The Lattice Discrete Particle Model (LDPM) formulated in the preceding Part I of this study is calibrated and validated in the present Part II. Calibration and validation is performed by comparing the results of numerical simulations with experimental data gathered from the literature. Simulated experiments include uniaxial and multiaxial compression, tensile fracture, shear strength, and cycling compression tests.

Lattice Discrete Particle Model (LDPM) for failure behavior of concrete. II: Calibration and validation

Fil: Sfer, Domingo. Universidad Nacional de Tucuman. Facultad de Ciencias Exactas y Tecnologia; Argentina

Study of the Behavior of Concrete under Triaxial Compression

Shape and Size Effects on the Compressive Strength of High-strength Concrete

Fracture energy based bi-dissipative damage model for concrete

Compressive behaviour of recycled aggregate concrete under impact loading

0025-5432/97 © RILEM tory cast its own specimens following a prescribed recipe The pre-peak behaviour was found to be independent of specimen slenderness when low friction loading platens were used However, for all loading systems a strong increase of (post-peak) ductility was found with decreasing specimen slenderness Analysis of the results, and comparison with data from literature, showed that irrespective of the loading system used, a perfect localization of deformations occured in the post-peak regime, which was first recognised by Van Mier in a series of uniaxial compression tests on concrete between brushes in 1984 Based on the results of the Round Robin, a draft recommendation will be made for a test procedure to measure strain softening of concrete under uniaxial compression Although the post-peak stress-strain behaviour seems to be a mixture of material and structural behaviour, it appears that a test on either prismatic or cylindrical specimens of slenderness h/d = 2, loaded between low friction boundaries (for example by inserting sheets of tef lon between the steel loading platen and the specimen), yields reproducible results with relatively low scatter For normal strength concrete, the closed-loop test can be controlled by using the axial platen-to-platen deformation as a feed-back signal, whereas for high-strength concrete either a combination of axial and lateral deformation should be used, or a combination of axial deformation and axial load FOREWORD An extensive Round Robin test programme on compressive softening was carried out by the RILEM Technical Committee 148-SSC “Test methods for the Strain Softening response of Concrete” The goal was to develop a reliable standard test method for measuring strain softening of concrete under uniaxial compression The main variables in the test programme were the specimen slenderness h/d and the boundary restraint caused by the loading platen used in the experiments Both high friction and low friction loading systems were applied Besides these main variables, which are both related to the experimental environment under which softening is measured, two different concretes were tested: a normal strength concrete of approximately 45 MPa and a higher strength concrete of approximately 75 MPa In addition to the prescribed test variables, due to individual initiatives, the Round Robin also provided information on the effect of specimen shape and size The experiments revealed that under low boundary friction a constant compressive strength is measured irrespective of the specimen slenderness For high friction loading systems (plain steel loading platen), an increase of specimen strength is found with decreasing slenderness However, for slenderness greater than 2 (and up to 4), a constant strength was measured The shape of the stress-strain curves was very consistent, in spite of the fact that each laboraRILEM TC 148-SSC: TEST METHODS FOR THE STRAIN-SOFTENING RESPONSE OF CONCRETE

/pdf/strain-softening-of-concrete-in-uniaxial-compression-143y1q4dh3.pdf

G. Markeset

Papers

Strain-softening of concrete in uniaxial compression

Test method for measurement of the strain-softening behaviour of concrete under uniaxial compression