Showing papers in "Journal of Colloid and Interface Science in 2022"

TL;DR: In this paper, tetra (4-carboxyphenyl) porphyrin (TCPP) was loaded onto the surface of Bi2MoO6 microspheres to gain hierarchical organic-inorganic TCPP/BMO heterojunctions via a facile impregnation strategy.

TL;DR: In this article , tetra (4-carboxyphenyl) porphyrin (TCPP) was loaded onto the surface of Bi2MoO6 microspheres to gain hierarchical organic-inorganic TCPP/BMO heterojunctions via a facile impregnation strategy.

TL;DR: In this paper, a new and effective strategy was proposed to develop high efficiency microwave absorbers with ultra-lightweight, wide-band, thin thickness and strong absorption capabilities, benefiting from the excellent synergistic effect between RGOF and reduced graphene oxide foam (RGOF)/MoS2.

TL;DR: In this article , a step-scheme heterojunction of OVs mediated Bi2MoO6/C3N5 was fabricated by in-situ growing Bi2MO6 nanoparticles with OVs on C3N 5 nanosheets.

TL;DR: In this paper, a hybrid nanocomposite (FeCo/FeCoP@NMn-CNS-800) was constructed by one-step pyrolysis of the metal precursors and polyinosinic acid.

TL;DR: In this paper , tetra (4-carboxyphenyl) porphyrin (TCPP) and graphene quantum dots (GQDs) were loaded on the surface of Bi2MoO6 (BMO) to fabricate novel Z-scheme heterojunctions of TCPP/G/BMO.

TL;DR: In this paper , the authors proposed a new and effective strategy to develop high efficiency microwave absorbers with ultra-lightweight, wide-band, thin thickness and strong absorption capabilities.

TL;DR: In this paper, the Ni@Co/C@polypyrrole (PPy) composites integrating the advantages of component and microstructure were fabricated, which effectively optimized the impedance matching and improved the EM attenuation.

TL;DR: In this article, Fe,Rh-codoped Ni2P nanosheets arrays were in situ anchored on three-dimensional (3D) Ni foam under hydrothermal condition and successive phosphorization.

TL;DR: The FeCo/FeCoP@NMn-CNS-800-assembled rechargeable Zn-air battery presented an open-circuit voltage of 1.522 V (vs. RHE), a peak power density of 135.0 mW cm-2, and long-term durability by charge-discharge cycling for 200 h, surpassing commercial Pt/C + RuO2 based counterpart as mentioned in this paper .

TL;DR: In this paper , the Ni@Co/C@polypyrrole (PPy) composites integrating the advantages of component and microstructure were fabricated, and the addition of Co/C and PPy effectively optimized the impedance matching and improved the EM attenuation.

TL;DR: In this paper , an integrative S-scheme heterojunction photocatalyst building from Cd0.5S nanoparticles and BiOCl microflowers with oxygen vacancies (OVs) was developed.

TL;DR: In this paper , Fe,Rh-codoped Ni2P nanosheets arrays were in situ anchored on three-dimensional (3D) Ni foam under hydrothermal condition and successive phosphorization.

TL;DR: In this article, a 3D hierarchical hollow tubular g-C3N4/ZnIn2S4 nanosheets (HTCN/ZIS) type-Ⅱ heterojunction photocatalyst was successfully prepared and applied for photocatalytic hydrogen production under visible light irradiation.

TL;DR: In this paper , a 3D hierarchical hollow tubular g-C3N4/ZnIn2S4 nanosheets (HTCN/ZIS) type-Ⅱ heterojunction photocatalyst was successfully prepared and applied for photocatalytic hydrogen production under visible light irradiation.

TL;DR: In this article , a polyethersulfone (PES) membrane matrix was firstly coated by magnetic Ni via an in-situ reduction reaction, and then incorporated into a PES-Ni@UiO-66 membrane.

TL;DR: In this paper , Ni3Se4@CoSe2@C/CNTs electrode was used as anode material of a sodium ion battery (SIB) with excellent rate capability of 206 mA h g-1 at 3 A g 1 and marvelous cyclic stability with capacity retention of 243 mAh g 1 after 600 cycles at 1 A g -1.

TL;DR: In this paper , Co9S8 nanoclusters implanted in Co/Mn-S,N multi-doped porous carbon are fabricated with the mixture (i.e., Eriochrome black T (EBT), metal precursors and dicyandiamide) by a coordination regulated pyrolysis strategy.

TL;DR: In this article, Co9S8 nanoclusters implanted in Co/Mn-S,S,N multi-doped porous carbon are fabricated with the mixture of Eriochrome black T (EBT), metal precursors and dicyandiamide by a coordination regulated pyrolysis strategy.

TL;DR: In this article , a transitional bimetal-based carbon catalysts for oxygen reduction reaction (ORR) in alkaline fuel cells was proposed. But the performance of the proposed catalysts was not as good as commercial Pt/C (50 wt%) in a 0.1 M KOH solution, with a limiting current density as high as -5.54 mA cm-2.

TL;DR: In this paper, ultrathin rhodium-iridium nanosheets were facilely grown on nickel foam (RhIr NSs/NF) by a one-pot aqueous strategy at room temperature.

TL;DR: In this article , a metal-free boron nitride quantum dots (BNQDs) and graphitic carbon nitride (C3N4) heterostructure was designed as an effective and durable NRR catalyst.

TL;DR: In this paper, a metal-free boron nitride quantum dots (BNQDs) and graphitic carbon nitride (C3N4) heterostructure was designed as an effective and durable NRR catalyst.

TL;DR: In this paper , ultrathin rhodium-iridium nanosheets were facilely grown on nickel foam (RhIr NSs/NF) by a one-pot aqueous strategy at room temperature.

TL;DR: In this article , a plum-like NiCo@C composite was successfully prepared by simple solvothermal method and carbonization treatment, which displays strong absorption (-55.4 dB) and wide effective absorption band (EAB, 7.2 GHz) when the loading is 20 wt%.

TL;DR: In this article , an effective strategy for obtaining WSe2@CNTs nanohybrids is reported, which can be tailored by confinedly implanting WSe 2 nanosheets on multi-walled carbon nanotubes.

TL;DR: In this article , the authors synthesized ultrafine FeNi/(FeNi)9S8 nanoclusters encapsulated in nitrogen, sulfur-codoped graphitic carbon nanosheets by coordination regulated pyrolyzing the mixture of the metal precursors, dithizone and g-C3N4.

TL;DR: In this article, MgFe2O4/MgO/C fibers were successfully prepared via electrospinning technology and carbonization, and their surfaces were coated by MoS2 via hydrothermal method.

TL;DR: In this article , the anti-corrosion efficiency of DDD and DTDD were as high as 99.6% and 98.9%, respectively, in 0.5 mol/L H2SO4 media.

TL;DR: In this article , the Nb2C MXene-derived ternary photocatalyst was synthesized via one-pot in-situ hydrothermal method for photocatalytic hydrogen (H2) evolution.