This paper reviews the recent progress of quantum-dot semiconductor optical amplifiers developed as ultrawideband polarization-insensitive high-power amplifiers, high-speed signal regenerators, and wideband wavelength converters. A semiconductor optical amplifier having a gain of > 25 dB, noise figure of < 5 dB, and 3-dB saturation output power of > 20 dBm, over the record widest bandwidth of 90 nm among all kinds of optical amplifiers, and also having a penalty-free output power of 23 dBm, the record highest among all the semiconductor optical amplifiers, was realized by using quantum dots. By utilizing isotropically shaped quantum dots, the TM gain, which is absent in the standard Stranski-Krastanow QDs, has been drastically enhanced, and nearly polarization-insensitive SOAs have been realized for the first time. With an ultrafast gain response unique to quantum dots, an optical regenerator having receiver-sensitivity improving capability of 4 dB at a BER of 10-9 and operating speed of > 40 Gb/s has been successfully realized with an SOA chip. This performance achieved together with simplicity of structure suggests a potential for low-cost realization of regenerative transmission systems.

Quantum-Dot Semiconductor Optical Amplifiers

With a new generation of quantum dot (QD) optical gain material comprising atom-like features, the fundamental spectral characteristics of laser emission have been improved significantly. We describe the spectral and power characteristics of continuous wave (CW) single-mode InAs/AlGaInAs/InP QD distributed feedback lasers operating at 1.5 μm. Linewidths as narrow as 60 kHz (30  kHz±10  kHz intrinsic linewidth) at 20°C, which broadens to only 280 kHz (80  kHz±10  kHz intrinsic linewidth) at 80°C, have been achieved. The laser exhibits high output powers of 58 mW at 20°C and 26 mW at 80°C with side mode suppression ratios exceeding 50 dB. These record values stem from high uniformity of the QDs and a large dot density. The linewidth was measured by two techniques that confirm each other: delayed self-heterodyne interferometry and optical frequency comb interferometry. A model fits the experimental results well and enables extraction of the bias and temperature dependent α parameter. At 20°C, α is less than 0.5 at threshold and increases to only 0.9 at 150 mA above threshold. The corresponding values at 80°C are 2 and 2.5. These results imply a great potential of QD lasers for the most demanding applications in terms of spectral purity, such as coherent optical communication systems and optical metrology.

Large linewidth reduction in semiconductor lasers based on atom-like gain material

https://onlinelibrary.wiley.com/doi/pdf/10.1002/andp.202000015

Advances in Functional Nanomaterials Science

Using quantum dot (QD) structures as active material for optoelectronics was already in focus before the development of quantum well (QW) lasers and before semiconductor lasers occupied an important place in the market. The big step in reducing laser threshold conditions by substituting bulk gain materials with QWs should find a logical continuation by further reducing the dimensionality toward full 3D carrier confinement by QDs. This was predicted by theoretical considerations at the beginning of the 1980s [1], [2]. However, no practical technologies were available at that time. Top-down approaches, as originally addressed, to produce nanoscale species on very large surfaces and interface areas resulted in the accumulation of a large defect density within the active region and the domination of nonradiative carrier recombination mechanisms. Only during the early 1990s was a major breakthrough achieved with the introduction of the bottom-up approach of strain-driven, self-organized epitaxial QD growth. The first lasers were obtained in the gallium arsenide (GaAs)-based material system [3].

1.5-mm Indium Phosphide-Based Quantum Dot Lasers and Optical Amplifiers: The Impact of Atom-Like Optical Gain Material for Optoelectronics Devices

Optimization of size uniformity and dot density of InxGa1−xAs/GaAs quantum dots for laser applications in 1 µm wavelength range

We report on high quality InAs/InP quantum dot optical amplifiers for the 1550 nm wavelength range operating over a wide temperature range of 25 to 100 °C. A temperature dependent shift of the peak gain wavelength at a rate of 0.78 nm/K is observed. Consequently, two possible modes of operation are performed for a systematic device characterization over the entire temperature range. In the first mode, the signal wavelength is tuned to always match the peak gain wavelength while in the second mode, the signal wavelength is kept constant as the gain spectrum shifts with the temperature. Static characteristics, such as gain spectra and saturation levels, as well as dynamical properties, are presented. Distortion-less amplification of a single 28 Gbit/s signal and cross-talk free amplification of two channels, detuned by 2 nm, were demonstrated over the entire temperature range.

F Schanbel

Papers

Static and dynamic characteristics of an InAs/InP quantum-dot optical amplifier operating at high temperatures