Journal ArticleDOI
Investigation of the wear failure mechanism of a flour milling roller
Quanshun Luo,J Xie,W Lu +2 more
Reads0
Chats0
TLDR
In this article, the stress condition and wear failure mechanisms of a flour milling roller have been investigated, and the wear mechanism of the roller consists of plastic fatigue and multi-impact fatigue wear in the matrix and brittle spalling in the carbides.About:
This article is published in Wear.The article was published on 1993-04-01. It has received 13 citations till now.read more
Citations
More filters
Journal ArticleDOI
Tribological behavior of ceramic materials (Si3N4, SiC and Al2O3) in aqueous medium
TL;DR: In this paper, the friction and wear behavior of self-mated Si3N4, SiC and Al2O3 in water were investigated by varying the test conditions of applied load and sliding speed.
Journal ArticleDOI
Effects of microstructures on the abrasive wear behaviour of spheroidal cast iron
TL;DR: In this paper, the effect of graphite phase on the wear performance of spheroidal cast irons was investigated under both two-body (pin-on-disc) and three-body impact conditions.
Journal ArticleDOI
Understanding the fretting wear of Ti3SiC2
TL;DR: In this article, the tribological properties of Ti 3SiC2 and steel couple were analyzed under different fretting conditions. And the authors found that the triboxidation is accompanied by the formation of TiO 2, SiO2 and Fe2O3.
Journal ArticleDOI
The effect of test parameters on alumina wear under low contact stress
F Xiong,Rafael R. Manory +1 more
TL;DR: In this paper, a flat pin-on-disc wear test method was used to evaluate alumina wear behavior, and two main wear regimes were identified, mild and severe wear respectively, with a transition region in between.
Journal ArticleDOI
Is Glass Infiltration Beneficial to Improve Fretting Wear Properties for Alumina
TL;DR: In this article, the tribological properties of the glass-infiltrated (GI) alumina with a major aim to understand scientifically the influence of glass infiltration on the underlying mechanisms of material removal (when fretted against steel).
References
More filters
Journal ArticleDOI
Principles of abrasive wear
TL;DR: The mechanisms of abrasive wear are reviewed and laboratory test methods assessed in this article, where the results of tests on technically pure metals, heat treated steels, cold work hardened materials, hard wear resistant materials and minerals against fixed abrasive grains are discussed.