Open Access
Description of Stress-Strain Curves by Three Parameters
Walter Ramberg,William R Osgood +1 more
Reads0
Chats0
TLDR
In this paper, a simple formula is suggested for describing the stress-strain curve in terms of three parameters; namely, Young's modulus and two secant yield strengths.Abstract:
A simple formula is suggested for describing the stress-strain curve in terms of three parameters; namely, Young's modulus and two secant yield strengths. Dimensionless charts are derived from this formula for determining the stress-strain curve, the tangent modulus, and the reduced modulus of a material for which these three parameters are given. Comparison with the tensile and compressive data on aluminum-alloy, stainless-steel, and carbon-steel sheet in NACA Technical Note No. 840 indicates that the formula is adequate for most of these materials. The formula does not describe the behavior of alclad sheet, which shows a marked change in slope at low stress. It seems probable that more than three parameters will be necessary to represent such stress-strain curves adequately.read more
Citations
More filters
Journal ArticleDOI
Finite element investigation of shear failure of lean duplex stainless steel plate girders
TL;DR: In this article, a finite element modeling for full-size lean duplex stainless steel plate girders of non-rigid end stiffeners of grade EN 1.4162 is presented.
Journal ArticleDOI
Correlation of Resilient and Seismic Modulus Test Results
TL;DR: The most common test to evaluate the representative modulus and nonlinear behavior of base and subgrade materials is the resilient modulus test as discussed by the authors, however, since the seismic tests provide small-strain moduli whereas the resilient tests measure moduli at higher strains, some additional considerations must be taken into account to relate these two moduli.
Journal ArticleDOI
Inelastic buckling analyses of beams, columns and plates using the spline finite strip method
S. C. Lau,Gregory J. Hancock +1 more
TL;DR: In this paper, a method of inelastic buckling analysis of thin-walled structural members and plates is described, based on the spline finite strip method of structural analysis, which takes into account the nonlinear material stress-strain properties, strain hardening and residual stresses.
Journal ArticleDOI
Local stability of press-braked stainless steel angle and channel sections: Testing, numerical modelling and design analysis
Lulu Zhang,Kang Hai Tan,Ou Zhao +2 more
TL;DR: The continuous strength method (CSM) is an advanced deformation-based design method, allowing for a rational utilisation of material strain hardening in determining cross-section resistances as discussed by the authors.
Journal ArticleDOI
A homogenized multigrid XFEM to predict the crack growth behavior of ductile material in the presence of microstructural defects
TL;DR: In this article, a homogenized multigrid XFEM approach has been proposed to simulate the stable crack growth in ductile material using finite strain plasticity, and the accuracy and effectiveness of the proposed approach have been verified by solving several stable crack problems.