Journal ArticleDOI
Electrical Properties of Conducting Polymer, Poly-Thiophene, Prepared by Electrochemical Polymerization
TLDR
In this article, a polythiophene perchlorate was prepared electrochemically in an electrolyte of 0.5 M AgClO4 and 0.2 M thiophene in acetonitrile.Abstract:
Poly-thiophene perchlorate is prepared electrochemically in an electrolyte of 0.5 M AgClO4 and 0.2 M thiophene in acetonitrile. Dark greenish film with the complex of ca. [C4H2S(ClO4)0.26]x is obtained. The electrical conductivity along the film surface is about 0.6 Ω-1cm-1.read more
Citations
More filters
Journal ArticleDOI
Improvement of the Electrosynthesis and Physicochemical Properties of Poly(3,4-ethylenedioxythiophene) Using a Sodium Dodecyl Sulfate Micellar Aqueous Medium
N. Sakmeche,Salah Aeiyach,Jean-Jacques Aaron,Mohamed Jouini,Jean Christophe Lacroix,Pierre-Camille Lacaze +5 more
TL;DR: In this article, a micellar aqueous solution containing sodium dodecyl sulfate (SDS) was used for the synthesis of poly(3,4-ethylenedioxythiophene) (PEDOT) films.
Journal ArticleDOI
Raman spectra of polypyrrole and its 2,5-13C-substituted and C-deuterated analogues in doped and undoped states
Journal ArticleDOI
Activated Ester Containing Polymers: Opportunities and Challenges for the Design of Functional Macromolecules
Anindita Das,Patrick Theato +1 more
Journal ArticleDOI
Synthesis of well‐defined polymeric activated esters
TL;DR: In this paper, two different research areas of activated esters in polymer science are discussed: (i) the preparation of defined reactive polymer architectures by controlled polymerization techniques and (ii) the prepared reactive thin films.
Journal ArticleDOI
Dependences of electrical and mechanical properties of conducting polypyrrole films on conditions of electrochemical polymerization in an aqueous medium
TL;DR: In this paper, the electrical and mechanical properties of polypyrrole films under various polymerization conditions were studied and the electrical conductivity was found to be increased to higher than 500 S/cm by selecting the polymerization condition.