Effects of pressure angle on tooth deflection and root stress.
Reads0
Chats0
TLDR
In this article, the effects of pressure angle on tooth deflection and root stress were investigated by using finite difference method (FDM) and the results were compared with those measured.Abstract:
This paper presents a study on the effects of pressure angle on tooth deflection and root stress. The analyses of tooth deflection and bending moment at root fillet due to a concentrated load on a gear tooth with various pressure angles were carried out by the finite difference method (FDM) and the results were compared with those measured. The validity of this analysis method was confirmed and the effects of pressure angle on the tooth deflection and bending moment were made considerably clear. The approximate equations for the deflection and bending moment due to a concentrated load on a gear tooth with various pressure angles were derived on the basis on the calculated and measured results.read more
Citations
More filters
Journal ArticleDOI
Experimental procedure for the evaluation of tooth stiffness in spline coupling including angular misalignment
Francesca Maria Cura,Andrea Mura +1 more
TL;DR: In this article, the experimental values of spline coupling tooth stiffness have been obtained by means of a special hexapod measuring device, and the effect of angular misalignments between hub and shaft has been investigated in the experimental planning.
Journal ArticleDOI
Determining both radial pressure distribution and torsional stiffness of involute spline couplings
TL;DR: In this article, an analytical method is used to investigate the distortions of spline spline teeth and the following hypotheses are adopted: teeth geometry is in conformity with standardizati...
Journal ArticleDOI
The mathematical model of Wildhaber-Novikov gears applicable to finite element stress analysis
TL;DR: In this paper, a finite element method (FEM) using the SAP IV package is employed to the W-N gear stress analysis, and an automatic nodal points and meshes generating (AMG) computer program has been developed.
References
More filters
Journal ArticleDOI
Experimental procedure for the evaluation of tooth stiffness in spline coupling including angular misalignment
Francesca Maria Cura,Andrea Mura +1 more
TL;DR: In this article, the experimental values of spline coupling tooth stiffness have been obtained by means of a special hexapod measuring device, and the effect of angular misalignments between hub and shaft has been investigated in the experimental planning.
Journal ArticleDOI
Determining both radial pressure distribution and torsional stiffness of involute spline couplings
TL;DR: In this article, an analytical method is used to investigate the distortions of spline spline teeth and the following hypotheses are adopted: teeth geometry is in conformity with standardizati...
Journal ArticleDOI
The mathematical model of Wildhaber-Novikov gears applicable to finite element stress analysis
TL;DR: In this paper, a finite element method (FEM) using the SAP IV package is employed to the W-N gear stress analysis, and an automatic nodal points and meshes generating (AMG) computer program has been developed.
Related Papers (5)
Evaluation of load capacity of gears with an asymmetric tooth profile
Tomoya Masuyama,Naoki Miyazaki +1 more