Thermophysical Properties Research Literature Retrieval Guide Edited by Y. S. Touloukian, J. K. Gerritsen and N. Y. Moore Second edition, revised and expanded. Book 1: Pp. xxi + 819. Book 2: Pp.621. Book 3: Pp. ix + 1315. (New York: Plenum Press, 1967.) n.p.

/pdf/heat-and-mass-transfer-1yaijfx8vp.pdf

Heat and Mass Transfer

Silicon nanowire possesses great potential as the material for renewable energy harvesting and conversion. The significantly reduced spectral reflectivity of silicon nanowire to visible light makes it even more attractive in solar energy applications. However, the benefit of its use for solar thermal energy harvesting remains to be investigated and has so far not been clearly reported. The purpose of this study is to provide practical information and insight into the performance of silicon nanowires in solar thermal energy conversion systems. Spectral hemispherical reflectivity and transmissivity of the black silicon nanowire array on silicon wafer substrate were measured. It was observed that the reflectivity is lower in the visible range but higher in the infrared range compared to the plain silicon wafer. A drying experiment and a theoretical calculation were carried out to directly evaluate the effects of the trade-off between scattering properties at different wavelengths. It is clearly seen that silicon nanowires can improve the solar thermal energy harnessing. The results showed that a 17.8 % increase in the harvest and utilization of solar thermal energy could be achieved using a silicon nanowire array on silicon substrate as compared to that obtained with a plain silicon wafer.

/pdf/silicon-nanowires-for-solar-thermal-energy-harvesting-an-35qf4w71op.pdf

Silicon Nanowires for Solar Thermal Energy Harvesting: an Experimental Evaluation on the Trade-off Effects of the Spectral Optical Properties

World׳s energy demand is growing fast because of population explosion and technological advancements. It is therefore important to go for reliable, cost effective and everlasting renewable energy source for energy demand arising in future. Solar energy, among other renewable sources of energy, is a promising and freely available energy source for managing long term issues in energy crisis. Solar industry is developing steadily all over the world because of the high demand for energy while major energy source, fossil fuel, is limited and other sources are expensive. It has become a tool to develop economic status of developing countries and to sustain the lives of many underprivileged people as it is now cost effective after a long aggressive researches done to expedite its development. The solar industry would definitely be a best option for future energy demand since it is superior in terms of availability, cost effectiveness, accessibility, capacity and efficiency compared to other renewable energy sources. This paper therefore discusses about the need of solar industry with its fundamental concepts, worlds energy scenario, highlights of researches done to upgrade solar industry, its potential applications and barriers for better solar industry in future in order to resolve energy crisis.

Solar energy for future world: - A review

An overview of thermal energy storage systems

Developments in organic solid–liquid phase change materials and their applications in thermal energy storage

Flat plate photovoltaic/thermal (PV/T) solar collector produces both thermal energy and electricity simultaneously. This paper presents the state-of-the-art on flat plate PV/T collector classification, design and performance evaluation of water, air and combination of water and/or air based. This review also covers the future development of flat plate PV/T solar collector on building integrated photovoltaic (BIPV) and building integrated photovoltaic/thermal (BIPVT) applications. Different designs feature and performance of flat plate PV/T solar collectors have been compared and discussed. Future research and development (R&D) works have been elaborated. The tube and sheet design is the simplest and easiest to be manufactured, even though, the efficiency is 2% lower compared to other types of collectors such as, channel, free flow and two-absorber. It is clear from the review that for both air and water based PV/T solar collectors, the important key factors that influenced the efficiency of the system are the area where the collector covered, the number of passes and the gap between the absorber collector and solar cells. From the literature review, it is obvious that the flat plate PV/T solar collector is an alternative promising system for low-energy applications in residential, industrial and commercial buildings. Other possible areas for the future works of BIPVT are also mentioned.

Recent advances in flat plate photovoltaic/thermal (PV/T) solar collectors

Performance analysis of photovoltaic thermal (PVT) water collectors

Drying for agricultural and marine products are one of the most attractive and cost-effective application of solar energy. Numerous types of solar dryers have been designed and developed in various parts of the world, yielding varying degrees of technical performance. Basically, there are four types of solar dryers; (1) direct solar dryers, (2) indirect solar dryers, (3) mixed-mode dryers and (4) hybrid solar dryers. This paper is a review of these types of solar dryers with aspect to the product being dried, technical and economical aspects. The technical directions in the development of solar-assisted drying systems for agricultural produce are compact collector design, high efficiency, integrated storage, and long-life drying system. Air-based solar collectors are not the only available systems. Water-based collectors can also be used whereby water to air heat exchanger can be used. The hot air for drying of agricultural produce can be forced to flow in the water to air heat exchanger. The hot water tank acts as heat storage of the solar drying system.

Review of solar dryers for agricultural and marine products

Evaluation of the nanofluid and nano-PCM based photovoltaic thermal (PVT) system: An experimental study

Heating and domestic hot water (DHW) systems account for 75% of energy consumption in residential, commercial, and industrial sectors. Furthermore, thermal energy storage strongly reduces energy consumption. Storage devices of thermal energy from phase change material (PCM) are essential in solar thermal and waste heat energy technologies that match energy supply to demand and enhance their thermal performance. The storage of PCM thermal energy is more beneficial than sensible energy storage because of its high density of storage energy per unit volume/mass. This review presents previous works on thermal energy storage as applied to DHW and heating systems. PCM has been used in different parts of heating networks and DHW systems, including solar collectors, storage tanks, packed beds, and duct networks. Researchers have also investigated the application of PCM in heating and DHW systems to reduce greenhouse gas emission and electrical power consumption. Hence, PCM thermal energy storage is expected to lower cost and the volumes of heating and DHW systems.

Mohd Hafidz Ruslan

Papers

Recent advances in flat plate photovoltaic/thermal (PV/T) solar collectors

Performance analysis of photovoltaic thermal (PVT) water collectors

Review of solar dryers for agricultural and marine products

Evaluation of the nanofluid and nano-PCM based photovoltaic thermal (PVT) system: An experimental study

Review of the application of phase change material for heating and domestic hot water systems