Shear-banding is a ubiquitous plastic-deformation mode in materials. In metallic glasses, shear bands are particularly important as they play the decisive role in controlling plasticity and failure at room temperature. While there have been several reviews on the general mechanical properties of metallic glasses, a pressing need remains for an overview focused exclusively on shear bands, which have received tremendous attention in the past several years. This article attempts to provide a comprehensive and up-to-date review on the rapid progress achieved very recently on this subject. We describe the shear bands from the inside out, and treat key materials-science issues of general interest, including the initiation of shear localization starting from shear transformations, the temperature and velocity reached in the propagating or sliding band, the structural evolution inside the shear-band material, and the parameters that strongly influence shear-banding. Several new discoveries and concepts, such as stick-slip cold shear-banding and strength/plasticity enhancement at sub-micrometer sample sizes, will also be highlighted. The understanding built-up from these accounts will be used to explain the successful control of shear bands achieved so far in the laboratory. The review also identifies a number of key remaining questions to be answered, and presents an outlook for the field.

Shear bands in metallic glasses

Design of a novel Mn-based 1 GPa duplex stainless TRIP steel with 60% ductility by a reduction of austenite stability

Mechanical behavior of high-entropy alloys

Experimental and numerical analysis on formation of stable austenite during the intercritical annealing of 5Mn steel

Recent advances in the development of high performance steels presenting improved properties of strength and ductility rely on the TRIP effect, i.e. on the mechanically-induced martensitic transformation of the retained austenite dispersed in a soft ferrite-based matrix. As a consequence, the stabilisation and retention of austenite at room temperature have become of primary importance, leading to specifically designed steel grades and thermal or thermomechanical treatments. Particularly, carbon enrichment of the austenite during intercritical annealing and bainite transformation was found to be very effective in retaining austenite. This metastable austenite then progressively transforms during straining, bringing about a large increase of the work hardening rate. This increase results from the stress and strain partitioning continuously evolving with the appearance of the hard martensite. (c) 2004 Elsevier Ltd. All rights reserved.

J. Ohlert

Papers

A study of microstructure, transformation mechanisms and correlation between microstructure and mechanical properties of a low alloyed TRIP steel