Boundary conditions for direct simulations of compressible viscous flows

Perturbed Free Shear Layers

In the present study, it is shown that the spreading rate of a mixing layer can be greatly manipulated at very low forcing level if the mixing layer is perturbed near a subharmonic of the most-amplified frequency. The subharmonic forcing technique is able to make several vortices merge simultaneously and hence increases the spreading rate dramatically. A new mechanism, ‘collective interaction’, was found which can bypass the sequential stages of vortex merging and make a large number of vortices (ten or more) coalesce.A deeper physical insight into the evolution of the coherent structures is revealed through the investigation of a forced mixing layer. The stability and the forcing function play important roles in determining the initial formation of the vortices. The subharmonic starts to amplify at the location where the phase speed of the subharmonic matches that of the fundamental. The position where vortices are seen to align vertically coincides with the position where the measured subharmonic reaches its peak. This location is defined as the merging location, and it can be determined from the feedback equation (Ho & Nosseir 1981).The spreading rate and the velocity profiles of the forced mixing layer are distinctly different from the unforced case. The data show that the initial condition has a longlasting effect on the development of the mixing layer.

https://www.cambridge.org/core/services/aop-cambridge-core/content/view/S0022112082001438

Subharmonics and vortex merging in mixing layers

The effect of periodic two-dimensional excitation on the development of a turbulent mixing region was studied experimentally. Controlled oscillations of variable ampli- tude and frequency were applied at the initiation of mixing between two parallel air streams. The frequency of forcing was at least an order of magnitude lower than the initial instability frequency of the flow in order to test its effect far downstream. The effect of the velocity difference between the streams was also investigated in this experiment. A typical Reynolds number based on the velocity difference and the momentum thickness of the shear layer was l04.It was determined that the spreading rate of the mixing layer is sensitive to periodic surging even if the latter is so small that it does not contribute to the initial energy of the fluctuations. Oscillations at very small amplitudes tend to increase the spreading rate of the flow by enhancing the amalgamation of neighbouring eddies, but at higher amplitudes the flow resonates with the imposed oscillation. The resonance region can extend over a significant fraction of the test section depending on the Strouhal number and a dimensionless velocity-difference parameter. The flow in the resonance region consists of a single array of large, quasi-two-dimensional vortex lumps, which do not interact with one another. The exponential shape of the mean-velocity distribution is not affected in this region, but the spreading rate of the flow with increasing distance downstream is inhibited. The Reynolds stress in this region changes sign, indicating that energy is extracted from the turbulence to the mean motion; the intensity of the spanwise fluctuations is also reduced, suggesting that the flow tends to become more two-dimensional.Amalgamation of large coherent eddies is resumed beyond the resonance region, but the flow is not universally similar. There are many indications suggesting that the large eddies in the turbulent mixing layer at fairly large Re are governed by an inviscid instability.

The forced mixing layer between parallel streams

In a high-speed subsonic jet impinging on a flat plate, the surface pressure fluctuations have a broad spectrum due to the turbulent nature of the high-Reynolds-number jet. However, these pressure fluctuations dramatically change their pattern into almost periodic waves, if the plate is placed close to the nozzle (x0/d < 7·5). In the present study extensive measurements of the near-field pressure provide solid support for the hypothesis that a feedback mechanism is responsible for the sudden change observed in the pressure fluctuations at the onset of resonance. The feedback loop consists of two elements: the downstream-convected coherent structures and upstream-propagating pressure waves generated by the impingement of the coherent structures on the plate. The upstream-propagating waves and the coherent structures are phase-locked at the nozzle exit. The upstream-propagating waves excite the thin shear layer near the nozzle lip and produce periodic coherent structures. The period is determined by the convection speed of the coherent structures, the speed of the upstream-propagating waves as well as the distance between the nozzle and the plate. An instability process, herein referred to as the ‘collective interaction’, was found to be critical in closing the feedback loop near the nozzle lip.

Dynamics of an impinging jet. Part 1. The feedback phenomenon

The aerodynamic noise generated by a subsonic jet impinging on a flat plate is studied from measurements of near-field and surface-pressure fluctuations. The far-field noise measured at 90° to the jet axis is found to be generated by two different physical mechanisms. One mechanism is the impinging of the large coherent structures on the plate, and the other is associated with the initial instability of the shear layer. These two sources of noise radiate to the far field via different acoustical paths.

Dynamics of an impinging jet. Part 2. The noise generation

Etude de la formation d'un tourbillon et de l'influence des dimensions de la chambre de combustion

Characteristics of jet impingement in a side-dump combustor

Etude experimentale de l'impact de deux jets turbulents axisymetriques l'un sur l'autre. L'angle d'impact est de 180° et les jets sont issus de grandes plaques planes. Caracteristiques du champ d'ecoulement et des perturbations de pression

N. Nosseir

Papers

Dynamics of an impinging jet. Part 1. The feedback phenomenon

Dynamics of an impinging jet. Part 2. The noise generation

Characteristics of jet impingement in a side-dump combustor

Pressure field generated by jet-on-jet impingement

Tests of a theoretical model of jet noise