A review of the geologic history of the Himalayan-Tibetan orogen suggests that at least 1400 km of north-south shortening has been absorbed by the orogen since the onset of the Indo-Asian collision at about 70 Ma. Significant crustal shortening, which leads to eventual construction of the Cenozoic Tibetan plateau, began more or less synchronously in the Eocene (50–40 Ma) in the Tethyan Himalaya in the south, and in the Kunlun Shan and the Qilian Shan some 1000–1400 km in the north. The Paleozoic and Mesozoic tectonic histories in the Himalayan-Tibetan orogen exerted a strong control over the Cenozoic strain history and strain distribution. The presence of widespread Triassic flysch complex in the Songpan-Ganzi-Hoh Xil and the Qiangtang terranes can be spatially correlated with Cenozoic volcanism and thrusting in central Tibet. The marked difference in seismic properties of the crust and the upper mantle between southern and central Tibet is a manifestation of both Mesozoic and Cenozoic tectonics. The form...

Geologic Evolution of the Himalayan-Tibetan Orogen

This geochemical classification of granitic rocks is based upon three INTRODUCTION variables. These are FeO/(FeO + MgO) = Fe-number [or Although granitoids are the most abundant rock types FeO/(FeO + MgO) = Fe∗], the modified alkali–lime index in the continental crust, no single classification scheme (MALI) (Na2O + K2O – CaO) and the aluminum saturation has achieved widespread use. Part of the problem in index (ASI) [Al/(Ca – 1·67P + Na + K)]. The Fe-number granite classification is that the same mineral assemblage, (or Fe∗) distinguishes ferroan granitoids, which manifest strong iron quartz and feldspars with a variety of ferromagnesian enrichment, from magnesian granitoids, which do not. The ferroan minerals, can be achieved by a number of processes. and magnesian granitoids can further be classified into alkalic, Granitoids can form from differentiation of any hyalkali–calcic, calc-alkalic, and calcic on the basis of the MALI persthene-normative melt and from partial melting of and subdivided on the basis of the ASI into peraluminous, metamany rock types. Furthermore, granitic melts may be luminous or peralkaline. Because alkalic rocks are not likely to be derived solely from crustal components, may form from peraluminous and calcic and calc-alkalic rocks are not likely to be evolved mantle-derived melts, or may be a mixture peralkaline, this classification leads to 16 possible groups of granitic of crustal and mantle-derived melts. Because of this rocks. In this classification most Cordilleran granitoids are magnesian complexity, petrologists have relied upon geochemical and calc-alkalic or calcic; both metaluminous and peraluminous classifications to distinguish between various types of types are present. A-type granitoids are ferroan alkali–calcic, although granitoids. Approximately 20 different schemes have evolved over the past 30 years [see Barbarin (1990, 1999) some are ferroan alkalic. Most are metaluminous although some are for a summary thereof]. Most of these schemes are either peraluminous. Caledonian post-orogenic granites are predominantly genetic or tectonic in nature. This paper is an attempt magnesian alkali–calcic. Those with <70 wt % SiO2 are domto present a non-genetic, non-tectonic geochemical clasinantly metaluminous, whereas more silica-rich varieties are comsification scheme that incorporates the best qualities of monly peraluminous. Peraluminous leucogranites may be either the previous schemes, and to explain the petrologic magnesian or ferroan and have a MALI that ranges from calcic to processes that makes this scheme work. alkalic.

/pdf/a-geochemical-classification-for-granitic-rocks-j2go5p9d9i.pdf

A geochemical classification for granitic rocks

Two end member models of how the high elevations in Tibet formed are (i) continuous thickening and widespread viscous flow of the crust and mantle of the entire plateau and (ii) time-dependent, localized shear between coherent lithospheric blocks. Recent studies of Cenozoic deformation, magmatism, and seismic structure lend support to the latter. Since India collided with Asia ∼55 million years ago, the rise of the high Tibetan plateau likely occurred in three main steps, by successive growth and uplift of 300- to 500-kilometer-wide crustal thrust-wedges. The crust thickened, while the mantle, decoupled beneath gently dipping shear zones, did not. Sediment infilling, bathtub-like, of dammed intermontane basins formed flat high plains at each step. The existence of magmatic belts younging northward implies that slabs of Asian mantle subducted one after another under ranges north of the Himalayas. Subduction was oblique and accompanied by extrusion along the left lateral strike-slip faults that slice Tibet's east side. These mechanisms, akin to plate tectonics hidden by thickening crust, with slip-partitioning, account for the dominant growth of the Tibet Plateau toward the east and northeast.

