The use of the compressional hydromagnetic mode (also called the magnetosonic or, simply, the fast wave) is examined in some detail with respect to the heating of a tritium plasma containing a few percent deuterium. Efficient absorption of wave energy by the deuteron component is found when ω = ωC (deuterons), with Qwave 100. Reasonable efficiencies are found also for electron heating, but coherence effects between transit-time and Landau damping for electrons reduce the total absorption for both processes to one-half of the transit-time power, calculated separately.The fusion output of a two-component neutral-injected plasma can be enhanced by selective heating of the injected deuterons. Also, selective deuteron absorption may be used for ion-tail creation by radiofrequency excitation alone, as an alternative to neutral injection. The dominant behaviour of the high-energy deuteron distribution function is found to be f(v) ~ exp[(3/2)∫vdv / ], where is the Chandrasekhar-Spitzer drag coefficient, and is the Kennel-Engelmann quasi-linear diffusion coefficient for wave-particle interaction at the deuteron cyclotron frequency. An analytic solution to the one-dimensional Fokker-Planck equation, with r.f.-induced diffusion, is developed, and using this solution together with Duane's fit to the D-T fusion cross-section, it is found that the nuclear-fusion power output from an r.f.-produced two-component plasma can significantly exceed the incremental (radiofrequency) power input.

Fast-wave heating of a two-component plasma

Point design targets have been specified for the initial ignition campaign on the National Ignition Facility [G. H. Miller, E. I. Moses, and C. R. Wuest, Opt. Eng. 443, 2841 (2004)]. The targets contain D-T fusion fuel in an ablator of either CH with Ge doping, or Be with Cu. These shells are imploded in a U or Au hohlraum with a peak radiation temperature set between 270 and 300 eV. Considerations determining the point design include laser-plasma interactions, hydrodynamic instabilities, laser operations, and target fabrication. Simulations were used to evaluate choices, and to define requirements and specifications. Simulation techniques and their experimental validation are summarized. Simulations were used to estimate the sensitivity of target performance to uncertainties and variations in experimental conditions. A formalism is described that evaluates margin for ignition, summarized in a parameter the Ignition Threshold Factor (ITF). Uncertainty and shot-to-shot variability in ITF are evaluated, and...

Point design targets, specifications, and requirements for the 2010 ignition campaign on the National Ignition Facility

Transport Processes in the Plasma

Point Design Targets, Specifications, and Requirements for the 2010 Ignition Campaign on the National Ignition Facility

Arc discharge synthesis of carbon nanotubes: Comprehensive review

Targets meant to achieve ignition on the National Ignition Facility (NIF) [J. A. Paisner, J. D. Boyes, S. A. Kumpan, W. H. Lowdermilk, and M. S. Sorem, Laser Focus World 30, 75 (1994)] have been redesigned and their performance simulated. Simulations indicate dramatically reduced growth of short wavelength hydrodynamic instabilities, resulting from two changes in the designs. First, better optimization results from systematic mapping of the ignition target performance over the parameter space of ablator and fuel thickness combinations, using techniques developed by one of us (Herrmann). After the space is mapped with one-dimensional simulations, exploration of it with two-dimensional simulations quantifies the dependence of instability growth on target dimensions. Low modes and high modes grow differently for different designs, allowing a trade-off of the two regimes of growth. Significant improvement in high-mode stability can be achieved, relative to previous designs, with only insignificant increase in...

/pdf/increasing-robustness-of-indirect-drive-capsule-designs-477lai4zus.pdf

Increasing robustness of indirect drive capsule designs against short wavelength hydrodynamic instabilitiesa)

Target designs are described that are meant to achieve ignition on the National Ignition Facility. Simulations of recent indirect drive cryogenic capsule designs indicate dramatically reduced growth of short wavelength hydrodynamic instabilities, resulting from two changes in the designs. First, better optimization results from systematic mapping of the ignition target performance over the parameter space of ablator and DT-ice thickness combinations, using techniques developed by one of us (Herrmann). After the space is mapped with one-dimensional simulations, exploration of it with two-dimensional simulations quantifies the dependence of instability growth on target dimensions. Low modes and high modes grow differently in different regions of the space, allowing a trade-off of the two regimes of growth. Significant improvement in high-mode stability can be achieved, relative to previous designs, with only insignificant increase in low-mode growth. This procedure produces capsule designs that, in simulations, tolerate several times the surface roughness that could be tolerated by capsules optimized by older more heuristic techniques. Another significant reduction in instability growth, by another factor of several, is achieved with ablators with 'graded dopants.' In this type of capsule the mid-Z dopant, which is needed in the ablator to minimize x-ray preheat at the ablator-ice interface, ismore » optimally positioned within the ablator. A fabrication scenario for graded dopants already exists, using sputter coating to fabricate the ablator shell. We describe the systematics of these advances in capsule design, discuss the basis behind their improved performance, and summarize how this is affecting our plans for NIF ignition.« less

Increasing robustness of indirect drive capsule designs against short wavelength hydrodynamic instabilities

Mass filters using rotating plasmas have been considered for separating nuclear waste and spent nuclear fuel. We propose a new mass filter that utilizes centrifugal and magnetic confinement of ions in a way similar to the asymmetric centrifugal trap. This magnetic centrifugal mass filter is shown to be more proliferation resistant than present technology. This filter is collisional and produces well confined output streams, among other advantages.

/pdf/the-magnetic-centrifugal-mass-filter-5g8v3l3gwp.pdf

The magnetic centrifugal mass filter

The wave-particle α-channeling effect is generalized to include rotating plasma. Specifically, radio frequency waves can resonate with α particles in a mirror machine with E × B rotation to diffuse the α particles along constrained paths in phase space. Of major interest is that the α-particle energy, in addition to amplifying the RF waves, can directly enhance the rotation energy which in turn provides additional plasma confinement in centrifugal fusion reactors. An ancillary benefit is the rapid removal of alpha particles, which increases the fusion reactivity.

/pdf/a-channeling-in-a-rotating-plasma-2qvthrced9.pdf

Abraham J. Fetterman

Papers

Increasing robustness of indirect drive capsule designs against short wavelength hydrodynamic instabilitiesa)

Increasing robustness of indirect drive capsule designs against short wavelength hydrodynamic instabilities

The magnetic centrifugal mass filter

α Channeling in a Rotating Plasma

Enhanced ablation of small anodes in a carbon nanotube arc plasma