A. K. Chaubey

TL;DR: In this article, the effect of annealing on microstructure and related tensile properties is examined and the results demonstrate that the mechanical behavior of the Al-12Si SLM samples can be tuned within a wide range of strength and ductility through proper annesaling treatment.

TL;DR: In this article, the authors investigated the wear properties of commercially pure titanium (CP-Ti) parts produced using selective laser melting (SLM) and casting, and they found that SLM-produced CP-Ti parts have martensitic (α΄) microstructure, whereas cast-produced PC-Ti samples exhibit plate-like (α)-microstructure.

TL;DR: The influence of annealing at different temperatures (573, 873, 1273, 1373 and 1673 K) on the stability of 316L stainless steel fabricated by SLM has been investigated and the changes induced by the heat treatment have been used to understand the corresponding variations of the mechanical properties of the specimens under tensile loading as mentioned in this paper.

TL;DR: In this article, the microstructural characteristic of the alloys with Nb addition and its effect on their mechanical properties as well as wear resistance were investigated. And the authors proposed that increasing the Nb content enhances β phase stability and its proportion in the microstructure of the designed alloys.

TL;DR: In this article, selective laser melting (SLM) was used to produce the Al6MoTi intermetallic phase due to the reaction of the reinforcement with the Al-12Si matrix during SLM.