http://science.sciencemag.org/content/sci/294/5547/1671.full.pdf

Oblique Stepwise Rise and Growth of the Tibet Plateau

Convective removal of lower lithosphere beneath the Tibetan Plateau can account for a rapid increase in the mean elevation of the Tibetan Plateau of 1000 m or more in a few million years. Such uplift seems to be required by abrupt tectonic and environmental changes in Asia and the Indian Ocean in late Cenozoic time. The composition of basaltic volcanism in northern Tibet, which apparently began at about 13 Ma, implies melting of lithosphere, not asthenosphere. The most plausible mechanism for rapid heat transfer to the midlithosphere is by convective removal of deeper lithosphere and its replacement by hotter asthenosphere. The initiation of normal faulting in Tibet at about 8 (± 3) Ma suggests that the plateau underwent an appreciable increase in elevation at that time. An increase due solely to the isostatic response to crustal thickening caused by India's penetration into Eurasia should have been slow and could not have triggered normal faulting. Another process, such as removal of relatively cold, dense lower lithosphere, must have caused a supplemental uplift of the surface. Folding and faulting of the Indo-Australian plate south of India, the most prominent oceanic intraplate deformation on Earth, began between about 7.5 and 8 Ma and indicates an increased north-south compressional stress within the Indo-Australian plate. A Tibetan uplift of only 1000 m, if the result of removal of lower lithosphere, should have increased the compressional stress that the plateau applies to India and that resists India's northward movement, from an amount too small to fold oceanic lithosphere, to one sufficient to do so. The climate of the equatorial Indian Ocean and southern Asia changed at about 6–9 Ma: monsoonal winds apparently strengthened, northern Pakistan became more arid, but weathering of rock in the eastern Himalaya apparently increased. Because of its high altitude and lateral extent, the Tibetan Plateau provides a heat source at midlatitudes that should oppose classical (symmetric) Hadley circulation between the equator and temperate latitudes and that should help to drive an essentially opposite circulation characteristic of summer monsoons. For the simple case of axisymmetric heating (no dependence on longitude) of an atmosphere without dissipation, theoretical analyses by Hou, Lindzen, and Plumb show that an axisymmetric heat source displaced from the equator can drive a much stronger meridianal (monsoonlike) circulation than such a source centered on the equator, but only if heating exceeds a threshold whose level increases with the latitude of the heat source. Because heating of the atmosphere over Tibet should increase monotonically with elevation of the plateau, a modest uplift (1000–2500 m) of Tibet, already of substantial extent and height, might have been sufficient to exceed a threshold necessary for a strong monsoon. The virtual simultaneity of these phenomena suggests that uplift was rapid: approximately 1000 m to 2500 m in a few million years. Moreover, nearly simultaneously with the late Miocene strengthening of the monsoon, the calcite compensation depth in the oceans dropped, plants using the relatively efficient C4 pathway for photosynthesis evolved rapidly, and atmospheric CO2 seems to have decreased, suggesting causal relationships and positive feedbacks among these phenomena. Both a supplemental uplift of the Himalaya, the southern edge of Tibet, and a strengthened monsoon may have accelerated erosion and weathering of silicate rock in the Himalaya that, in turn, enhanced extraction of CO2 from the atmosphere. Thus these correlations offer some support for links between plateau uplift, a downdrawing of CO2 from the atmosphere, and global climate change, as proposed by Raymo, Ruddiman, and Froehlich. Mantle dynamics beneath mountain belts not only may profoundly affect tectonic processes near and far from the belts, but might also play an important role in altering regional and global climates.

Mantle dynamics, uplift of the Tibetan Plateau, and the Indian Monsoon

/pdf/tibetan-tectonic-evolution-inferred-from-spatial-and-1f7oxv9x3m.pdf

Tibetan tectonic evolution inferred from spatial and temporal variations in post-collisional magmatism

Tectonics of Western Tibet, between the Tarim and the Indus

The high K2O volcanism of northwestern Tibet: Geochemistry and tectonic implications

HP rocks (eclogites and granulites) occur in the upper unit of the western Iberian allochthonous complexes in Spain and Portugal. This HP metamorphism was considered as Early Variscan or Ordovician in Spain and Precambrian in Portugal. We have dated eclogites retrogressed into granulites in the Braganca massif in NE Portugal by U–Pb on rutile and zircon. The upper intercept of the discordia gives 390±4 Ma that we consider as the age of the HP/HT metamorphism.

Early Variscan HP metamorphism in the western Iberian Allochthon—A 390 Ma U–Pb age for the Bragança eclogite (NW Portugal)

Decollements are conspicuous features of collision belts as a result of shortening and shearing of rocks of different competencies in response to intracontinental subduction and crustal stacking. When these decollements occur at upper levels, the classical thin skin tectonics of the foredeeps without important internal strain results; at mid crustal levels slaty cleavage and foliation development occurs. In the more internal parts of the chains, in the lower crust, near the crust mantle boundary, the more severe conditions (granulitic metamorphism) result in ductile deformation in the deepest parts of the mountain belts. Examples of middle and lower crust are well documented in Central China and the Variscan Belt of Europe from field evidence and deep seismic profiling. From these examples it appears more and more likely that most of the mid-crustal slate belts showing vertical slaty cleavage at the erosion surface overly flat decollements. At greater depth large decollements must occur as well in the lower continental crust and at crust-mantle boundary. Typical features of the deep seismic vertical profiles such as the strongly layered lower crust may represent the image of such deep decollements.

Ph. Matte

Papers

Tectonics of Western Tibet, between the Tarim and the Indus

The high K2O volcanism of northwestern Tibet: Geochemistry and tectonic implications

Early Variscan HP metamorphism in the western Iberian Allochthon—A 390 Ma U–Pb age for the Bragança eclogite (NW Portugal)

Decollements in slate belts, examples from the European variscides and the Qin Ling Belt of Central China

Teleseismic tomography across the middle Urals: lithospheric trace of an ancient continental collision