Synthesis of Ag/polyaniline nanocomposite via an in situ photo-redox mechanism

Optical and electrical transport properties of polyaniline–silver nanocomposite

A Facile Solution Route for Polymeric Hollow Spheres with Controllable Size

On the basis of nanocellulose obtained by acidic swelling and ultrasonication, rodlike nanocellulose/polyaniline nanocomposites with a core–shell structure have been prepared via in situ polymerization. Compared to pure polyaniline, the nanocomposites show superior film-forming properties, and the prepared nanocomposite films demonstrate excellent electrochemical and electrochromic properties in electrolyte solution. Nanocomposite films, especially the one prepared with 40% polyaniline coated nanocomposite, exhibited faster response time (1.5 s for bleaching and 1.0 s for coloring), higher optical contrast (62.9%), higher coloration efficiency (206.2 cm2/C), and more remarkable switching stability (over 500 cycles). These novel nanocellulose-based nanorod network films are promising novel electrochromic materials with excellent properties.

Preparation, Characterization, and Electrochromic Properties of Nanocellulose-Based Polyaniline Nanocomposite Films

Nanowires of silver–polyaniline nanocomposite synthesized via in situ polymerization and its novel functionality as an antibacterial agent

Spectroscopic [UV–visible and Fourier transform IR (FTIR)] and thermal properties of chemically synthesized polyanilines are found to be affected by varying the protonation media (acetic, citric, oxalic, and tartaric acid). The optical spectra show the presence of a greater fraction of fully oxidized insulating pernigraniline phase in polyaniline doped with acetic acid. In contrast, the selectivity in the formation of the conducting phase is higher in oxalic acid as a protonic acid media. The FTIR spectra of these polymers reveal a higher ratio of the relative intensities of the quinoid to benzenoid ring modes in acetic acid doped polyaniline. Scanning electron micrographs revealed a sponge-like structure derived from the aggregation of the small granules in acetic acid and oxalic acid doped polyaniline. A three-step decomposition pattern is observed in all the polymers, regardless of the protonic acid used for the doping. The second step loss related to the loss of dopant is found to be higher in the oxalic acid doped polymer. In accordance with these results the conductivity is also found to be higher in oxalic acid doped material. The temperature dependent conductivity measurements show the thermal activated behavior in all the polymers. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 2043–2049, 2004

Synthesis and characterization of polyaniline doped with organic acids

A conducting polymer, polyaniline, was synthesized by chemical polymerization using different inorganic acids, such as HCl, H2SO4, HClO4, HNO3, and H3PO4, as protonic acid media. The synthesized polymers were characterized using UV-visible and FT-IR spectroscopy. A granular type of morphology was observed under SEM for HCl, HNO3, and H3PO4 doped polyanilines. However, HClO4 doped polyaniline shows the folded lamellar structure derived from the fibers. The thermal stability of these polymers was investigated with the help of thermogravimetric (TG/SDTA) analysis. The formation of a greater fraction of the conducting emeraldine salt phase is observed in HClO4 as a protonic acid media. The thermal stability of H3PO4 doped material is found to be better as compared with other acids. An increase in conductivity with an increase in temperature was observed in all the samples except for HClO4 doped polyaniline. Polym. Eng. Sci. 44:1676–1681, 2004. © 2004 Society of Plastics Engineers.

Spectroscopic, transport, and morphological studies of polyaniline doped with inorganic acids

Conducting polymer, Poly(o-toluidine) was synthesized by chemical oxidative polymerization method using different inorganic acids such as HCl, H2SO4, HClO4, HNO3, H3PO4 and H3BO3 as protonic acid media. Synthesized polymers were characterized by UV-Visible and FT-IR spectroscopy. Conducting emeraldine salt phase of the polymer has been confirmed with the help of spectroscopic analysis. Thermal stability of these polymers were investigated by thermogravimetric (TG/SDTA) analysis. Increase in conductivity with increase in temperature was observed in all the samples.

Investigation of effect of protonic acid media on the optical and thermal properties of chemically synthesized poly(o-toluidine)

Novel solar light driven photocatalyst, zinc indium vanadate for photodegradation of aqueous phenol

Hydrogen is a future fuel and hence production of cheap hydrogen is an important area of research. Recently, the photocatalysts were used to generate hydrogen from water and hydrogen sulfide splitting under solar light. Hence, we designed Zinc Indium Vanadate, a novel visible light active photocatalyst and used for the generation of hydrogen by using solar light. We have demonstrated the synthesis of ZnIn2V2O9 (ZIV) catalyst by sonochemical route using NH4VO3, In (NO3)3 and Zn(CH3COO)2 as a precursors and PVP as a capping agent. The obtained product was further characterized by XRD, UV-DRS and FESEM. The XRD pattern reveals the existence of monoclinic crystal structure and broader peaks indicating the nanocrystalline nature of the material. The particle size was observed in the range of 50-70 nm. The optical study showed the absorption edge cut off at 520 nm with estimated band gap about 2.3 eV. Considering the band gap in visible range, ZnIn2V2O9 was used as a photocatalyst for photodecomposition of H2S under visible light irradiation to produce hydrogen. We observed excellent photocatalytic activity for the hydrogen generation by using this photocatalyst.

R. Marimuthu

Papers

Synthesis and characterization of polyaniline doped with organic acids

Spectroscopic, transport, and morphological studies of polyaniline doped with inorganic acids

Investigation of effect of protonic acid media on the optical and thermal properties of chemically synthesized poly(o-toluidine)

Novel solar light driven photocatalyst, zinc indium vanadate for photodegradation of aqueous phenol

Nanocrystalline zinc indium vanadate: a novel photocatalyst for hydrogen generation.