scispace - formally typeset
Journal ArticleDOI

The influence of minor additions of Y, Sc, and Zr on the microstructural evolution, superplastic behavior, and mechanical properties of AA6013 alloy

Reads0
Chats0
TLDR
In this article , minor additions of Y, Sc, Zr were considered and their influence on the microstructural evolution, superplastic deformation behavior, and room temperature mechanical properties of a novel AA6013-type alloy was studied.
About
This article is published in Journal of Alloys and Compounds.The article was published on 2022-04-01. It has received 9 citations till now. The article focuses on the topics: Superplasticity & Alloy.

read more

Content maybe subject to copyright    Report

Citations
More filters
Journal ArticleDOI

Microstructure Evolution, Constitutive Modelling, and Superplastic Forming of Experimental 6XXX-Type Alloys Processed with Different Thermomechanical Treatments

TL;DR: In this article , the effect of the thermomechanical treatment with various proportions of hot/cold rolling degrees on the secondary particle distribution and deformation behavior was studied, and a constitutive model based on Arrhenius and Beckofen equations was used to describe and predict the superplastic flow behavior of the alloy studied.
Journal ArticleDOI

The Effect of Ce on the Microstructure, Superplasticity, and Mechanical Properties of Al-Mg-Si-Cu Alloy

TL;DR: In this paper, the influence of Ce on the superplastic behavior, microstructure, and mechanical properties of the Al-Mg-Si-Cu-Zr-Sc alloy was investigated.
Journal ArticleDOI

Effect of Sc, Hf, and Yb Additions on Superplasticity of a Fine-Grained Al-0.4%Zr Alloy

TL;DR: In this paper , the way deformation behaves in ultrafine-grained (UFG)-conducting Al-Zr alloys doped with Sc, Hf, and Yb was studied.
Journal ArticleDOI

Grain Refinement of Aluminum and Aluminum Alloys by Sc and Zr

TL;DR: In this article , the effects of rare earth elements and transition elements on the grain refinement of aluminum and aluminum alloys are analyzed. But the authors do not consider the effect of transition elements in the preparation of Al-M master alloys.
References
More filters
Journal ArticleDOI

Scandium in aluminium alloys

TL;DR: A considerable part of the available literature on scandium in aluminium alloys is reviewed in this article, with emphasis on the aluminium rich part of diagrams, including a wide range of ternary Al-Sc-X phase diagrams and a few higher order phase diagrams.
Journal ArticleDOI

Precipitation evolution in Al–Zr and Al–Zr–Ti alloys during aging at 450–600 °C

TL;DR: In this paper, the transformation of Al3Zr and Al3(Zr1−xTix) (L12) precipitates to their respective equilibrium D023 structures is investigated.
Journal ArticleDOI

Effect of minor Sc and Zr on the microstructure and mechanical properties of Al–Mg based alloys

TL;DR: In this article, a series of Al-Mg-based alloy plates with thickness of 4 mm containing minor Sc and Zr were prepared and tensile properties and microstructures of the alloys were studied.
Journal ArticleDOI

New aspect of development of high strength aluminum alloys for aerospace applications

TL;DR: In this paper, the fracture toughness is proportional to the square root of the spacing of constituents, i.e., Cu 2 FeAl 7, in 2024 aluminum alloys, and fracture toughness increases by 20%.
Journal ArticleDOI

Corrosion mechanism associated with Mg2Si and Si particles in Al–Mg–Si alloys

TL;DR: In this article, the electrochemical behaviors and coupling behaviors of the Mg2Si and Si phases with α(Al) were investigated, the corrosion morphologies of Al alloys containing Mg 2Si and si particles were observed, and the corrosion mechanism associated with them in Al-Mg-Si alloys was advanced.
Related Papers (5)