1. Advantages of Chemical Redox Agents 878 2. Disadvantages of Chemical Redox Agents 879 C. Potentials in Nonaqueous Solvents 879 D. Reversible vs Irreversible ET Reagents 879 E. Categorization of Reagent Strength 881 II. Oxidants 881 A. Inorganic 881 1. Metal and Metal Complex Oxidants 881 2. Main Group Oxidants 887 B. Organic 891 1. Radical Cations 891 2. Carbocations 893 3. Cyanocarbons and Related Electron-Rich Compounds 894

/pdf/chemical-redox-agents-for-organometallic-chemistry-4fs84ntwp8.pdf

Chemical Redox Agents for Organometallic Chemistry

ion. The oxidative addition mechanism was originally proposed22i because of the lack of a strong rate dependence on polar factors and on the acidity of the medium. Later, however, the electrophilic substitution mechanism also was proposed. Recently, the oxidative addition mechanism was confirmed by investigations into the decomposition and protonolysis of alkylplatinum complexes, which are the reverse of alkane activation. There are two routes which operate in the decomposition of the dimethylplatinum(IV) complex Cs2Pt(CH3)2Cl4. The first route leads to chloride-induced reductive elimination and produces methyl chloride and methane. The second route leads to the formation of ethane. There is strong kinetic evidence that the ethane is produced by the decomposition of an ethylhydridoplatinum(IV) complex formed from the initial dimethylplatinum(IV) complex. In D2O-DCl, the ethane which is formed contains several D atoms and has practically the same multiple exchange parameter and distribution as does an ethane which has undergone platinum(II)-catalyzed H-D exchange with D2O. Moreover, ethyl chloride is formed competitively with H-D exchange in the presence of platinum(IV). From the principle of microscopic reversibility it follows that the same ethylhydridoplatinum(IV) complex is the intermediate in the reaction of ethane with platinum(II). Important results were obtained by Labinger and Bercaw62c in the investigation of the protonolysis mechanism of several alkylplatinum(II) complexes at low temperatures. These reactions are important because they could model the microscopic reverse of C-H activation by platinum(II) complexes. Alkylhydridoplatinum(IV) complexes were observed as intermediates in certain cases, such as when the complex (tmeda)Pt(CH2Ph)Cl or (tmeda)PtMe2 (tmeda ) N,N,N′,N′-tetramethylenediamine) was treated with HCl in CD2Cl2 or CD3OD, respectively. In some cases H-D exchange took place between the methyl groups on platinum and the, CD3OD prior to methane loss. On the basis of the kinetic results, a common mechanism was proposed to operate in all the reactions: (1) protonation of Pt(II) to generate an alkylhydridoplatinum(IV) intermediate, (2) dissociation of solvent or chloride to generate a cationic, fivecoordinate platinum(IV) species, (3) reductive C-H bond formation, producing a platinum(II) alkane σ-complex, and (4) loss of the alkane either through an associative or dissociative substitution pathway. These results implicate the presence of both alkane σ-complexes and alkylhydridoplatinum(IV) complexes as intermediates in the Pt(II)-induced C-H activation reactions. Thus, the first step in the alkane activation reaction is formation of a σ-complex with the alkane, which then undergoes oxidative addition to produce an alkylhydrido complex. Reversible interconversion of these intermediates, together with reversible deprotonation of the alkylhydridoplatinum(IV) complexes, leads to multiple H-D exchange

Activation of c-h bonds by metal complexes

5.7. [32π + 32σ] Cycloadditions 74 5.8. [44π + 22π] Cycloadditions 75 6. Seven-Membered Ring Formation 78 6.1. [44π + 32σ] Cycloadditions 78 6.2. [52π+2σ + 22π] Cycloadditions 79 7. Eight-Membered Ring Formation 79 7.1. [22π + 22π + 22π + 22π] Cycloadditions 80 7.2. [44π + 22π + 22π] Cycloadditions 80 7.3. [44π + 44π] Cycloadditions 81 7.4. [66π + 22π] Cycloadditions 83 8. Ten-Membered Ring Formation 85 9. Conclusion and Remarks 87

Transition Metal-Mediated Cycloaddition Reactions

Enzyme-like catalysis by molecularly imprinted polymers.

The Yen–Mullins model, also known as the modified Yen model, specifies the predominant molecular and colloidal structure of asphaltenes in crude oils and laboratory solvents and consists of the following: The most probable asphaltene molecular weight is ∼750 g/mol, with the island molecular architecture dominant. At sufficient concentration, asphaltene molecules form nanoaggregates with an aggregation number less than 10. At higher concentrations, nanoaggregates form clusters again with small aggregation numbers. The Yen–Mullins model is consistent with numerous molecular and colloidal studies employing a broad array of methodologies. Moreover, the Yen–Mullins model provides a foundation for the development of the first asphaltene equation of state for predicting asphaltene gradients in oil reservoirs, the Flory–Huggins–Zuo equation of state (FHZ EoS). In turn, the FHZ EoS has proven applicability in oil reservoirs containing condensates, black oils, and heavy oils. While the development of the Yen–Mullin...

Advances in Asphaltene Science and the Yen–Mullins Model

Selective hydride-mediated conjugate reduction of .alpha.,.beta.-unsaturated carbonyl compounds using [(Ph3P)CuH]6

The components of petroleum asphaltenes exhibit complex bridged structures comprising sulfur, nitrogen, aromatic, and naphthenic groups linked by alkyl chains. These components aggregate in crude o...

Supramolecular Assembly Model for Aggregation of Petroleum Asphaltenes

[5 + 2] Cycloaddition Reactions in Organic and Natural Product Synthesis

A structural, kinetic and thermodynamic study of the reversible thermal carbon-hydrogen bond activation/reductive elimination of alkanes at iridium

Hydride-mediated reduction of {alpha},{beta}-unsaturated ketones catalytic in the hydride reagent is reported using ((Ph{sub 3}P)CuH){sub 6} and molecular hydrogen. The reaction proceeds at room temperature and is highly regioselective, affording either the product of conjugate reduction or complete 1,4- and 1,2-reduction to the saturated alcohol, depending on reaction conditions. In the presence of excess phosphine, the process is homogeneous and chemoselective: isolated double bonds are not hydrogenated, even under forcing conditions. This novel catalytic reduction appears to proceed via the heterolytic activation of molecular hydrogen by highly reactive copper(I) enolate and alkoxide intermediates.

Jeffrey M. Stryker

Papers

Selective hydride-mediated conjugate reduction of .alpha.,.beta.-unsaturated carbonyl compounds using [(Ph3P)CuH]6

Supramolecular Assembly Model for Aggregation of Petroleum Asphaltenes

[5 + 2] Cycloaddition Reactions in Organic and Natural Product Synthesis

A structural, kinetic and thermodynamic study of the reversible thermal carbon-hydrogen bond activation/reductive elimination of alkanes at iridium

Hydride-mediated homogeneous catalysis. Catalytic reduction of .alpha.,.beta.-unsaturated ketones using [(Ph3P)CuH]6 and H2