Wireless Communications

A cellular base station serves a multiplicity of single-antenna terminals over the same time-frequency interval. Time-division duplex operation combined with reverse-link pilots enables the base station to estimate the reciprocal forward- and reverse-link channels. The conjugate-transpose of the channel estimates are used as a linear precoder and combiner respectively on the forward and reverse links. Propagation, unknown to both terminals and base station, comprises fast fading, log-normal shadow fading, and geometric attenuation. In the limit of an infinite number of antennas a complete multi-cellular analysis, which accounts for inter-cellular interference and the overhead and errors associated with channel-state information, yields a number of mathematically exact conclusions and points to a desirable direction towards which cellular wireless could evolve. In particular the effects of uncorrelated noise and fast fading vanish, throughput and the number of terminals are independent of the size of the cells, spectral efficiency is independent of bandwidth, and the required transmitted energy per bit vanishes. The only remaining impairment is inter-cellular interference caused by re-use of the pilot sequences in other cells (pilot contamination) which does not vanish with unlimited number of antennas.

Noncooperative Cellular Wireless with Unlimited Numbers of Base Station Antennas

Multiple-input multiple-output (MIMO) technology is maturing and is being incorporated into emerging wireless broadband standards like long-term evolution (LTE) [1]. For example, the LTE standard allows for up to eight antenna ports at the base station. Basically, the more antennas the transmitter/receiver is equipped with, and the more degrees of freedom that the propagation channel can provide, the better the performance in terms of data rate or link reliability. More precisely, on a quasi static channel where a code word spans across only one time and frequency coherence interval, the reliability of a point-to-point MIMO link scales according to Prob(link outage) ` SNR-ntnr where nt and nr are the numbers of transmit and receive antennas, respectively, and signal-to-noise ratio is denoted by SNR. On a channel that varies rapidly as a function of time and frequency, and where circumstances permit coding across many channel coherence intervals, the achievable rate scales as min(nt, nr) log(1 + SNR). The gains in multiuser systems are even more impressive, because such systems offer the possibility to transmit simultaneously to several users and the flexibility to select what users to schedule for reception at any given point in time [2].

/pdf/scaling-up-mimo-opportunities-and-challenges-with-very-large-puqp9v7gzk.pdf

Scaling Up MIMO: Opportunities and Challenges with Very Large Arrays

The quintessential goal of sensor array signal processing is the estimation of parameters by fusing temporal and spatial information, captured via sampling a wavefield with a set of judiciously placed antenna sensors. The wavefield is assumed to be generated by a finite number of emitters, and contains information about signal parameters characterizing the emitters. A review of the area of array processing is given. The focus is on parameter estimation methods, and many relevant problems are only briefly mentioned. We emphasize the relatively more recent subspace-based methods in relation to beamforming. The article consists of background material and of the basic problem formulation. Then we introduce spectral-based algorithmic solutions to the signal parameter estimation problem. We contrast these suboptimal solutions to parametric methods. Techniques derived from maximum likelihood principles as well as geometric arguments are covered. Later, a number of more specialized research topics are briefly reviewed. Then, we look at a number of real-world problems for which sensor array processing methods have been applied. We also include an example with real experimental data involving closely spaced emitters and highly correlated signals, as well as a manufacturing application example.

Two decades of array signal processing research: the parametric approach

It is shown that, particularly for terrestrial cellular telephony, the interference-suppression feature of CDMA (code division multiple access) can result in a many-fold increase in capacity over analog and even over competing digital techniques. A single-cell system, such as a hubbed satellite network, is addressed, and the basic expression for capacity is developed. The corresponding expressions for a multiple-cell system are derived. and the distribution on the number of users supportable per cell is determined. It is concluded that properly augmented and power-controlled multiple-cell CDMA promises a quantum increase in current cellular capacity. >

On the capacity of a cellular CDMA system

The problem of estimating propagation delays of the transmitted signals in a direct-sequence code-division multiple-access (DS-CDMA) system operating over fading channels is considered. Even though this study is limited to the case when the propagation delays are fixed during the observation interval, the channel gain and phase are allowed to vary in time. Special attention is given to the near-far problem which is catastrophic for the standard acquisition algorithm. An estimator based on subspace identification techniques is proposed, and the Cramer-Rao bound, which serves as an optimality criterion, is derived. The Cramer-Rao bound is shown to be independent of the near-far problem, which implies that there is no fundamental reason for propagation delay estimators to be near-far limited. Furthermore, the proposed algorithm is experimentally shown to be robust against the near-far problem.

DS-CDMA synchronization in time-varying fading channels

The WCDMA uplink has recently been enhanced with hybrid ARQ, scheduling, and shorter TTI to provide improved performance for packet data services in terms of reduced delays, improved availability of high data rates, and increased capacity. This paper gives an overview of the design targets, the basic principles, and how they are integrated into WCDMA.

WCDMA enhanced uplink - principles and basic operation

6G will likely be the first generation of mobile communication that will feature tight integration of localization and sensing with communication functionalities. Among several worldwide initiatives, the Hexa-X flagship project stands out as it brings together 25 key players from adjacent industries and academia, and has among its explicit goals to research fundamentally new radio access technologies and high-resolution localization and sensing. Such features will not only enable novel use cases requiring extreme localization performance, but also provide a means to support and improve communication functionalities. This paper provides an overview of the Hexa-X vision alongside the envisioned use cases. To close the required performance gap of these use cases with respect to 5G, several technical enablers will be discussed, together with the associated research challenges for the coming years.

Integration of Communication and Sensing in 6G: a Joint Industrial and Academic Perspective

The invention is a method and apparatus for signaling uplink control information in a mobile communication network using carrier aggregation. The signaling mechanism allows the transmission, on a single uplink component carrier, of control information associated with a downlink transmission on multiple aggregated downlink component carriers. Semi-statically reserved resources for the transmission of control information on the uplink component carrier may be dynamically shared byuser terminals that are assigned multiple downlink component carriers for downlink transmissions. Implicit or explicit resource indication can be used in combination with dynamic resource indication.

Pucch resource allocation for carrier aggregation in lte-advanced

Channel state feedback is provided from a UE to a base station as a first, detailed or a second, less detailed type of channel state feedback information. Initially it is determined whether the UE has received an uplink grant from the base station or not. If the UE has received an uplink grant, a first type of channel state feedback information is transmitted to the base station on the granted resource. If, however, the UE has not received an uplink grant, a second type of channel state feedback information is transmitted to the base station. Different types of channel state feedback information enables a UE and an associated base station to use available resources more efficiently, when requesting for and delivering channel state feedback information.

Stefan Parkvall

Papers

DS-CDMA synchronization in time-varying fading channels

WCDMA enhanced uplink - principles and basic operation

Integration of Communication and Sensing in 6G: a Joint Industrial and Academic Perspective

Pucch resource allocation for carrier aggregation in lte-advanced

Using an uplink grant as trigger of first or second type of CQI report