Laboratory measurements of iron opacity made under conditions similar to those inside the Sun reveal much higher opacity than predicted, helping to resolve inconsistencies within stellar models of the internal temperatures of stars. Internal temperature profiles of the Sun and other stars are controlled in large part by the rate at which radiation is absorbed by stellar matter. Until now it has not been possible to determine the opacity of matter in star-like conditions in the laboratory, but James Bailey et al. have now achieved that feat using the Sandia National Laboratories' Z facility, the world's most powerful X-ray generator. The experiments reveal a wavelength-resolved iron opacity that is 30 to 400 times greater than predicted in conditions very similar to those at the radiation/convection zone boundary in the Sun. Previous measurements of stellar interiors have been based on observations of surface waves, and there were serious discrepancies between theoretical predictions and observations. The new measurements account for about half of adjustment in opacity figures required to restore agreement between standard solar models and observations. Nearly a century ago it was recognized1 that radiation absorption by stellar matter controls the internal temperature profiles within stars. Laboratory opacity measurements, however, have never been performed at stellar interior conditions, introducing uncertainties in stellar models2,3,4,5. A particular problem arose2,3,6,7,8 when refined photosphere spectral analysis9,10 led to reductions of 30–50 per cent in the inferred amounts of carbon, nitrogen and oxygen in the Sun. Standard solar models11 using the revised element abundances disagree with helioseismic observations that determine the internal solar structure using acoustic oscillations. This could be resolved if the true mean opacity for the solar interior matter were roughly 15 per cent higher than predicted2,3,6,7,8, because increased opacity compensates for the decreased element abundances. Iron accounts for a quarter of the total opacity2,12 at the solar radiation/convection zone boundary. Here we report measurements of wavelength-resolved iron opacity at electron temperatures of 1.9–2.3 million kelvin and electron densities of (0.7–4.0) × 1022 per cubic centimetre, conditions very similar to those in the solar region that affects the discrepancy the most: the radiation/convection zone boundary. The measured wavelength-dependent opacity is 30–400 per cent higher than predicted. This represents roughly half the change in the mean opacity needed to resolve the solar discrepancy, even though iron is only one of many elements that contribute to opacity.

/pdf/a-higher-than-predicted-measurement-of-iron-opacity-at-solar-4vx7wp39j8.pdf

A higher-than-predicted measurement of iron opacity at solar interior temperatures.

The luminous infrared-loud quasar IRAS 13349+2438 was observed with the XMM - Newton Observatory as part of the Performance Verification program. The spectrum obtained by the Reflection Grating Spectrometer (RGS) exhibits broad (FWHM - 1400 km/s) absorption lines from highly ionized elements including hydrogen- and helium-like carbon, nitrogen, oxygen, and neon, and several iron L - shell ions (Fe XVII - XX). Also shown in the spectrum is the first astrophysical detection of a broad absorption feature around lambda = 16 - 17 A identified as an unresolved transition array (UTA) of 2p - 3d inner-shell absorption by iron M-shell ions in a much cooler medium; a feature that might be misidentified as an O VII edge when observed with moderate resolution spectrometers. No absorption edges are clearly detected in the spectrum. We demonstrate that the RGS spectrum of IRAS 13349+2438 exhibits absorption lines from two distinct regions, one of which is tentatively associated with the medium that produces the optical/UV reddening.

/pdf/complex-resonance-absorption-structure-in-the-x-ray-spectrum-54jeavk8r0.pdf

Complex resonance absorption structure in the X-ray spectrum of IRAS 13349+2438

Astrophysics traditionally has been the domain of large astronomical observatories and theorists' computers, the former producing images from deep space, and the latter constructing intricate models to explain the observations. A component often missing has been the ability to quantitatively test the theories and models in an experimental setting where the initial and final states are well characterized. In a new development, intense lasers are being used to recreate aspects of astrophysical phenomena in the laboratory, allowing the creation of experimental testbeds where theory and modeling can be quantitatively compared with data. We summarize here several areas of astrophysics: supernovae, supernova remnants, gamma-ray bursts, and giant planets. In each of these areas, experiments are under development at intense laser facilities to test and refine our understanding of these phenomena.

