Preface. 1. Introduction and Overview. 1.1 Introduction. 1.2 Compact Microstrip Antennas. 1.3 Compact Broadband Microstrip Antennas. 1.4 Compact Dual-Frequency Microstrip Antennas. 1.5 Compact Dual-Polarized Microstrip Antennas. 1.6 Compact Circularly Polarized Microstrip Antennas. 1.7 Compact Microstrip Antennas with Enhanced Gain. 1.8 Broadband Microstrip Antennas. 1.9 Broadband Dual-Frequency and Dual-Polarized Microstrip Antennas. 1.10 Broadband and Dual-Band Circularly Polarized Microstrip Antennas. 2. Compact Microstrip Antennas. 2.1 Introduction. 2.2 Use of a Shorted Patch with a Thin Dielectric Substrate. 2.3 Use of a Meandered Patch. 2.4 Use of a Meandered Ground Plane. 2.5 Use of a Planar Inverted-L Patch. 2.6 Use of an Inverted U-Shaped or Folded Patch. 3. Compact Broadband Microstrip Antennas. 3.1 Introduction. 3.2 Use of a Shorted Patch with a Thick Air Substrate. 3.3 Use of Stacked Shorted Patches. 3.4 Use of Chip-Resistor and Chip-Capacitor Loading Technique. 3.5 Use of a Slot-Loading Technique. 3.6 Use of a Slotted Ground Plane. 4. Compact Dual-Frequency and Dual-Polarized Microstrip Antennas. 4.1 Introduction. 4.2 Some Recent Advances in Regular-Size Dual-Frequency Designs. 4.3 Compact Dual-Frequency Operation with Same Polarization Planes. 4.4 Compact Dual-Frequency Operation. 4.5 Dual-Band or Triple-Band PIFA. 4.6 Compact Dual-Polarized Designs. 5. Compact Circularly Polarized Microstrip Antennas. 5.1 Introduction. 5.2 Designs with a Cross-Slot of Unequal Arm Lengths. 5.3 Designs with a Y-Shaped Slot of Unequal Arm Lengths. 5.4 Designs with Slits. 5.5 Designs with Spur Lines. 5.6 Designs with Truncated Corners. 5.7 Designs with Peripheral Cuts. 5.8 Designs with a Tuning Stub. 5.9 Designs with a Bent Tuning Stub. 5.10 Compact CP Designs with an Inset Microstrip-Line Feed. 6. Compact Microstrip Antennas with Enhanced Gain. 6.1 Introduction. 6.2 Compact Microstrip Antennas with High-Permittivity Superstrate. 6.3 Compact Microstrip Antennas with Active Circuitry. 7. Broadband Microstrip Antennas. 7.1 Introduction. 7.2 Use of Additional Microstrip Resonators. 7.3 Microstrip Antennas with an Air Substrate. 7.4 Broadband Slot-Loaded Microstrip Antennas. 7.5 Broadband Microstrip Antennas with an Integrated Reactive Loading. 7.6 Broadband Microstrip Antennas with Reduced Cross-Polarization Radiation. 8. Broadband Dual-Frequency and Dual-Polarized Microstrip Antennas. 8.1 Introduction. 8.2 Broadband Dual-Frequency Microstrip Antennas. 8.3 Broadband Dual-Polarized Microstrip Antennas. 9. Broadband and Dual-Band Circularly Polarized Microstrip Antennas. 9.1 Introduction. 9.2 Broadband Single-Feed Circularly Polarized Microstrip Antennas. 9.3 Broadband Two-Feed Circularly Polarized Microstrip Antennas. 9.4 Broadband Four-Feed Circularly Polarized Microstrip Antennas. 9.5 Dual-Band Circularly Polarized Microstrip Antennas. Index.

Compact and Broadband Microstrip Antennas

The objective of this paper is to summarize the work that has been developed by the authors for the last several years, in order to demonstrate that the Theory of Characteristic Modes can be used to perform a systematic design of different types of antennas. Characteristic modes are real current modes that can be computed numerically for conducting bodies of arbitrary shape. Since characteristic modes form a set of orthogonal functions, they can be used to expand the total current on the surface of the body. However, this paper shows that what makes characteristic modes really attractive for antenna design is the physical insight they bring into the radiating phenomena taking place in the antenna. The resonance frequency of modes, as well as their radiating behavior, can be determined from the information provided by the eigenvalues associated with the characteristic modes. Moreover, by studying the current distribution of modes, an optimum feeding arrangement can be found in order to obtain the desired radiating behavior.

