Influence of interceptors, stern flaps, and their combinations on the hydrodynamic performance of a deep-vee ship

The interceptor hydrodynamic analysis for controlling the porpoising instability in high speed crafts

An experimental investigation of interceptors for a high speed hull

Interceptor design for optimum trim control and minimum resistance of planing boats

Interceptor and trim tab combination to prevent interceptor's unfit effects

Nowadays, the use of interceptor by both partial and total dynamic lift crafts is quite common. In this article, a lot of evidence is given regarding the effectiveness of interceptor. The interceptor, when placed at the stern region, changes the pressure distribution around the craft. Its presence affects drag force, lifting force and the position of pressure's center leading to a new trim. This study focuses on hydrodynamic effects of interceptors on a 2-D flat plate based on both computational fluid dynamic (CFD) and experimental approaches. The Reynolds average Navier-Stokes (RANS) equations are used to model the flow around a fixed flat plate with an interceptor at different heights and attack angles. Based on finite volume method and SIMPLE algorithm which uses static structures, this model can be analyzed and the RANS results can be compared with the experimental data obtained in the current channel of the laboratory of waves and current of COPPE/UFRJ (LOC in Portuguese acronym). According to the results, the increase of pressure at the end of the flat plate was proportional to the interceptor height. In addition, the existence of interceptors can significantly increase the lift force coefficient at high angles of attack also proportional to the interceptor height. The presence of interceptor at the end of the flat plate increased both the lift coefficient and the drag coefficient but hydrodynamic drag did not grow as fast as the lift coefficient did. The lift coefficient increased much more. Furthermore, the results showed that the interceptor effectiveness is proportional to the boundary layer thickness at the end of the flat plate. As the interceptor was inside the boundary layer alterations of flow speed led to changes in boundary layer thickness, directly affecting interceptor's efficiency. Optimum choice of interceptor height had a great effect on its efficiency, and in choosing it the flow speed and length of the boat must be taken into consideration.

M. Mansoori

Papers

The interceptor hydrodynamic analysis for controlling the porpoising instability in high speed crafts

Hydrodynamics of the interceptor on a 2-D flat plate by CFD and experiments

Interceptor design for optimum trim control and minimum resistance of planing boats

Interceptor and trim tab combination to prevent interceptor's unfit effects

Hydrodynamics of the Interceptor Analysis Via Both Ultrareduced Model Test and Dynamic Computational Fluid Dynamics Simulation