Data Reduction And Error Analysis For The Physical Sciences

a time as one year after leaving the Rehabilitation Unit, and about one quarter were not in competitive jobs but were in sheltered employment. Only just over one quarter were still working in ordinary jobs. Their average wage was £8 I is. 6d. Furthermore if one compares the type of work these patients were able to perform there was a definite decline from their premorbid position. The social class grouping before and after rehabilitation was Class II, i-i, Class III, 9-3, Class IV, 4-6, and Class V, IO-I4. Indeed the authors report that 'even the least handicapped of these patients presented continuous problems . . .' and it is noted that such a programme requires special personnel and a great deal of work. Comparing these results with the extra cost in personnel, time, and effort (which could be directed elsewhere) a Doctor Beeching of the psychiatric services would probably scrap such a rehabilitation service before it even started. But is this the right way of looking at it? The authors point out that such a programme, if applied throughout the country, would affect about 6,ooo patients. If the failure rate were the same as in this experiment, about I,500 would be rescued from a disabled life in a mental hospital and once more returned to an at least partially useful and, one assumes, more satisfying life. Obviously more is involved here than mere economics. We were interested to read that as regards behaviour at the Rehabilitation Centre and during the follow-up year 'There were no outstanding differences' between the schizophrenic and the non-schizophrenic rehabilitees. It appears that the group of schizophrenics had difficulties in social adjustment which were even greater than those of work adjustment. '. . . the men concerned had greater difficulty in living outside hospital, than in working outside hospital. If, however, adequate arrangements are made to cater for these various needs, there seems to be every reason to expect that a small selected group of long stay schizophrenic patients can be successfully resettled in work.' The experiment and the report show the high standards we have come so confidently to expect from Dr. Wing and his colleagues, and the publication will be read with interest, not only by psychiatrists, but by all those concemed with rehabilitation problems of chronically disabled patients. J. HOENIG

https://oem.bmj.com/content/oemed/23/2/161.2.full.pdf

The Mechanics of Aerosols

Innovation in concentrated solar power

This work focuses on innovation in CSP technologies over the last decade. A multitude of advancements has been developed during this period, as the topic of concentrated solar power is becoming more mainstream. Improvements have been made in reflector and collector design and materials, heat absorption and transport, power production and thermal storage. Many applications that can be integrated with CSP regimes to conserve (and sometimes produce) electricity have been suggested and implemented, keeping in mind the environmental benefits granted by limited fossil fuel usage.

Innovation in Concentrated Solar Power

This paper presents a state-of-the-art review on various techniques of heat transfer enhancement in latent heat thermal energy storage (LHTES) systems. Heat transfer enhancement in LHTES systems can be achieved through either geometric configuration and/or thermal conductivity enhancement. The use of extended surfaces such as fins or heat pipes is a common technique for heat transfer enhancement in LHTES systems and therefore, reviewed in details in this paper. Next, we studied the thermal conductivity enhancement techniques, which include the use of porous materials, nanoparticles with high thermal conductivity, and low-density materials. Finally, studies involving combined techniques for heat transfer enhancement are reviewed in the paper. The paper discusses research gaps in the methods of heat transfer enhancement for LHTES systems and proposed some recommendations.

Heat transfer enhancement of phase change materials for thermal energy storage applications: A critical review

Numerical simulation of parabolic trough solar collector: Improvement using counter flow concentric circular heat exchangers

Numerical simulation of a Linear Fresnel Reflector Concentrator used as direct generator in a Solar-GAX cycle

Numerical simulation of triple concentric-tube heat exchangers

Numerical simulation and experimental validation of coiled adiabatic capillary tubes

A detailed one-dimensional steady and transient numerical simulation of the thermal and fluid-dynamic behaviour of double-pipe heat exchangers (evaporators and condensers) has been carried out. The governing equations (continuity, momentum and energy) inside the internal tube and the annulus, together with the energy equation in the internal tube wall, external tube wall and insulation, are solved iteratively in a segregated manner. The discretized governing equations in the zones with fluid flow are efficiently coupled using an implicit step by step method. This formulation requires the use of empirical correlations for the evaluation of convective heat transfer, shear stress and void fraction. An implicit central difference numerical scheme and a line-by-line solver was used in the internal and external tube walls and insulation. A special treatment has been implemented in order to consider transitions (single-phase/two-phase, dry-out,…). All the flow variables (enthalpies, temperatures, pressures, mass fractions, velocities, heat fluxes,…) together with the thermophysical properties are evaluated at each point of the grid in which the domain is discretized. Different numerical aspects and comparisons with analytical and experimental results are presented in order to verify and validate the model.

Octavio García-Valladares

Papers

Numerical simulation of parabolic trough solar collector: Improvement using counter flow concentric circular heat exchangers

Numerical simulation of a Linear Fresnel Reflector Concentrator used as direct generator in a Solar-GAX cycle

Numerical simulation of triple concentric-tube heat exchangers

Numerical simulation and experimental validation of coiled adiabatic capillary tubes

Numerical simulation of double-pipe condensers and evaporators