scispace - formally typeset
Journal ArticleDOI

Pressure solution and Coble creep in rocks and minerals: a review

K. R. McCLAY
- 01 Oct 1977 - 
- Vol. 134, Iss: 1, pp 57-70
TLDR
A brief review of the literature on pressure solution is given in this article, where the mechanisms of pressure solution and Coble creep are discussed and the thermodynamics of non-hydrostatically stressed solids are discussed.
Abstract
A brief review of research on pressure solution is given. The mechanisms of pressure solution and Coble creep are discussed. Deformation by diffusive mass transfer processes is generally accompanied by grain boundary sliding and this will have important effects on the textures and microstructures produced during deformation. Experiments using relaxation testing seem promising in allowing access to the slow strain rates necessary to observe pressure solution phenomena. The thermodynamics of non-hydrostatically stressed solids is discussed and an analysis of possible diffusion paths in rocks is presented. Evaluation of theoretical rate equations for pressure solution and Coble creep indicates that pressure solution in fine-grained quartz and calcite rocks may give rise to geological strain rates at temperatures from 200–350°C. Coble creep is expected to give rise to geological strain rates in fine-grained galena at low temperatures and also in fine-grained calcite rocks at temperatures around 350°C. The chemistry of natural rock pressure solution systems is expected to have significant effects and needs further detailed study. Further research is needed to elucidate the nature and role of grain boundaries during diffusive mass transfer. Pressure solution phenomena are important in the compaction behaviour of some petroleum reservoir rocks and perhaps in some faults where sliding is accommodated by pressure solution.

read more

Citations
More filters
Journal ArticleDOI

Fault zone models, heat flow, and the depth distribution of earthquakes in the continental crust of the United States

TL;DR: In this article, the authors show that the maximum depth of microseismic activity in various heat flow provinces of the conterminous United States generally correlates well with the frictional to quasi-plastic transition modeled for the different geotherms.
Journal ArticleDOI

Pressure solution in nature, theory and experiment

TL;DR: In this paper, the authors derived constitutive flow laws for creep by diffusive mass transfer and showed that the diffusion of matter in an aqueous intergranular film which can support shear stress is an essential part of the process and the diffusion is driven by stress induced chemical potential gradients.
Journal ArticleDOI

Continental fault structure and the shallow earthquake source

TL;DR: A simple 2-level model for these important structures accounts for the depth distribution of most continental earthquakes, and for the observed range of faulting styles and associated rock deformation textures as mentioned in this paper.
Journal ArticleDOI

Crustal stress, faulting and fluid flow

TL;DR: In the vicinity of active faults that undergo intermittent rupturing, permeability and fluid flux may be tied to the earthquake cycle through a range of mechanisms, leading to complex interactions between stress cycling, the creation and destruction of permeability, and fluid flow as discussed by the authors.
Book

A Practical Guide to Rock Microstructure

TL;DR: In this article, a glossary of microstructural terms for sedimentary and metamorphic rocks is presented, along with a discussion of the relationship between sedimentary, igneous and deformed rocks.
References
More filters
Journal ArticleDOI

Diffusional Viscosity of a Polycrystalline Solid

TL;DR: In this article, it is suggested that mosaic boundaries and boundaries between grains of nearly the same orientation may not serve as sources or sinks of the diffusion currents, in which case the creep rate will depend only on the configuration of grain boundaries having a sizable orientation differen...
Journal ArticleDOI

A Model for Boundary Diffusion Controlled Creep in Polycrystalline Materials

TL;DR: In this article, the authors discussed the mechanism of creep in polycrystalline alumina based on the differences between the lattice and boundary diffusion models and showed that the boundary diffusion model is more stable than lattice diffusion model, while the grain size dependence and the numerical constant are greater.
Journal ArticleDOI

On the Equilibrium of Heterogeneous Substances

TL;DR: The article ''On the Equilibrium of Heterogeneous Substances'', which was published in ''Transactions of the Connecticut Academy of Arts and Sciences'', vol. 3 (1874-78), pp. 108-248 and 343-524 as mentioned in this paper
Related Papers (5)