Journal ArticleDOI
Mutual influence of plateau roughness and groove texture of honed surface on frictional performance of piston ring–liner system:
Yang Hu,Xianghui Meng,Youbai Xie,Jiazheng Fan +3 more
- Vol. 231, Iss: 7, pp 1350650116682161
Reads0
Chats0
TLDR
The cylinder liner surface finish, which is commonly produced using the honing technique, is an essential factor of engine performance as mentioned in this paper, and the characteristics of the texture features, including the cr...Abstract:
The cylinder liner surface finish, which is commonly produced using the honing technique, is an essential factor of engine performance. The characteristics of the texture features, including the cr...read more
Citations
More filters
Journal ArticleDOI
Evolutions of cylinder liner surface texture and tribological performance of piston ring-liner assembly
TL;DR: In this article, the results of the tribological experiments conducted using an oscillating wear tester under lubricated conditions were presented, where the surface topography of cylinder liners was measured by a white light interferometer.
Journal ArticleDOI
A new efficient flow continuity lubrication model for the piston ring-pack with consideration of oil storage of the cross-hatched texture
Yang Hu,Xianghui Meng,Youbai Xie +2 more
TL;DR: In this article, a new efficient flow continuity lubrication model for the piston ring -pack is established by taking the oil storage of the cross-hatched texture into account, and the trapped oil in the texture is calculated as an extra oil supply to the inlet of the contact.
Journal ArticleDOI
An improved technique for measuring piston-assembly friction and comparative analysis with numerical simulations: Under motored condition
TL;DR: An improved measurement technique is developed that provides an accurate and reliable option for the friction evaluation of piston-assembly components in engine designs and is in good correlation with the well-known Stribeck curve.
Journal ArticleDOI
On the oil-gas-solid mixed bearing between compression ring and cylinder liner under starved lubrication and high boundary pressures
TL;DR: In this article, the oil-gas-solid mixed bearing characteristics and tribological properties of the top ring under starved lubrication were analyzed and it was found that the high boundary pressure has a significant effect and it can even compare with hydrodynamic lubrication and asperity contact near fire top dead centers (FTDCs).
Journal ArticleDOI
Effects of the array modes of laser-textured micro-dimples on the tribological performance of cylinder liner–piston ring:
TL;DR: In this paper, a mixed lubrication model of textured cylinder liners was built to investigate the effects of four array modes namely, square array, stagger array, stretching, and shortening along liners.
References
More filters
Journal ArticleDOI
An Average Flow Model for Determining Effects of Three-Dimensional Roughness on Partial Hydrodynamic Lubrication
Nadir Patir,H. S. Cheng +1 more
Journal ArticleDOI
Application of Average Flow Model to Lubrication Between Rough Sliding Surfaces
Nadir Patir,H. S. Cheng +1 more
Journal ArticleDOI
Correlational Aspects of the Viscosity-Temperature-Pressure Relationship of Lubricating Oils(Dr In dissertation at Technical University of Delft, 1966)
Book
Elasto-hydrodynamic lubrication : the fundamentals of roller and gear lubrication
Duncan Dowson,G. R. Higginson +1 more
Journal ArticleDOI
A Laser Surface Textured Parallel Thrust Bearing
TL;DR: In this article, the potential use of a new technology of laser surface texturing (LST) in parallel thrust bearings is theoretically investigated, where the surface texture has the form of micro-dimples with pre-selected diameter, depth, and area density.
Related Papers (5)
An Average Flow Model for Determining Effects of Three-Dimensional Roughness on Partial Hydrodynamic Lubrication
Nadir Patir,H. S. Cheng +1 more