The Theory of Characteristic Modes Revisited: A Contribution to the Design of Antennas for Modern Applications

Several solutions are presented to reduce the mutual coupling between two planar inverted-F antennas (PIFAs) working in close radiocommunication standards and positioned on a finite-sized ground plane modeling the printed circuit board (PCB) of a typical mobile phone. First, the two PIFAs are designed on separate PCBs to, respectively, operate in the DCS1800 and UMTS bands. In a second step, they are associated on the top edge of the same PCB. Realistic arrangements are then theoretically and experimentally studied. Finally, several solutions are investigated to maximize the isolation. They consist in inserting a suspended line between the PIFAs' feedings and/or shorting points. All along this paper, several prototypes are fabricated and their performances measured to validate the obtained IE3D moment method-based simulation results

Study and Reduction of the Mutual Coupling Between Two Mobile Phone PIFAs Operating in the DCS1800 and UMTS Bands

The concept of concurrent multiband low-noise-amplifiers (LNAs) is introduced. A systematic way to design concurrent multiband integrated LNAs in general is developed. Applications of concurrent multiband LNAs in concurrent multiband receivers together with receiver architecture are discussed. Experimental results of a dual-band LNA implemented in a 0.35-/spl mu/m CMOS technology as a demonstration of the concept and theory is presented.

/pdf/concurrent-multiband-low-noise-amplifiers-theory-design-and-1iy48rdapl.pdf

Concurrent multiband low-noise amplifiers-theory, design, and applications

The performance of the mobile phone handset antenna-chassis combination is analyzed based on an approximate decomposition of the waves on the structure into two resonant wavemodes: the antenna-element wavemode and the chassis wavemode. A double resonator equivalent circuit model is presented and used to estimate the impedance bandwidth and the respective distributions of radiation losses with typical parameter values at 900 and 1800 MHz. It is noticed that at 900 MHz, the radiation losses of the antenna element wavemode represent typically less than 10% of the total power. Thus, the antenna element works mainly as a matching element, which couples to the low-Q resonant wavemode of the chassis. At 1800 MHz, the contribution of the antenna element wavemode is larger. By enhancing the coupling and by tuning the chassis resonance, it is possible to obtain an impedance bandwidth of over 50% (6 dB return loss) at both at 900 and 1800 MHz. The results given by the equivalent circuit study are fully supported by those of three-dimensional phone-model simulations, including calculation of the SAR and efficiency values. In prototyping, the 6 dB bandwidth of 5.5% was obtained at 980 MHz with a nonradiating coupling element with a volume of 1.6 cm/sup 3/ on a 120 mm long chassis.

/pdf/resonator-based-analysis-of-the-combination-of-mobile-6ags7cyeod.pdf

Resonator-based analysis of the combination of mobile handset antenna and chassis

Cellular telephone handsets are now being designed to have dual-mode capabilities. In particular, there is a requirement for internal antennas for GSM and DCS1800 systems. This paper describes a novel planar dual-band inverted-F antenna for cellular handsets, which operates at the 0.9-GHz and 1.8-GHz bands. The dual-band antenna has almost the same size as a conventional inverted-F antenna operating at 0.9 GHz and has an isolation between bands of better than 17 dB. The bandwidths of the antenna are close to those required for the above systems. Good dual-band action is also obtained for other frequency ratios in the range of 1.3-2.4. Studies also show that the dual-band antenna can operate with one or two feeds. A finite-difference time-domain analysis has been shown to give calculated results close to those measured.

Dual-frequency planar inverted-F antenna

Terahertz (THz) joint radar-communication (T-JRC) has been envisioned as a method to overcome the challenges in THz communications. Recent works mainly emphasize the tradeoffs between radar estimations and data communications, unable to characterize the mutual benefit relationship as a key feature of T-JRC system. In this work, a comprehensive performance model considering both tradeoff and benefit relationship is derived for THz systems under random mobility. TJRC performance in three typical cases is analyzed to present the universality of the model. Additionally, the bounds of TJRC performance are acquired in terms of the communication data rate and a novel radar rate extended from the traditional works. Finally, the simulations of T-JRC systems considering mobility, beamwidth and distance are performed to validate the derived models. Numerical results indicate that the mutual benefit relationship dominates in low radar rate, while tradeoffs are crucial when the radar estimations are sufficient.

Performance Model of Terahertz Joint Radar-Communication Systems Under Random Mobility

As an enabler technology in future network, terahertz (THz) joint radar-communication (T-JRC) has been envisioned as a solution to overcome the challenges in THz communications. Recent works on JRC mainly emphasize either performance tradeoffs or mutual benefits between radar and communication functionalities. Unable to characterize both benefit and tradeoff relationships, existing metrics and models are inapplicable to performance analysis on T-JRC systems. In this paper, a closed-form T-JRC performance model are proposed to explore the relationship between radar and communication metrics. To begin with, a novel T-JRC system model concerning random mobility and THz beam tracking is put forward. Next, the performance bounds of T-JRC performance in terms of communication rate and a proposed radar rate are acquired in three different integration cases. Furthermore, the expression of communication rate by radar rate in T-JRC is obtained theoretically, which is the first time to derive the closed-form relationship considering both benefits and tradeoffs to the best of our knowledge. Finally, numerical results validate the proposed model as well as closed-form expression, showing that the model succeeds in benefit and tradeoff relationship characterization in T-JRC systems and the fitting bounds are applicable in non-extreme scenarios. 

Zi Dong Liu

Papers

Dual-frequency planar inverted-F antenna

Performance Model of Terahertz Joint Radar-Communication Systems Under Random Mobility

Closed-Form Model for Performance Analysis of THz Joint Radar-Communication Systems