Journal ArticleDOI
Corrosion protective performances of commercial low-VOC epoxy/urethane coatings on hot-rolled 1010 mild steel
E Potvin,L Brossard,G Larochelle +2 more
Reads0
Chats0
TLDR
In this article, the protection properties of low-VOC epoxy/urethane paint systems of commercial grade were investigated using a variety of techniques such as electrochemical impedance spectroscopy (EIS).About:
This article is published in Progress in Organic Coatings.The article was published on 1997-08-01. It has received 86 citations till now. The article focuses on the topics: Epoxy & Corrosion.read more
Citations
More filters
Journal ArticleDOI
Enhancement of barrier and corrosion protection performance of an epoxy coating through wet transfer of amino functionalized graphene oxide
TL;DR: An amino functionalized graphene oxide (FGO) was synthesized and characterized by Fourier transform infrared spectroscopy (FTIR) and X-Ray diffraction analysis (XRD) as mentioned in this paper.
Journal ArticleDOI
Covalently-grafted graphene oxide nanosheets to improve barrier and corrosion protection properties of polyurethane coatings
TL;DR: In this paper, surface modification of graphene oxide (GO) has been performed by grafting of polyisocyanate (PI) resin, and the PI functionalized GO sheets were incorporated into the polyurethane (PU) matrix.
Journal ArticleDOI
Study on corrosion electrochemical behavior of several different coating systems by EIS
TL;DR: In this paper, the electrochemical impedance spectroscopy (EIS) of chlorinated rubber top coating (single layer), inorganic zinc-rich primer/chlorinated rubber-top-coating (double-layer), and tri-layer (tri-layer) in 3.5-wt% NaCl solution was studied by EIS and a series of impedance spectra of the three coating systems during immersion were measured.
Journal ArticleDOI
Studying the influence of nano-Al2O3 particles on the corrosion performance and hydrolytic degradation resistance of an epoxy/polyamide coating on AA-1050
TL;DR: In this article, the effects of the addition of Al2O3 nanoparticles on the anticorrosion performance of an epoxy/polyamide coating applied on the AA-1050 metal substrate were studied.
Journal ArticleDOI
Influence of nanoclay particles modification by polyester-amide hyperbranched polymer on the corrosion protective performance of the epoxy nanocomposite
TL;DR: In this article, surface modification of nanoclay particles by various amounts of polyester-amide hyperbranched polymer (HBP) was carried out to estimate the efficiency of the HPB grafting on the clay particles.
References
More filters
Book
CRC Handbook of Chemistry and Physics
TL;DR: CRC handbook of chemistry and physics, CRC Handbook of Chemistry and Physics, CRC handbook as discussed by the authors, CRC Handbook for Chemistry and Physiology, CRC Handbook for Physics,
Journal ArticleDOI
The analysis of electrode impedances complicated by the presence of a constant phase element
TL;DR: In this article, it was shown that the electrical double-layer at a solid electrode does not in general behave as a pure capacitance but rather as an impedance displaying a frequency-independent phase angle different from 90°.
Journal ArticleDOI
A review of impedance plot methods used for corrosion performance analysis of painted metals
TL;DR: In this article, a small library of Bode and Nyquist plot shapes is presented, based on increasingly more complex equivalent electrical circuit models, along with methods for obtaining equivalent circuit component values.
Journal ArticleDOI
Electrical measurements in the study of immersed paint coatings on metal. I. Comparison between capacitance and gravimetric methods of estimating water-uptake
D. M. Brasher,A. H. Kingsbury +1 more
TL;DR: The capacitance method can be used for routine testing of the water-uptake of paints only on a type of paint known to give good agreement between the two methods; where applicable, it has decided advantages over gravimetric methods as discussed by the authors.
Journal ArticleDOI
Evaluation of Corrosion Behavior of Coated Metals with AC Impedance Measurements
TL;DR: In this article, the AC impedance measurements have been performed in 0.5 N NaCl for coated steel and aluminum alloys which had been subjected to different surface treatment procedures, including different surface treatments.
Related Papers (5)
Application of electrochemical impedance spectroscopy to study the degradation of polymer-coated metals
A. Amirudin,D. Thieny +1 more