To date, the most widely adopted resource conserving technology in the Indo-Gangetic Plains (IGP) of South Asia has been zero-tillage (ZT) wheat after rice, particularly in India. The paper reviews and synthesizes the experience with ZT in the Indian IGP. ZT wheat is particularly appropriate for rice–wheat systems in the IGP by alleviating system constraints by allowing earlier wheat planting, helping control the weed Phalaris minor , reducing production costs and saving water. ZT wheat after rice generates substantial benefits at the farm level (US$97 ha −1 ) through the combination of a ‘yield effect’ (a 5–7% yield increase, particularly due to more timely planting of wheat) and a ‘cost savings effect’ (US$52 ha −1 , particularly tillage savings). These benefits explain the widespread interest of farmers and the rapidity of the diffusion across the Indian IGP, further aided by the wide applicability of this mechanical innovation.

Zero tillage impacts in India's rice–wheat systems: A review

Rice and wheat are the staple foods for almost the entire Asian population and therefore they occupy a premium position among all food commodities. The era of the Green Revolution started during the early 1970s with wheat and rice and since then the rice–wheat cropping system of the Indo-Gangetic Plains has played a significant role in the food security of the region. However, recent years have witnessed a significant slowdown in the yield growth rate of this system and the sustainability of this important cropping system is at risk due to second-generation technology problems and mounting pressure on natural resources. Traditional cultivars and conventional agronomic practices are no longer able to even maintain the gains in productivity achieved during the past few decades. Demand for food is increasing with the increasing population and purchasing power of consumers. The rice–wheat cropping system is labor-, water-, and energy-intensive and it becomes less profitable as these resources become increasingly scarce and the problem is aggravated with deterioration of soil health, the emergence of new weeds, and emerging challenges of climate change. Therefore, a paradigm shift is required for enhancing the system's productivity and sustainability. Resource-conserving technologies involving zero- or minimum-tillage in wheat, dry direct seeding in rice, improved water- and nutrient-use efficiency, innovations in residue management to avoid straw burning, and crop diversification should assist in achieving sustainable productivity and allow farmers to reduce inputs, maximize yields, increase profitability, conserve the natural resource base, and reduce risk due to both environmental and economic factors. A number of technological innovation and diversification options have been suggested to overcome the system's sustainability problems but some of them have not been fully embraced by the farmers as these are expensive, knowledge-intensive, or do not fit into the system and have resulted in some other unforeseen problems. Different concerns and possible strategies needed to sustain the rice–wheat cropping system are discussed in this review on the basis of existing evidence and future challenges.

Productivity and sustainability of the rice-wheat cropping system in the indo-gangetic plains of the Indian subcontinent: Problems, opportunities, and strategies

Increasing the productivity of the rice–wheat (RW) system in north-west India is critical for the food security of India. However, yields are stagnating or declining, and the rate of groundwater use is not sustainable.

Many improved technologies are under development for RW systems, with multiple objectives including increased production, improved soil fertility, greater input use efficiency, reduced environmental pollution, and higher profitability for farmers. There are large reductions in irrigation amount with many of these technologies compared with conventional practice, such as laser land leveling, alternate wetting and drying (AWD) water management in rice, delayed rice transplanting, shorter duration rice varieties, zero till wheat, raised beds, and replacing rice with other crops. However, the nature of the irrigation water savings has seldom been determined. It is often likely to be due to reduced deep drainage, with little effect on evapotranspiration (ET).

Reducing deep drainage has major benefits, including reduced energy consumption to pump groundwater, nutrient loss by leaching, and groundwater pollution. The impacts of alternative technologies on deep drainage (and thus on irrigation water savings) vary greatly depending on site conditions, especially soil permeability, depth to the watertable, and water management. More than 90% of the major RW areas in north-west India are irrigated using groundwater. Here, reducing deep drainage will not “save water” nor reduce the rate of decline of the watertable. In these regions, it is critical that technologies that decrease ET and increase the amount of crop produced per amount of water lost as ET (i.e., crop water productivity, WPET) are implemented. The best technologies for achieving this are delaying rice transplanting and short duration rice varieties. The potential for replacing rice with other crops with lower ET is less clear.

Halting the groundwater decline in north-west India--which crop technologies will be winners?

/pdf/optimizing-intensive-cereal-based-cropping-systems-19p43b1nru.pdf

Optimizing intensive cereal-based cropping systems addressing current and future drivers of agricultural change in the northwestern Indo-Gangetic Plains of India

Intensification of rice-based cropping systems in Asia has substantially increased production of food and associated crop residues. The interval between crops in these systems is often brief, making it attractive for farmers to burn residues in the field to hasten and facilitate tillage for the next crop. Open-air burning causes serious air quality problems affecting human health and safety, and it has been banned by many Asian governments. In this chapter, we evaluate for rice-based cropping systems existing and emerging in-field alternatives to burning residues based on criteria of productivity, profitability, environmental impact, and sustainability. In intensive rice monocropping systems, residue is typically managed under conditions of soil flooding and anaerobic decomposition during the rice crop. In systems, where rice is rotated with an upland (non-flooded) crop, there are two major categories: residue of upland crop managed during flooded rice and rice residue managed during the upland crop. One option during the flooded rice crop is incorporation of residues from the previous rice or upland crop into the soil. Many studies have examined incorporation of crop residue during land preparation for flooded rice. In the vast majority of cases there was no significant increase in yield or profit. Residue decomposition in anaerobic flooded soil substantially increases methane (CH 4 ) emission relative to residue removal. Surface retention of residue during rice cropping is challenging to implement because residue must be removed from the field during conventional tillage with soil flooding (i.e., puddling) and then returned. Alternatively, rice must be established without the traditional puddling that has helped sustain its productivity. Mulch is a good option for rice residue management during the upland crop, especially with reduced and no tillage. Mulch can increase yield, water use efficiency, and profitability, while decreasing weed pressure. It can slightly increase nitrous oxide (N 2 O) emission compared with residue incorporation or removal, but N fertilization and water management are typically more important factors controlling N 2 O emission than residue management. Long-term studies of residue removal have indicated that removing residue from continuous rice systems with near continuous soil flooding does not adversely affect soil organic matter (SOM). The use of crop residue as a mulch with reduced or no tillage for upland crops should be promoted in rice-based cropping systems. On the contrary, residues from the crop preceding rice on puddled and flooded soil can be considered for removal for off-field uses.

