M
M.S. Donley
Researcher at Wright-Patterson Air Force Base
Publications - 23
Citations - 1873
M.S. Donley is an academic researcher from Wright-Patterson Air Force Base. The author has contributed to research in topics: Thin film & Corrosion. The author has an hindex of 19, co-authored 23 publications receiving 1778 citations.
Papers
More filters
Journal ArticleDOI
Design of a Ti/TiC/DLC functionally gradient coating based on studies of structural transitions in Ti–C thin films
TL;DR: In this paper, phase transitions between adhesive metal, load supporting carbide, and wear-resistant diamond-like carbon (DLC) surfaces were investigated on the Ti-C system prepared by a hybrid of magnetron sputtering and pulsed laser deposition.
Journal ArticleDOI
An XPS study of cerium dopants in sol–gel coatings for aluminum 2024-T3
TL;DR: In this article, a few wt.% of cerium salts were investigated as coatings on aluminum alloy 2024-T3, and no change in the oxidation state of the cerium in the sol-gels was found.
Journal ArticleDOI
Plasma electrolytic fabrication of oxide ceramic surface layers for tribotechnical purposes on aluminium alloys
TL;DR: In this article, the problem of technical and economical optimization of the process of microarc discharge oxidation of high-strength aluminium for the fabrication of oxide ceramic layers for tribotechnical purposes is considered in terms of experimental design.
Journal ArticleDOI
Chemical and tribological characterization of PbOMoS2 films grown by pulsed laser deposition
TL;DR: The potential of pulsed laser deposition to incorporate additives into MoS2 films was investigated in this paper, where composites were grown on stainless steel substrates using the 248 nm radiation from a KrF excimer laser.
Journal ArticleDOI
Potentiodynamic evaluation of sol–gel coatings with inorganic inhibitors
TL;DR: The use of corrosion inhibitors within organically modified sol-gel coatings is discussed in this article, where the improved performance characteristics were derived from the solgel ability to form a uniform, low defect, barrier coating.