A truly modular and power-scalable architecture for low-power programmable frequency dividers is presented. The architecture was used in the realization of a family of low-power fully programmable divider circuits, which consists of a 17-bit UHF divider, an 18-bit L-band divider, and a 12-bit reference divider. Key circuits of the architecture are 2/3 divider cells, which share the same logic and the same circuit implementation. The current consumption of each cell can be determined with a simple power optimization procedure. The implementation of the 2/3 divider cells is presented, the power optimization procedure is described, and the input amplifiers are briefly discussed. The circuits were processed in a standard 0.35 /spl mu/m bulk CMOS technology, and work with a nominal supply voltage of 2.2 V. The power efficiency of the UHF divider is 0.77 GHz/mW, and of the L-band divider, 0.57 GHz/mW. The measured input sensitivity is >10 mV rms for the UHF divider, and >20 mV rms for the L-band divider.

A family of low-power truly modular programmable dividers in standard 0.35-/spl mu/m CMOS technology

A fully-integrated FMCW radar system for automotive applications operating at 77 GHz has been proposed. Utilizing a fractional- synthesizer as the FMCW generator, the transmitter linearly modulates the carrier frequency across a range of 700 MHz. The receiver together with an external baseband processor detects the distance and relative speed by conducting an FFT-based algorithm. Millimeter-wave PA and LNA are incorporated on chip, providing sufficient gain, bandwidth, and sensitivity. Fabricated in 65-nm CMOS technology, this prototype provides a maximum detectable distance of 106 meters for a mid-size car while consuming 243 mW from a 1.2-V supply.

A Fully-Integrated 77-GHz FMCW Radar Transceiver in 65-nm CMOS Technology

A phase noise cancellation technique and a charge pump linearization technique, both of which are insensitive to component errors, are presented and demonstrated as enabling components in a wideband CMOS delta-sigma fractional-N phase-locked loop (PLL). The PLL has a loop bandwidth of 460 kHz and is capable of 1-Mb/s in- loop FSK modulation at center frequencies of 2402 + k MHz for k = 0, 1, 2, ..., 78. For each frequency, measured results indicate that the peak spot phase noise reduction achieved by the phase noise cancellation technique is 16 dB or better, and the minimum suppression of fractional spurious tones achieved by the charge pump linearization technique is 8 dB or better. With both techniques enabled, the PLL achieves a worst-case phase noise of -121 dBc/Hz at 3-MHz offsets, and a worst-case in-band noise floor of -96 dBc/Hz. The PLL circuitry consumes 34.4 mA from 1.8-2.2-V supplies. The IC is realized in a 0.18-/spl mu/m mixed-signal CMOS process, and has a die size of 2.72 mm /spl times/ 2.47 mm.

/pdf/a-wideband-2-4-ghz-delta-sigma-fractional-npll-with-1-mb-s-1qda1jn31a.pdf

A wideband 2.4-GHz delta-sigma fractional-NPLL with 1-Mb/s in-loop modulation

A fast-settling adaptive calibration technique is presented that makes phase noise cancelling DeltaSigma fractional-N PLLs practical for the low reference frequencies commonly used in wireless communication systems. The technique is demonstrated as an enabling component of a 2.4 GHz ISM band CMOS PLL IC with a 730 kHz bandwidth, a 12 MHz reference, and an on-chip loop filter. In addition to the adaptive calibration technique, the IC incorporates a dynamic charge pump biasing technique to reduce power dissipation. The worst-case phase noise of the IC is -101 dBc/Hz and -124 dBc/Hz at 100 kHz and 3 MHz offsets, respectively, and the adaptive phase noise cancellation technique has a worst-case settling time of 35 mus . The IC is implemented in 0.18 CMOS technology. It measures 2.2 x 22 mm2 and its core circuitry consumes 20.9 mA from a 1.8 V supply.

A Wide-Bandwidth 2.4 GHz ISM Band Fractional- $N$ PLL With Adaptive Phase Noise Cancellation

An adaptive phase-locked loop (PLL) architecture for high-performance tuning systems is described. The architecture combines contradictory requirements posed by different performance aspects. Adaptation of loop parameters occurs continuously, without switching of loop filter components, and without interaction from outside of the tuning system. The relationship of performance aspects (settling time, phase noise, and spurious signals) to design variables (loop bandwidth, phase margin, and loop filter attenuation at the reference frequency) are presented, and the basic tradeoffs of the new concept are discussed. A circuit implementation of the adaptive PLL, optimized for use in a multiband (global) car-radio tuner IC, is described in detail. The realized tuning system achieved state-of-the-art settling time and spectral purity performance in its class (integer-N PLLs): a signal-to-noise ratio of 65 dB, a 100-kHz spurious reference breakthrough signal under -81 dBc, and a residual settling error of 3 kHz after 1 ms, for a 20-MHz frequency step. It simultaneously fulfills the speed requirements for inaudible frequency hopping and the heavy signal-to-noise ratio specification of 64 dB.

An adaptive PLL tuning system architecture combining high spectral purity and fast settling time

The building blocks for a low-power tuning system that reduces the phase noise of integrated VCO's are described. The multimodulus prescaler, the phase frequency detector, and the wide-band charge pump have been integrated in a standard bipolar technology with 9-GHz n-p-n transistors and 200-MHz p-n-p transistors. The maximum input frequency of the multimodulus prescaler is 3.2 GHz, the maximum reference frequency of the phase frequency detector is 380 MHz, and the 3-dB bandwidth of the charge pump is 41 MHz at a reference frequency of 300 MHz. The achieved performance enables the use of fully integrated VCO's with relatively high phase noise for reception of satellite digital signals.

A wide-band tuning system for fully integrated satellite receivers

The building blocks for a low power tuning system that reduces the phase noise of integrated VCO's are described. The multi-modulus prescaler, the phase frequency detector and the wide band charge pump were integrated in a standard bipolar technology with 9 GHz npn-transistors and 200 MHz pnp-transistors. The maximum input frequency of the multi-modulus prescaler is 3 GHz, the maximum reference frequency of the phase frequency detector is 380 MHz and the -3 dB bandwidth of the charge pump is 41 MHz at a reference frequency of 300 MHz. The achieved performance enables use of noisy integrated VCO's for reception of satellite digital signals.

http://ieeexplore.ieee.org/iel5/9916/31525/01470862.pdf

D. Kasperkovitz

Papers

A wide-band tuning system for fully integrated satellite receivers

A wide band tuning system for fully integrated satellite receivers