/pdf/a-review-of-astrophysics-experiments-on-intense-lasers-25xf1k9njy.pdf

A review of astrophysics experiments on intense lasers

Advances in NLTE modeling for integrated simulations

High-harmonic generation is a universal response of matter to strong femtosecond laser fields, coherently upconverting light to much shorter wavelengths. Optimizing the conversion of laser light into soft x-rays typically demands a trade-off between two competing factors. Because of reduced quantum diffusion of the radiating electron wave function, the emission from each species is highest when a short-wavelength ultraviolet driving laser is used. However, phase matching--the constructive addition of x-ray waves from a large number of atoms--favors longer-wavelength mid-infrared lasers. We identified a regime of high-harmonic generation driven by 40-cycle ultraviolet lasers in waveguides that can generate bright beams in the soft x-ray region of the spectrum, up to photon energies of 280 electron volts. Surprisingly, the high ultraviolet refractive indices of both neutral atoms and ions enabled effective phase matching, even in a multiply ionized plasma. We observed harmonics with very narrow linewidths, while calculations show that the x-rays emerge as nearly time-bandwidth-limited pulse trains of ~100 attoseconds.

/pdf/ultraviolet-surprise-efficient-soft-x-ray-high-harmonic-36wwmlpmx5.pdf

Ultraviolet surprise: Efficient soft x-ray high-harmonic generation in multiply ionized plasmas

Hybrid atomic models for spectroscopic plasma diagnostics

Absorption of the 2p-3d transitions of iron has been measured using point projection spectroscopy. Thin C tamped Fe foils were heated around 20 eV by X-rays generated in gold spherical hohlraums irradiated by the high-power laser ASTERIX IV. Absorption of Fe V to Fe X has been observed in the spectral vicinity of 730 eV (17 A). The Ag backlighter source and absorbed spectra were recorded on the same shot by a TlAP crystal spectrograph. The experimental spectra have been reproduced by the two superconfiguration local thermodynamic equilibrium codes SCO and STA. Detailed statistical calculations of the different ionic structures have also been performed with the Spin Orbit Split Arrays method, allowing the determination of ion populations. The electron temperature and average ionization obtained by fitting the experiment with the different calculations were compared with radiative hydrodynamic simulations.

http://iopscience.iop.org/article/10.1086/313354/pdf

Opacity Studies of Iron in the 15-30eV Temperature Range

Atomic Properties in Hot Plasmas

Superconfiguration widths and their effects on atomic models

The impact of the third (skewness) and fourth (kurtosis) reduced centered moments on the statistical modeling of E1 lines in complex atomic spectra is investigated through the use of Gram-Charlier, Normal Inverse Gaussian and Generalized Gaussian distributions. It is shown that the modeling of unresolved transition arrays with non-Gaussian distributions may reveal more detailed structures, due essentially to the large value of the kurtosis. In the present work, focus is put essentially on the Generalized Gaussian, the power of the argument in the exponential being constrained by the kurtosis value. The relevance of the new statistical line distribution is checked by comparisons with smoothed detailed line-by-line calculations and through the analysis of 2p-3d transitions of recent laser or Z-pinch absorption measurements. The issue of calculating high-order moments is also discussed (Racah algebra, Jucys graphical method, semi-empirical approach ...).

Claire Bauche-Arnoult

Papers

Hybrid atomic models for spectroscopic plasma diagnostics

Opacity Studies of Iron in the 15-30eV Temperature Range

Atomic Properties in Hot Plasmas

Superconfiguration widths and their effects on atomic models

Effect of third- and fourth-order moments on the modeling of Unresolved Transition Arrays