Thermoelectric materials are solid-state energy converters whose combination of thermal, electrical, and semiconducting properties allows them to be used to convert waste heat into electricity or electrical power directly into cooling and heating. These materials can be competitive with fluid-based systems, such as two-phase air-conditioning compressors or heat pumps, or used in smaller-scale applications such as in automobile seats, night-vision systems, and electrical-enclosure cooling. More widespread use of thermoelectrics requires not only improving the intrinsic energy-conversion efficiency of the materials but also implementing recent advancements in system architecture. These principles are illustrated with several proven and potential applications of thermoelectrics.

http://engin1000.pbworks.com/f/TE_rev.pdf

Cooling, heating, generating power, and recovering waste heat with thermoelectric systems.

The dimensionless thermoelectric figure of merit (ZT) in bismuth antimony telluride (BiSbTe) bulk alloys has remained around 1 for more than 50 years. We show that a peak ZT of 1.4 at 100°C can be achieved in a p-type nanocrystalline BiSbTe bulk alloy. These nanocrystalline bulk materials were made by hot pressing nanopowders that were ball-milled from crystalline ingots under inert conditions. Electrical transport measurements, coupled with microstructure studies and modeling, show that the ZT improvement is the result of low thermal conductivity caused by the increased phonon scattering by grain boundaries and defects. More importantly, ZT is about 1.2 at room temperature and 0.8 at 250°C, which makes these materials useful for cooling and power generation. Cooling devices that use these materials have produced high-temperature differences of 86°, 106°, and 119°C with hot-side temperatures set at 50°, 100°, and 150°C, respectively. This discovery sets the stage for use of a new nanocomposite approach in developing high-performance low-cost bulk thermoelectric materials.

/pdf/high-thermoelectric-performance-of-nanostructured-bismuth-4evuadx0tz.pdf

High-Thermoelectric Performance of Nanostructured Bismuth Antimony Telluride Bulk Alloys

http://absimage.aps.org/image/MAR08/MWS_MAR08-2007-001627.pdf

High Thermoelectric Performance of Nanostructured Bismuth Antimony Telluride Bulk Alloys.

Nanocrystals (NCs) discussed in this Review are tiny crystals of metals, semiconductors, and magnetic material consisting of hundreds to a few thousand atoms each. Their size ranges from 2-3 to about 20 nm. What is special about this size regime that placed NCs among the hottest research topics of the last decades? The quantum mechanical coupling * To whom correspondence should be addressed. E-mail: dvtalapin@uchicago.edu. † The University of Chicago. ‡ Argonne National Lab. Chem. Rev. 2010, 110, 389–458 389

/pdf/prospects-of-colloidal-nanocrystals-for-electronic-and-3dxpyhl3r7.pdf

Prospects of Colloidal Nanocrystals for Electronic and Optoelectronic Applications

Approximately 90 per cent of the world's power is generated by heat engines that use fossil fuel combustion as a heat source and typically operate at 30-40 per cent efficiency, such that roughly 15 terawatts of heat is lost to the environment. Thermoelectric modules could potentially convert part of this low-grade waste heat to electricity. Their efficiency depends on the thermoelectric figure of merit ZT of their material components, which is a function of the Seebeck coefficient, electrical resistivity, thermal conductivity and absolute temperature. Over the past five decades it has been challenging to increase ZT > 1, since the parameters of ZT are generally interdependent. While nanostructured thermoelectric materials can increase ZT > 1 (refs 2-4), the materials (Bi, Te, Pb, Sb, and Ag) and processes used are not often easy to scale to practically useful dimensions. Here we report the electrochemical synthesis of large-area, wafer-scale arrays of rough Si nanowires that are 20-300 nm in diameter. These nanowires have Seebeck coefficient and electrical resistivity values that are the same as doped bulk Si, but those with diameters of about 50 nm exhibit 100-fold reduction in thermal conductivity, yielding ZT = 0.6 at room temperature. For such nanowires, the lattice contribution to thermal conductivity approaches the amorphous limit for Si, which cannot be explained by current theories. Although bulk Si is a poor thermoelectric material, by greatly reducing thermal conductivity without much affecting the Seebeck coefficient and electrical resistivity, Si nanowire arrays show promise as high-performance, scalable thermoelectric materials.

Enhanced thermoelectric performance of rough silicon nanowires

We describe the first demonstration of PbTe-based, cross-plane quantum-dot superlattice (QDSL) unicouple thermoelectric generator devices fabricated from nanostructured, thick-film materials (∼100μm). Both n- and p-type QDSL materials were investigated. With ∼220K temperature difference across small thermoelements (∼95μm length, 4mm2 cross-sectional area), electrical power outputs up to 89mW and power densities up to 2.2W∕cm2 have been demonstrated for both n- and p-type materials. The devices consist of a substrate-free, bulklike slab of molecular beam epitaxy grown PbSeTe∕PbTe QDSL material as the n- or p-type leg and a copper wire as the other p-type leg.

High electrical power density from PbTe-based quantum-dot superlattice unicouple thermoelectric devices

Towards building large-scale integrated photonic systems for quantum information processing, spatial and spectral alignment of single quantum systems to photonic nanocavities is required. Here, we demonstrate spatially targeted implantation of nitrogen vacancy (NV) centers into the mode maximum of 2-d diamond photonic crystal cavities with quality factors up to 8000, achieving an average of 1.1 ± 0.2 NVs per cavity. Nearly all NV-cavity systems have significant emission intensity enhancement, reaching a cavity-fed spectrally selective intensity enhancement, Fint, of up to 93. Although spatial NV-cavity overlap is nearly guaranteed within about 40 nm, spectral tuning of the NV’s zero-phonon-line (ZPL) is still necessary after fabrication. To demonstrate spectral control, we temperature tune a cavity into an NV ZPL, yielding FintZPL~5 at cryogenic temperatures.

Scalable fabrication of coupled NV center - photonic crystal cavity systems by self-aligned N ion implantation

In this work, we present a detailed photophysical analysis of recently discovered, optically stable single-photon emitters (SPEs) in gallium nitride (GaN). Temperature-resolved photoluminescence measurements reveal that the emission lines at 4 K are three orders of magnitude broader than the transform-limited width expected from excited-state lifetime measurements. The broadening is ascribed to ultrafast spectral diffusion. The photophysical study on several emitters at room temperature (RT) reveals an average brightness of $(427\ifmmode\pm\else\textpm\fi{}215)\phantom{\rule{0.16em}{0ex}}\mathrm{kCounts}/\mathrm{s}$. Finally, polarization measurements from 14 emitters are used to determine visibility as well as dipole orientation of defect systems within the GaN crystal. Our results underpin some of the fundamental properties of SPEs in GaN both at cryogenic and RT, and define the benchmark for future work in GaN-based single-photon technologies.

Photophysics of GaN single-photon emitters in the visible spectral range

Lead-related quantum emitters in diamond

Large area samples of submicron arrays of elliptical thin Co dots were fabricated using interference lithography and ion milling. The magnetic properties were investigated by MFM and hysteresis loops were measured at different temperatures. The temperature dependence of coercivity was measured suggests that the thermal fluctuation plays an important role in the magnetization reversal mechanism.

Michael Walsh

Papers

High electrical power density from PbTe-based quantum-dot superlattice unicouple thermoelectric devices

Scalable fabrication of coupled NV center - photonic crystal cavity systems by self-aligned N ion implantation

Photophysics of GaN single-photon emitters in the visible spectral range

Lead-related quantum emitters in diamond

In-plane anisotropy in arrays of magnetic ellipses