Chapter 3 Crop Residue Management for Lowland Rice-Based Cropping Systems in Asia

Lack of suitable machinery is a major constraint to direct drilling into combine-harvested rice residues due to the heavy straw load, and the presence of loose tough straw deposited by the harvester. Therefore, most rice stubbles are burnt in the mechanised rice–wheat systems of south Asia and Australia, as this is a rapid and cheap option, and allows for quick turn around between crops. As well as loss of organic matter and nutrients, rice stubble burning causes very serious and widespread air pollution in the north-west Indo-Gangetic Plains, where rice–wheat systems predominate. A novel approach with much promise is the Happy Seeder, which combines the stubble mulching and seed drilling functions in the one machine. The stubble is cut and picked up in front of the sowing tynes, which engage bare soil, and deposited behind the seed drill as mulch. Evaluation of the technology over 3 years in replicated experiments and farmers’ fields in Punjab, India, showed that establishment of wheat sown into rice residues with the Happy Seeder was comparable with establishment using conventional methods (straw burnt followed by direct drilling or cultivation before sowing) for sowings around the optimum time into stubbles up to 7.5 t/ha. For late sowings, plant density declined significantly at straw loads above 5 t/ha. The mulch also reduced weed biomass by ~60%, and reduced soil evaporation. Yield of wheat sown around the optimum time into rice residues, using the Happy Seeder, was comparable with or higher than yield after straw removal or burning, in replicated experiments and farmers’ fields, for straw loads up to 9 t/ha. In farmers’ fields there was an average yield increase of 9 and 11% in 2004–05 and 2005–06, respectively, compared with farmer practice. For sowings after the optimum time, yield declined significantly at straw loads greater than 7.5 t/ha. The Happy Seeder offers the means of drilling wheat into rice stubble without burning, eliminating air pollution and loss of nutrients and organic carbon due to burning, at the same time as maintaining or increasing yield.

The Happy Seeder enables direct drilling of wheat into rice stubble

Burning of rice stubbles is widely practised in Punjab, India, due to a lack of suitable machinery to direct drill wheat into combine-harvested rice residues. Although burning is a rapid and cheap option, and allows quick turn around between crops, it has serious effects on human and animal health due to air pollution, reduced soil fertility due to loss of nutrients and organic matter, and green house gas (GHG) emissions. The recently developed Happy Seeder (HS) overcomes the technical problems associated with direct drilling into rice residues. The primary aim of the present study was to conduct a preliminary evaluation of the direct financial benefits and costs to farmers of use of the HS in comparison with the current practices of straw burning followed by direct drilling or conventional tillage prior to sowing. The results of the evaluation suggest that the HS technology is more profitable than conventional cultivation or direct drilling after burning, and that it is viable for farmers from a financial perspective. The net present value (NPV) of the benefits is highly sensitive to yield; a 5% increase in yield with the HS doubles the increase in NPV of the HS over conventional tillage. The NPV is also quite sensitive to changes in herbicide use, and less sensitive to changes in irrigation water saving and discount rate. Furthermore, there are significant economic, community and environmental benefits through adoption of the technology. For widespread adoption of the technology, a range of potential mechanical, technical, social, institutional and policy constraints need to be considered and addressed in conjunction with a detailed economic assessment of the HS technology.

Economic evaluation of the Happy Seeder for rice-wheat systems in Punjab, India

Laser land levelling has contributed immensely to irrigation water saving to cope with declining ground water tables in South Asia. A topographic survey of a field is a pre-requisite to achieve high accuracy in land levelling. Presently, manual topographic surveys are conducted before using a laser land leveller in South Asia, which is cumbersome, time consuming and requires substantial operator skill. A novel sensor-based automatic topographic survey is potentially more precise and cost-effective. Therefore, a field study was conducted to compare the efficiency of a tractor operated sensor-based automatic survey system attached to a laser leveller compared with the conventional manual topographic survey. The automatic survey system consisted of automatic functioning of the laser operated power mast and scraper. The automatic survey method significantly reduced the earthwork and levelness index by 74.0 and 75.4% compared with 61.5 and 62.1% for manual topographic survey, respectively. The automatic survey improved the land uniformity coefficient by 78.4% compared with 42.4% for the manual survey. Average fuel consumption and field capacity were 56.5% and 48% higher for automatic survey compared to manual topographic survey method. The average survey cost was 38.2% lower for automatic survey compared with manual survey. The field capacity of the laser leveller (including the time taken for field survey) was significantly higher by 53% for automatic survey than manual survey. The total cost of operation of automatic survey method was 30.1% lower compared with conventional manual survey. Based on the results from this study, the newly developed automatic survey system is superior to conventional manual survey method in terms of precision in land levelling and economic gains.

Manpreet-Singh

Papers

The Happy Seeder enables direct drilling of wheat into rice stubble

Economic evaluation of the Happy Seeder for rice-wheat systems in Punjab, India

Performance evaluation of automatic vis-à-vis manual topographic survey for precision land levelling