scispace - formally typeset
Y

Yorikata Mizokami

Researcher at Mitsubishi Heavy Industries

Publications -  22
Citations -  135

Yorikata Mizokami is an academic researcher from Mitsubishi Heavy Industries. The author has contributed to research in topics: Creep & Casing. The author has an hindex of 4, co-authored 22 publications receiving 128 citations.

Papers
More filters
Journal ArticleDOI

Cost and performance design approach for GTHTR300 power conversion system

TL;DR: In this article, a gas turbine high temperature reactor of 300 MWe nominal capacity (GTHTR300) power plant, aiming at prototype demonstration in Japan during 2010s, is described.
Journal ArticleDOI

Development of structural design procedure of plate-fin heat exchanger for HTGR

TL;DR: In this article, the failure mode and failure limit of brazed side-bar structures were experimentally clarified and allowable stresses for aging materials and brazing structures were newly determined on the basis of the experimental results.
Journal ArticleDOI

Prediction of Macroscopic and Local Stress-Strain Behavior of Perforated Plates under Primary and Secondary Creep Conditions

TL;DR: In this article, a modified Neuber's rule is used for predicting local stress and strain concentrations of perforated heat exchanger, and the propriety of this prediction method is shown through a comparison of the prediction with both the numerical results by FEM for the unit section under creep, and experimental results by the Moire method.
Journal ArticleDOI

The role of Japan's industry in the HTTR design and its construction

TL;DR: In this article, the authors summarized the roles of each industrial organization in the HTTR design and construction, and the installation was completed in November 1996, and was then handed over to JAERI in September 1997.