V
Vakil Singh
Researcher at Banaras Hindu University
Publications - 96
Citations - 1731
Vakil Singh is an academic researcher from Banaras Hindu University. The author has contributed to research in topics: Alloy & Titanium alloy. The author has an hindex of 23, co-authored 91 publications receiving 1525 citations.
Papers
More filters
Journal ArticleDOI
Evolution of aluminide coating microstructure on nickel-base cast superalloy CM-247 in a single-step high-activity aluminizing process
TL;DR: In this article, the microstructural details of the Ni-base superalloy formed at various stages of aluminizing were analyzed and it was concluded that the coating growth in the above process takes place primarily by inward Al diffusion initially, followed by an intermediate stage when the growth involves both inward Al and outward Ni diffusion.
Journal ArticleDOI
N-(Piperidinomethyl)-3-[(pyridylidene)amino]isatin: A new and effective acid corrosion inhibitor for mild steel
Mumtaz Ahmad Quraishi,Ishtiaque Ahamad,Ashish Kumar Singh,Sudhish Kumar Shukla,B. Lal,Vakil Singh +5 more
TL;DR: In this article, a new corrosion inhibitor named N-(piperidinomethyl)-3-[(pyridylidene)amino]isatin (PPI) has been synthesized and its influence on corrosion inhibition of mild steel in 1N hydrochloric acid solution has been studied by weight loss and potentiodynamic polarisation techniques.
Journal ArticleDOI
Low cycle fatigue behavior of Ti alloy IMI 834 at room temperature
Nidhi Singh,Gouthama,Vakil Singh +2 more
TL;DR: In this article, low cycle fatigue behavior of the Ti alloy IMI 834 was studied, for a bimodal microstructure with ≈14 vol.% primary α (α p ) in the matrix of transformed β, at different total strain amplitudes (Δ e t /2) from ± 0.75 to ± 1.7%, at room temperature.
Journal ArticleDOI
Mechanical processing and microstructural control in hot working of hot isostatically pressed P/M IN-100 superalloy
TL;DR: In this paper, the hot deformation behavior of hot isostatically pressed (HIPd) P/M IN-100 superalloy has been studied in the temperature range 1000-1200 degrees C and strain rate range 0.0003-10 s(-1) using hot compression testing.
Journal ArticleDOI
Thermomechanical fatigue evaluation and life prediction of 316L(N) stainless steel
A. Nagesha,M. Valsan,R. Kannan,K. Bhanu Sankara Rao,V. Bauer,Hans-Juergen Christ,Vakil Singh +6 more
TL;DR: In this paper, a nitrogen-alloyed type 316L stainless steel was subjected to in-phase and out-of-phase thermal-mechanical cycling in air under a mechanical strain control mode, at a strain rate of 6.4 × 10−5−s−1 and a strain amplitude of ± 0.4%.