Showing papers by "David E. Cliffel published in 2004"

Synthesis and Catalytic Properties of Soluble Platinum Nanoparticles Protected by a Thiol Monolayer

Abstract: Several new platinum monolayer protected clusters (MPCs) have been synthesized and characterized. Two methods of platinum reduction were used depending on the solubility of the thiol: sodium borohydride for the water-soluble thiols and lithium triethylborohydride for the organic soluble thiols. In general, reactant solutions containing a 1:1 thiol/Pt ratio yielded the best particles in a single-phase reaction. Higher thiol/Pt ratios produced lower yields of MPCs, while much lower ratios produced gray-black precipitates. The Pt MPCs were used as catalysts to hydrogenate allyl alcohol to propanol by reducing the carbon−carbon double bond. The Pt−mercaptoammonium MPCs were also used as catalysts in the hydrogenation of maleic acid to succinic acid. Differences in the catalytic hydrogenation rates among the various monolayer coatings for MPCs are attributed to the variations in ligand chain length, branching, charged functional groups, packing density, and core size.

NanoLiterBioReactor: long-term mammalian cell culture at nanofabricated scale.

Abstract: There is a need for microminiaturized cell-culture environments, i.e. NanoLiter BioReactors (NBRs), for growing and maintaining populations of up to several hundred cultured mammalian cells in volumes three orders of magnitude smaller than those contained in standard multi-well screening plates. These devices would enable the development of a new class of miniature, automated cell-based bioanalysis arrays for monitoring the immediate environment of multiple cell lines and assessing the effects of drug or toxin exposure. We fabricated NBR prototypes, each of which incorporates a culture chamber, inlet and outlet ports, and connecting microfluidic conduits. The fluidic components were molded in polydimethylsiloxane (PDMS) using soft-lithography techniques, and sealed via plasma activation against a glass slide, which served as the primary culture substrate in the NBR. The input and outlet ports were punched into the PDMS block, and enabled the supply and withdrawal of culture medium into/from the culture chamber (10-100 nL volume), as well as cell seeding. Because of the intrinsically high oxygen permeability of the PDMS material, no additional CO(2)/air supply was necessary. The developmental process for the NBR typically employed several iterations of the following steps: Conceptual design, mask generation, photolithography, soft lithography, and proof-of-concept culture assay. We have arrived at several intermediate designs. One is termed "circular NBR with a central post (CP-NBR)," another, "perfusion (grid) NBR (PG-NBR)," and a third version, "multitrap (cage) NBR (MT-NBR)," the last two providing total cell retention. Three cells lines were tested in detail: a fibroblast cell line, CHO cells, and hepatocytes. Prior to the culturing trials, extensive biocompatibility tests were performed on all materials to be employed in the NBR design. To delineate the effect of cell seeding density on cell viability and survival, we conducted separate plating experiments using standard culture protocols in well-plate dishes. In both experiments, PicoGreen assays were used to evaluate the extent of cell growth achieved in 1-5 days following the seeding. Low seeding densities resulted in the absence of cell proliferation for some cell lines because of the deficiency of cell-cell and extracellular matrix (ECM)-cell contacts. High viabilities were achieved in all designs. We conclude that an instrumented microfluidics-based NanoBioReactor (NBR) will represent a dramatic departure from the standard culture environment. The employment of NBRs for mammalian cell culture opens a new paradigm of cell biology, so far largely neglected in the literature.

A Microphysiometer for Simultaneous Measurement of Changes in Extracellular Glucose, Lactate, Oxygen, and Acidification Rate

Abstract: A microphysiometer capable of measuring changes in extracellular glucose, lactate, oxygen, and acidification rate has been developed by incorporating modified electrodes into a standard Cytosensor Microphysiometer plunger. Glucose and lactate are measured indirectly at platinum electrodes by amperometric oxidation of hydrogen peroxide, which is produced from catalysis of glucose and lactate at films containing their respective entrapped oxidase. Oxygen is measured amperometrically at a platinum electrode coated with a Nafion film, while the acidification rate is measured potentiometrically by a Cytosensor Microphysiometer. Analytical information is obtained during the Cytosensor stop-flow cycles, where the electrodes measure changes in the extracellular medium corresponding to the consumption or production of the analyte by the cells. Modification of the Cytosensor plunger for multianalyte determination is described, and the operation of the technique is illustrated by the simultaneous measurement of all four analytes during the addition of fluoride and DNP to Chinese hamster ovary cells and fluoride and antimycin A to mouse fibroblast cells. Cell metabolic recovery and dynamics after exposure to agents can also be observed in specific cases.

Effect of surface composition on the adsorption of photosystem I onto alkanethiolate self-assembled monolayers on gold.

Abstract: We have used self-assembled monolayers (SAMs) prepared from ω-terminated alkanethiols on gold to generate model surfaces and examine the effect of surface composition on the adsorption of Photosyst...

NanoLiterBioReactor: Monitoring of Long-Term Mammalian Cell Physiology at Nanofabricated Scale

Abstract: There is a need for microminiaturized cell-culture environments, i.e., NanoLiter BioReactors (NBRs), for growing and maintaining populations of up to several hundred cultured mammalian cells in volumes three orders of magnitude smaller than those contained in standard multi-well screening plates. Reduced NBR volumes would not only shorten the time required for diffusive mixing, for achieving thermal equilibrium, and for cells to grow to confluence, but also simplify accurate cell counting, minimize required volumes of expensive analytical pharmaceuticals or toxins, and allow for thousands of culture chambers on a single instrumented chip. These devices would enable the development of a new class of miniature, automated cell-based bioanalysis arrays for monitoring the immediate environment of multiple cell lines and assessing the effects of drug or toxin exposure. The challenge, beyond that of optimizing the NBR physically, is to detect cellular response, provide appropriate control signals, and, eventually, facilitate closed-loop adjustments of the environment—e.g., to control temperature, pH, ionic concentration, etc., to maintain homeostasis, or to apply drugs or toxins followed by the adaptive administration of a selective toxin antidote. To characterize in a nonspecific manner the metabolic activity of cells, the biosensor elements of the NBR might include planar pH, dissolved oxygen, and redox potential sensors, or even an isothermal picocalorimeter (pC) to monitor thermodynamic response. Equipped with such sensors, the NBR could be used to perform short- and long-term cultivation of several mammalian cell lines in a perfused system, and to monitor their response to analytes in a massively parallel format. This approach will enable automated, parallel, and multiphasic monitoring of multiple cell lines for drug and toxicology screening. An added bonus is the possibility of studying cell populations with low cell counts whose constituents are completely detached from typical tissue environment, or populations in controlled physical and chemical gradients.