scispace - formally typeset
Open AccessJournal ArticleDOI

Harmonic Distortion Evaluation Generated by PWM Motor Drives in Electrical Industrial Systems

Reads0
Chats0
TLDR
In this paper, a comparative study between two industrial circuits connected at the same point of common coupling (PCC) with similar characteristics of load and transformers is presented, where one circuit has PWM motor drives and the other does not have them.
Abstract
This paper evaluates the harmonic distortion generated by PWM motor drives in an electrical industrial system of a wheat flour mill company. For this, a comparative study between two industrial circuits connected at the same point of common coupling (PCC) with similar characteristics of load and transformers is presented. The difference is that one circuit has PWM motor drives and the other does not have them. In the study, a practical method based on the statistical characterization of the total harmonic distortion of voltage (THDV) and current (THDI), individual voltage distortion (IVD), individual current distortion (ICD) and K-Factor is applied. As result, it was observed that PWM motor drives generated voltage harmonics mainly of fifth and seventh order with values that exceed limits established by standards in both circuits. With these values, the operation of elements such as capacitors, motors and transformers can be affected. In the work is also demonstrated that in the analysis of harmonics is necessary to consider various parameters and not only one.

read more

Content maybe subject to copyright    Report

Citations
More filters
Journal ArticleDOI

Assessment of the energy efficiency estimation methods on induction motors considering real-time monitoring

TL;DR: The feasibility of these methods for efficiency estimation in real-time were theoretically and experimentally assessed during the operation under different operational conditions and show that for load factors over 80%, the air-gap method is applicable under any condition, while the slip method is only applicable under BSV or balanced harmonic voltage.
Journal ArticleDOI

Voltage collapse point evaluation considering the load dependence in a power system stability problem

TL;DR: In this article, the authors evaluated the influence of load dependence on the voltage on the phenomenon of voltage stability and especially on the characteristics of voltage collapse point or instability point, and compared the results with those described in the bibliography and those obtained with commercial software.
Journal ArticleDOI

Effects of power electronics devices on the energy quality of an administrative building

TL;DR: The analysis of the effects of power electronics devices on the energy quality of an administrative building showed the presence of current harmonics and flicker problems due to non-linear loads such as the frequency inverters that drive the motors of the elevators and escalators, as well as the LED lamps.
Journal ArticleDOI

Energy planning and management during battery manufacturing

TL;DR: In this article, the main energy consumptions were identified in the battery formation, the compressed air system and the large electric motors, and different actions were proposed to improve energy performance.
Journal ArticleDOI

Effects of turbulization on the disc pump performance

TL;DR: In this paper, a new experimental study based on the turbulization of flow by the placement of turbulizers in the interdisc channel output is presented, where the variables involved are the angular velocity (ω) and the cross-section shape of the turbULizers.
References
More filters
Proceedings ArticleDOI

Induction motor thermal aging caused by voltage distortion and imbalance: loss of useful life and its estimated cost

TL;DR: In this article, the effect of voltage distortion and imbalance (VDI) on the thermal aging of low voltage induction motors was investigated. But the study was based on a detailed thermal modeling of actual motors in the 2 to 200 HP range.
Journal ArticleDOI

Time-varying harmonics. I. Characterizing measured data

TL;DR: This paper represents Part I of a two-part article which summarizes the probabilistic aspects of harmonics in electric distribution systems and various ways to describe recorded data in statistical terms.
Journal ArticleDOI

Transformer design and application considerations for nonsinusoidal load currents

L.W. Pierce
TL;DR: In this article, the Underwriters Laboratories Inc. (UL) K-factor rated dry type transformer and the recommended practices given in ANSI/IEEE C57.110 are reviewed.
Proceedings ArticleDOI

Estimation methods for power system harmonic effects on power distribution transformers

G. W. Massey
TL;DR: In this article, the authors introduce a conservative method of estimating the composite harmonic current generated by the operation of multiple linear and non-linear loads connected to a single power distribution transformer.
Journal ArticleDOI

Impact of Harmonics on Power Quality and Losses in Power Distribution Systems

TL;DR: The model follows a “bottom-up” approach, starting from end users appliances Norton equivalent model and then modeling residential, commercial and office loads, and shows that harmonic distortion in distribution systems can increase power losses up to 20%.
Related Papers (5)
Trending Questions (1)
Do all furnace blower motors have capacitors?

With these values, the operation of elements such as capacitors, motors and transformers can be affected.