In the past ten years we have witnessed a revival of, and subsequent rapid expansion in, the research on zinc oxide (ZnO) as a semiconductor. Being initially considered as a substrate for GaN and related alloys, the availability of high-quality large bulk single crystals, the strong luminescence demonstrated in optically pumped lasers and the prospects of gaining control over its electrical conductivity have led a large number of groups to turn their research for electronic and photonic devices to ZnO in its own right. The high electron mobility, high thermal conductivity, wide and direct band gap and large exciton binding energy make ZnO suitable for a wide range of devices, including transparent thin-film transistors, photodetectors, light-emitting diodes and laser diodes that operate in the blue and ultraviolet region of the spectrum. In spite of the recent rapid developments, controlling the electrical conductivity of ZnO has remained a major challenge. While a number of research groups have reported achieving p-type ZnO, there are still problems concerning the reproducibility of the results and the stability of the p-type conductivity. Even the cause of the commonly observed unintentional n-type conductivity in as-grown ZnO is still under debate. One approach to address these issues consists of growing high-quality single crystalline bulk and thin films in which the concentrations of impurities and intrinsic defects are controlled. In this review we discuss the status of ZnO as a semiconductor. We first discuss the growth of bulk and epitaxial films, growth conditions and their influence on the incorporation of native defects and impurities. We then present the theory of doping and native defects in ZnO based on density-functional calculations, discussing the stability and electronic structure of native point defects and impurities and their influence on the electrical conductivity and optical properties of ZnO. We pay special attention to the possible causes of the unintentional n-type conductivity, emphasize the role of impurities, critically review the current status of p-type doping and address possible routes to controlling the electrical conductivity in ZnO. Finally, we discuss band-gap engineering using MgZnO and CdZnO alloys.

/pdf/fundamentals-of-zinc-oxide-as-a-semiconductor-1s4l8bh009.pdf

Fundamentals of zinc oxide as a semiconductor

Zinc oxide (ZnO) is a wide band gap semiconductor with potential applications in optoelectronics, transparent electronics, and spintronics. The high efficiency of UV emission in this material could be harnessed in solid-state white lighting devices. The problem of defects, in particular, acceptor dopants, remains a key challenge. In this review, defects in ZnO are discussed, with an emphasis on the physical properties of point defects in bulk crystals. As grown, ZnO is usually n-type, a property that was historically ascribed to native defects. However, experiments and theory have shown that O vacancies are deep donors, while Zn interstitials are too mobile to be stable at room temperature. Group-III (B, Al, Ga, and In) and H impurities account for most of the n-type conductivity in ZnO samples. Interstitial H donors have been observed with IR spectroscopy, while substitutional H donors have been predicted from first-principles calculations but not observed directly. Despite numerous reports, reliable p-t...

Defects in ZnO

https://www.repository.cam.ac.uk/bitstream/1810/264501/1/Fu_et_al-2017-Progress_in_Material_Science-VoR.pdf

Advances in piezoelectric thin films for acoustic biosensors, acoustofluidics and lab-on-chip applications

ZnO has attracted considerable attention for optical device applications because of several potential advantages over GaN, such as commercial availability of bulk single crystals and a larger exciton binding energy (~60 meV compared with ~25 meV for GaN). Recent improvements in the control of background conductivity of ZnO and demonstrations of p-type doping have intensified interest in this material for applications in light-emitting diodes (LEDs). In this paper, we summarize recent progress in ZnO-based LEDs. Physical and electrical properties, bandgap engineering, and growth of n- and p-type ZnO thin films are also reviewed.

Recent Advances in ZnO-Based Light-Emitting Diodes

p-Type ZnO materials: Theory, growth, properties and devices

Reproducible Sb-doped p-type ZnO films were grown on n-Si (100) by electron-cyclotron-resonance-assisted molecular-beam epitaxy. The existence of Sb in ZnO:Sb films was confirmed by low-temperature photoluminescence measurements. An acceptor-bound exciton (A°X) emission was observed at 3.358 eV at 8 K. The acceptor energy level of the Sb dopant is estimated to be 0.2 eV above the valence band. Temperature-dependent Hall measurements were performed on Sb-doped ZnO films. At room temperature, one Sb-doped ZnO sample exhibited a low resistivity of 0.2Ωcm, high hole concentration of 1.7×1018cm−3 and high mobility of 20.0cm2∕Vs. This study suggests that Sb is an excellent dopant for reliable and reproducible p-type ZnO fabrication.

/pdf/high-mobility-sb-doped-p-type-zno-by-molecular-beam-epitaxy-3rqeu09ts6.pdf

D. T. Zhao

Papers

High-mobility Sb-doped p-type ZnO by molecular-beam epitaxy