Friction stir welding (FSW) is a widely used solid state joining process for soft materials such as aluminium alloys because it avoids many of the common problems of fusion welding. Commercial feasibility of the FSW process for harder alloys such as steels and titanium alloys awaits the development of cost effective and durable tools which lead to structurally sound welds consistently. Material selection and design profoundly affect the performance of tools, weld quality and cost. Here we review and critically examine several important aspects of FSW tools such as tool material selection, geometry and load bearing ability, mechanisms of tool degradation and process economics.

Review: friction stir welding tools

http://plast.me.tut.ac.jp/present/joining_CIRP.pdf

Joining by plastic deformation

The diversity and never-ending desire for a better life standard result in a continuous development of the existing manufacturing technologies. In line with these developments in the existing production technologies the demand for more complex products increases, which also stimulates new approaches in production routes of such products, e.g., novel welding procedures. For instance, the friction stir welding (FSW) technology, developed for joining difficult-to-weld Al-alloys, has been implemented by industry in manufacturing of several products. There are also numerous attempts to apply this method to other materials beyond Al-alloys. However, the process has not yet been implemented by industry for joining these materials with the exception of some limited applications. The microstructures and mechanical properties of friction stir welded Al-alloys existing in the open literature will be discussed in detail in this review. The correlations between weld parameters used during FSW and the microstructures evolved in the weld region and thus mechanical properties of the joints produced will be highlighted. However, the modeling studies, material flow, texture formation and developments in tool design are out of the scope of this work as well as the other variants of this technology, such as friction stir spot welding (FSSW).

Recent Developments in Friction Stir Welding of Al-alloys

Microstructural evolution and mechanical properties of dissimilar Al–Cu joints produced by friction stir welding

In this study, dissimilar AA7075-O/6061-O and AA7075-T6/6061-T6 butt joints were produced by friction stir welding (FSW), and postweld heat treatment (PWHT) was applied to the joints obtained. The effects of initial temper condition and PWHT on the microstructure and mechanical properties of the dissimilar joints were thus investigated. It was demonstrated that sound dissimilar joints can be produced for both temper conditions. A hardness increase in the joint area (i.e., strength overmatching) was obtained in the joints produced in the O-temper condition, whereas a hardness loss was observed in the joint area of the joints obtained in the T6 temper condition. It was also well demonstrated that PWHT could be used in order to improve the joint properties for both O and T6 joints provided that the joint is defect-free prior to subsequent heat treatment.

Effects of Initial Temper Condition and Postweld Heat Treatment on the Properties of Dissimilar Friction-Stir-Welded Joints between AA7075 and AA6061 Aluminum Alloys

N.K. Mehta

Papers

The microstructure and mechanical properties of friction stir welded Al–Zn–Mg alloy in as welded and heat treated conditions