) steels and their temperature dependence were investigated. Two steels with carbon concentrations of 0.6% and 0.8% (w/w) were tensile-tested at 173, 223, 273, 294, and 373 K. Three deformation modes were observed during tensile testing: ɛ -martensitic transformation, deformation twinning, and dynamic strain aging. The characteristic deformation mode that contributed to the work hardening rates changed with the deformation temperature and chemical compositions. The work hardening rate in the carbon-containing TWIP steels increased according to the deformation modes in the following order: ɛ -martensitic transformation > deformation twinning > dynamic strain aging.

Work hardening associated with ɛ-martensitic transformation, deformation twinning and dynamic strain aging in Fe–17Mn–0.6C and Fe–17Mn–0.8C TWIP steels

Effect of temperature on the fatigue-crack growth behavior of the high-entropy alloy CrMnFeCoNi

Low-cycle and extremely-low-cycle fatigue behaviors of high-Mn austenitic TRIP/TWIP alloys: Property evaluation, damage mechanisms and life prediction

The crack growth behavior of a high-manganese austenitic steel, which exhibits the twinning-induced plasticity (TWIP) effect, was investigated under positive stress ratios. An experimental study making use of miniature compact tension (CT) specimens and thorough microstructural analyses including transmission electron microscopy and fracture analyses demonstrated that the microstructural evolution in the plastic zone of the fatigued TWIP CT specimens is substantially different as compared to the monotonic plastic deformation case. Specifically, the twin density in the plastic zone of the CT specimens is very low, leading to the conclusion that the deformation mechanisms depend drastically on the loading conditions. The absence of twinning under cyclic loading in the plastic zone of the CT specimens indicates that even large accumulated plastic strains are not sufficient to cause substantial twinning in the TWIP steel. This lack of hardening preserves the ductile character of the TWIP steel in the plastic zone ahead of the crack tip and provides for a crack growth rate in the Paris regime lower than reported for other high strength steels.

J. Niendorf

Papers

Fatigue crack growth—Microstructure relationships in a high-manganese austenitic TWIP steel