抗原变异可使得多种致病微生物易于逃避宿主免疫应答。表达在感染红细胞表面的恶性疟原虫红细胞表面蛋白1（PfPMP1）与感染红细胞、内皮细胞、树突状细胞以及胎盘的单个或多个受体作用，在黏附及免疫逃避中起关键的作用。每个单倍体基因组var基因家族编码约60种成员，通过启动转录不同的var基因变异体为抗原变异提供了分子基础。

疟原虫var基因转换速率变化导致抗原变异[英]／Paul H, Robert P, Christodoulou Z, et al//Proc Natl Acad Sci U S A

Many potential applications have been proposed for carbon nanotubes, including conductive and high-strength composites; energy storage and energy conversion devices; sensors; field emission displays and radiation sources; hydrogen storage media; and nanometer-sized semiconductor devices, probes, and interconnects. Some of these applications are now realized in products. Others are demonstrated in early to advanced devices, and one, hydrogen storage, is clouded by controversy. Nanotube cost, polydispersity in nanotube type, and limitations in processing and assembly methods are important barriers for some applications of single-walled nanotubes.

http://science.sciencemag.org/content/sci/297/5582/787.full.pdf

Carbon Nanotubes--the Route Toward Applications

The interest in nanoscale materials stems from the fact that new properties are acquired at this length scale and, equally important, that these properties * To whom correspondence should be addressed. Phone, 404-8940292; fax, 404-894-0294; e-mail, mostafa.el-sayed@ chemistry.gatech.edu. † Case Western Reserve UniversitysMillis 2258. ‡ Phone, 216-368-5918; fax, 216-368-3006; e-mail, burda@case.edu. § Georgia Institute of Technology. 1025 Chem. Rev. 2005, 105, 1025−1102

Chemistry and properties of nanocrystals of different shapes.

Thermoelectric materials are of interest for applications as heat pumps and power generators. The performance of thermoelectric devices is quantified by a figure of merit, ZT, where Z is a measure of a material's thermoelectric properties and T is the absolute temperature. A material with a figure of merit of around unity was first reported over four decades ago, but since then-despite investigation of various approaches-there has been only modest progress in finding materials with enhanced ZT values at room temperature. Here we report thin-film thermoelectric materials that demonstrate a significant enhancement in ZT at 300 K, compared to state-of-the-art bulk Bi2Te3 alloys. This amounts to a maximum observed factor of approximately 2.4 for our p-type Bi2Te3/Sb2Te3 superlattice devices. The enhancement is achieved by controlling the transport of phonons and electrons in the superlattices. Preliminary devices exhibit significant cooling (32 K at around room temperature) and the potential to pump a heat flux of up to 700 W cm-2; the localized cooling and heating occurs some 23,000 times faster than in bulk devices. We anticipate that the combination of performance, power density and speed achieved in these materials will lead to diverse technological applications: for example, in thermochemistry-on-a-chip, DNA microarrays, fibre-optic switches and microelectrothermal systems.

Thin-film thermoelectric devices with high room-temperature figures of merit

"Space—the final frontier." This preamble to a well-known television series captures the challenge encountered not only in space travel adventures, but also in the field of porous materials, which aims to control the size, shape and uniformity of the porous space and the atoms and molecules that define it. The past decade has seen significant advances in the ability to fabricate new porous solids with ordered structures from a wide range of different materials. This has resulted in materials with unusual properties and broadened their application range beyond the traditional use as catalysts and adsorbents. In fact, porous materials now seem set to contribute to developments in areas ranging from microelectronics to medical diagnosis.

Ordered porous materials for emerging applications

We have fabricated sonic crystals, based on the idea of localized resonant structures, that exhibit spectral gaps with a lattice constant two orders of magnitude smaller than the relevant wavelength. Disordered composites made from such localized resonant structures behave as a material with effective negative elastic constants and a total wave reflector within certain tunable sonic frequency ranges. A 2-centimeter slab of this composite material is shown to break the conventional mass-density law of sound transmission by one or more orders of magnitude at 400 hertz.

http://science.sciencemag.org/content/sci/289/5485/1734.full.pdf

Locally Resonant Sonic Materials

Quantum and Classical Waves.- Wave Scattering and the Coherent Potential Approximation.- Coherent Waves and Effective Media.- Diffusive Waves.- The Coherent Backscattering Effect.- Renormalized Diffusion.- The Scaling Theory of Localization.- Localized States and the Approach to Localization.- Localization Phenomena in Electronic Systems.- Mesoscopic Phenomena.

/pdf/introduction-to-wave-scattering-localization-and-mesoscopic-1m0cjsa5lb.pdf

Introduction to Wave Scattering, Localization, and Mesoscopic Phenomena

Granular metal films (50–200,000 A thick) were prepared by co-sputtering metals (Ni, Pt, Au) and insulators (SiO2, Al2O3), where the volume fraction of metal, x, was varied from x = 1 to x = 0.05. The materials were characterized by electron micrography, electron and X-ray diffraction, and measurements of composition, density and electrical resistivity at electric fields e up to 106 V/cm and temperatures T in the range of 1.3 to 291 K. In the metallic regime (isolated insulator particles in a metal continuum) and in the transition regime (metal and insulator particles in a metal continuum) and in the transition regime (metal and insulator labyrinth structure) the conduction is due to percolation with a percolation threshold at x⋍0.5. Tunnelling measurements on superconductor-insulator-granular metal junctions reveals that the transition from the metallic regime to the dielectric regime (10–50 A size isolated metal particles in an insulator continuum) is associated with the breaking up of a metal ...

Structural and electrical properties of granular metal films

Transformation optics describes the capability to design the path of light waves almost at will through the use of metamaterials that control effective materials properties on a subwavelength scale. In this review, the physics and applications of transformation optics are discussed.

Transformation optics and metamaterials

Within a time span of 15 years, acoustic metamaterials have emerged from academic curiosity to become an active field driven by scientific discoveries and diverse application potentials. This review traces the development of acoustic metamaterials from the initial findings of mass density and bulk modulus frequency dispersions in locally resonant structures to the diverse functionalities afforded by the perspective of negative constitutive parameter values, and their implications for acoustic wave behaviors. We survey the more recent developments, which include compact phase manipulation structures, superabsorption, and actively controllable metamaterials as well as the new directions on acoustic wave transport in moving fluid, elastic, and mechanical metamaterials, graphene-inspired metamaterials, and structures whose characteristics are best delineated by non-Hermitian Hamiltonians. Many of the novel acoustic metamaterial structures have transcended the original definition of metamaterials as arising from the collective manifestations of constituent resonating units, but they continue to extend wave manipulation functionalities beyond those found in nature.

/pdf/acoustic-metamaterials-from-local-resonances-to-broad-4s4297ihw6.pdf

Ping Sheng

Papers

Locally Resonant Sonic Materials

Introduction to Wave Scattering, Localization, and Mesoscopic Phenomena

Structural and electrical properties of granular metal films

Transformation optics and metamaterials

Acoustic metamaterials: From local resonances to broad horizons.