Journal ArticleDOI
A study of the bone machining process—Drilling
Reads0
Chats0
TLDR
Results indicate that drill point geometry is critical when attempting to minimize drilling forces and that there appears to be a softening effect in bone when drilled at relatively high speeds.About:
This article is published in Journal of Biomechanics.The article was published on 1976-01-01. It has received 133 citations till now. The article focuses on the topics: Drill & Drilling.read more
Citations
More filters
Journal ArticleDOI
A 15-year study of osseointegrated implants in the treatment of the edentulous jaw
TL;DR: The clinical results achieved with bridges on osseointegrated fixtures fulfill and exceed the demands set by the 1978 Harvard Conference on successful dental implantation procedures.
Journal ArticleDOI
Osseointegrated Titanium Implants: Requirements for Ensuring a Long-Lasting, Direct Bone-to-Implant Anchorage in Man
TL;DR: It is concluded that the technique of osseointegration is a reliable type of cement-free bone anchorage for permanent prosthetic tissue substitutes in man for various bone restorative procedures.
Journal ArticleDOI
Osseointegrated Titanium Implants
Journal ArticleDOI
Thermal osteonecrosis and bone drilling parameters revisited
Goran Augustin,Slavko Davila,Kristijan Mihoci,Toma Udiljak,Denis Stjepan Vedrina,Anko Antabak +5 more
TL;DR: The external irrigation is the most important cooling factor with all combinations of parameters used, external irrigation maintained the bone temperature below 47°C and caused increase in bone temperature.
Journal ArticleDOI
Cortical bone drilling and thermal osteonecrosis
Goran Augustin,Tomislav Zigman,Slavko Davila,Toma Udilljak,Tomislav Staroveški,Danko Brezak,Slaven Babic +6 more
TL;DR: Important drill and drilling parameters that could cause increase in bone temperature and hence thermal osteonecrosis are reviewed and discussed: drilling speed, drill feed rate, cooling, drill diameter, drill point angle, drill material and wearing, drilling depth, pre-drilling, drill geometry and bone cortical thickness.
References
More filters
Book
BMD : biomedical computer programs
TL;DR: This book is very referred for you because it gives not only the experience but also lesson, it is about this book that will give wellness for all people from many societies.
Journal ArticleDOI
Mechanics of the Metal Cutting Process. II. Plasticity Conditions in Orthogonal Cutting
TL;DR: In this paper, the analysis of the orthogonal cutting with a type 2 chip is extended by introducing those physical properties of the work material which control its plastic behavior, and a simple additional plasticity condition is obtained by application of the principle of minimum energy.
Journal ArticleDOI
Factors Affecting the Determination of the Physical Properties of Femoral Cortical Bone
Elias D. Sedlin,Carl Hirsch +1 more
TL;DR: In this paper, the factors affecting the determination of the physical properties of the femoral Cortical bone were discussed, and the authors proposed a method to determine the physical property of femoral cortical bone.
Journal ArticleDOI
Temperatures Measured in Human Cortical Bone when Drilling
Larry S. Matthews,Carl Hirsch +1 more
TL;DR: All forms of irrigation that allowed the stream of irrigating fluid to be directed to the point of penetration of the cortex were effective in limiting the increases in cortical temperature.
Journal ArticleDOI
Theory of Formation of Metal Chips
TL;DR: In this paper, a new theory of the formation of a discontinuous chip is presented, based on the friction angle τ between the chip and the face of the tool, by which the forces loading the machine tool steeply may be decreased.
Related Papers (5)
Temperature threshold levels for heat-induced bone tissue injury: A vital-microscopic study in the rabbit
A.R. Eriksson,T. Albrektsson +1 more