scispace - formally typeset
M

Munish Kumar Gupta

Researcher at Opole University of Technology

Publications -  238
Citations -  7334

Munish Kumar Gupta is an academic researcher from Opole University of Technology. The author has contributed to research in topics: Machining & Tool wear. The author has an hindex of 31, co-authored 192 publications receiving 3462 citations. Previous affiliations of Munish Kumar Gupta include National Institute of Technology, Hamirpur & Chinese Ministry of Education.

Papers
More filters
Journal ArticleDOI

An approach to cleaner production for machining hardened steel using different cooling-lubrication conditions

Mozammel Mia, +4 more
- 20 Jun 2018 - 
TL;DR: In this article, the effect of three sustainable techniques, along with the traditional flood cooling system, on prominent machining indices such as cutting temperature, surface roughness, chip characteristics and tool wear in plain turning of hardened AISI 1060 steel has been investigated.
Journal ArticleDOI

Effects of hybrid Al2O3-CNT nanofluids and cryogenic cooling on machining of Ti–6Al–4V

Muhammad Jamil, +6 more
- 02 Mar 2019 - 
TL;DR: In this article, an attempt has been made to evaluate the effectiveness of two cooling and lubrication techniques namely cryogenic cooling and hybrid nanoadditive-based minimum quantity lubrication (MQL).
Journal ArticleDOI

Optimization of machining parameters and cutting fluids during nano-fluid based minimum quantity lubrication turning of titanium alloy by using evolutionary techniques

Munish Kumar Gupta, +2 more
- 01 Nov 2016 - 
TL;DR: In this paper, the effect of cutting fluid types is investigated as a function of three machining parameters (cutting speed, feed rate and approach angle) on responses (cutting force, cutting temperature, tool wear and surface roughness) while turning titanium alloy under nano-fluid based minimum quantity lubrication (NFMQL) environment.
Journal ArticleDOI

Multi-objective optimization and life cycle assessment of eco-friendly cryogenic N2 assisted turning of Ti-6Al-4V

Mozammel Mia, +7 more
- 10 Feb 2019 - 
TL;DR: In this paper, the cutting force, specific energy, temperature, surface quality (i.e. surface roughness), and material removal rate under the impingement of liquid nitrogen (LN2) as mono-jet and dual-jets were investigated.
Journal ArticleDOI

Improvement of machinability of Ti and its alloys using cooling-lubrication techniques: a review and future prospect

Danil Yu. Pimenov, +10 more
- 01 Mar 2021 - 
TL;DR: An extensive analysis of the literature on such cooling techniques as dry, conventional cooling system, minimum quantity of lubricant (MQL), minimum quantity cooling lubrication (MQCL), cryogenic lubrication, and high pressure cooling (HPC) is performed as mentioned in this paper.