Effects of Strain Rate, Applied Potential and Temperature on the Stress-Corrosion Cracking of 304L Stainless Steel in 5 mol/l H2SO4/0.1 mol/l NaCl Solution
Reads0
Chats0
About:
This article is published in Materials Transactions Jim.The article was published on 1978-01-01 and is currently open access. It has received 11 citations till now. The article focuses on the topics: Stress corrosion cracking & Strain rate.read more
Citations
More filters
Journal ArticleDOI
Effect of ferrite transformation on the tensile and stress corrosion properties of type 316 L stainless steel weld metal thermally aged at 873 K
TL;DR: In this article, the effect of microstructural changes, due to transformation of delta ferrite, on the associated variations that take place in the tensile and stress corrosion properties of type 316 L stainless steel weld deposits when subjected to postweld heat treatment at 873 K for prolonged periods (up to 2000 hours).
Book ChapterDOI
Corrosion of Copper and its Alloys
TL;DR: In this paper, the behavior of copper and its alloys in the various corrosive environments commonly experienced in service: atmospheric corrosion, soil corrosion, corrosion in fresh water and industrial chemicals.
Journal ArticleDOI
Studies on the influence of metallurgical variables on the stress corrosion behavior of AISI 304 stainless steel in sodium chloride solution using the fracture mechanics approach
TL;DR: In this article, a nuclear grade AISI type 304 stainless steel in a boiling solution of 5M NaCl+ 0.15M Na2SO4+ 3 mL/L HC1 (bp 381 K) was presented.
Journal ArticleDOI
Effect of cold work on stress corrosion cracking behavior of types 304 and 316 stainless steels
TL;DR: In this article, the influence of cold work in the range 2.3 to 56 pct on stress corrosion cracking (SCC) properties of 304 and 316 stainless steels in boiling MgCl2 solution at 154 °C was investigated using a constant load method.
Journal ArticleDOI
Stress corrosion cracking of weldments of AISI Type 316 stainless steel
TL;DR: In this article, the weldments of AISI Type 316 stainless steel prepared by the tungsten inert gas (TIG) and manual metal arc (MMA) welding processes, were tested in a boiling solution of 5 M NaCl + 0.15 M Na2SO4 (pH = 1.3) at an initial stress level of 200 MPa under the open circuit potential (OCP) and the impressed potential (IP) conditions using the constant load technique.
References
More filters
Journal ArticleDOI
Temperature Coefficient of Corrosion Inhibition
Olen L. Riggs,Ray M. Hurd +1 more
TL;DR: In this paper, a comparison of activation energies of uninhibited and inhibited corrosion reactions was obtained, and it was shown that the inhibition of steel corrosion in mineral acids by simple amines follows the Langmuir adsorption isotherm over a wide concentration range (10−5 to 10−2 M).
Journal ArticleDOI
The Influence of Iodide Ions and Carbon Monoxide on the Anodic Dissolution of Active Iron
K. E. Heusler,G. H. Cartledge +1 more
TL;DR: In this paper, the authors investigated the kinetics of the dissolution of iron in sulfuric acid by polarization measurements in the presence of iodide ions or carbon monoxide as an inhibitor.
Journal ArticleDOI
Der einfluss von halogenidionen auf die anodische auflösung des eisens
TL;DR: In this article, anodische Auflosung von reinem Eisen in schwefelsaurer Losung and in Gegenwart von Halogenidionen wurde durch galvanostatische Messungen der stationaren Stromdichtepotentialkurven untersucht.
Journal ArticleDOI
Stress-corrosion cracking of mild steels in sodium hydroxide solutions containing various additional substances
M.J. Humphries,R.N. Parkins +1 more
TL;DR: The only substances that have been found in the present work to have a truly inhibitive effect are valonea and quebracho tannins and NaH 2 PO 4, although Na 2 SiO 3 appears to confer partial inhibition.
Journal ArticleDOI
Stress—corrosion cracking of austenitic stainless steel in hydrochloric acid media at room temperature
G. Bianchi,F. Mazza,S. Torchio +2 more
TL;DR: In this article, it has been shown that at higher HCl concentrations, corrosion rates increase and uneven, general corrosion occurs instead of cracking, and the development of pitting and stress corrosion cracking under active conditions precludes the conclusion that active-passive cells always play a role in localized corrosion and, in particular, in stress-corrosion cracking.
Related Papers (5)
Effect of Strain Rate on Stress Corrosion Cracking of Austenitic Stainless Steel in MgCl2 Solutions
Effect of Electrochemical Potential on Stress-Corrosion Morphology of Type 304L Stainless Steel in H 2 SO 4 /NaCl Solutions at Room Temperature
Stress corrosion cracking of 304L stainless steel in molten salts media
H. Atmani,J.J. Rameau +1 more