Journal ArticleDOI
Fabric bending behaviour testing instrument for technical textiles
TLDR
In this article, a low cost mechanized and computerised system was developed to study complete behaviour of bending specially for technical textiles, which can measure dynamic bending behaviour by graphical bending load-deflection, cyclic bending, bending stress relaxation.About:
This article is published in Measurement.The article was published on 2016-06-01. It has received 16 citations till now. The article focuses on the topics: Bending & Flexural rigidity.read more
Citations
More filters
Journal ArticleDOI
Preparation of fluorescent pigment latex and its application on binder‐free printing of cotton fabrics
TL;DR: In this paper, fluorescent pigment latex (FPL) was prepared via mini-emulsion polymerization and further applied on cotton fabric printing in the absence of binder, which resulted in better hand feel and rubbing fastness.
Journal ArticleDOI
Development of sunnhemp (Crotalaria juncea) fibre based unconventional fabric
Surajit Sengupta,Sanjoy Debnath +1 more
TL;DR: In this paper, an attempt has been made to explore the possibility of production of unspinnable sunnhemp based unconventional fabric (needle punched nonwoven) for value addition and diversified uses.
Journal ArticleDOI
Development of Unconventional Fabric from Banana (Musa Acuminata) Fibre for Industrial Uses
TL;DR: An attempt has been made to explore the possibility of production of needle-punched nonwoven from fibrous material of biowaste for value addition and diversified uses.
Journal ArticleDOI
Study of Thermal Insulation Performance of Layered Jute Nonwoven: A Sustainable Material
TL;DR: An eco-friendly sustainable thermal insulator has been developed as a replacement of some commercially available manmade materials to control heat transfer in case of buildings, and semi-permanent/... as mentioned in this paper.
Journal ArticleDOI
Investigation of fabric shape retention evaluation based on image feature extraction by crease curve fitting
TL;DR: In this article, the authors proposed a method to fit fabric crease contour lines to Gaussian curves to optimize the fabric creases and describe the crease shape more intuitively.
References
More filters
Journal ArticleDOI
26—the “handle” of cloth as a measurable quantity
TL;DR: In this article, an instrument is described on which it is possible to measure the angle through which a specimen of cloth droops when a definite length is held out over an edge.
Journal ArticleDOI
The Mechanical Properties of Woven Fabrics Part II: The Bending of Woven Fabrics:
TL;DR: In this article, the plate buckling of woven fabrics is analyzed in terms of the known non-linear bending behavior of such fabrics, and a simplified form of this nonlinearity is found to explain the behavior of the fa...
Journal ArticleDOI
Part III: Shearing and Buckling of Various Commercial Fabrics
TL;DR: Load-deformation curves obtained by the methods for shearing and buckling de scribed in Part I and II are analyzed and discussed in this article, where parameters obtained from these curves are given for 66 commercial f...
Journal ArticleDOI
The Mechanical Properties of Woven Fabrics
P. Grosberg,N.M. Swani +1 more
TL;DR: In this paper, the initial load-extension modulus of a cloth is analyzed and is shown to depend not only on the bending modutus of the yarn and the geometry it takes up in the cloth, but also on the history of the fabric.
Journal ArticleDOI
Bending and Recovery Properties of Wool Plain-Knitted Fabrics
R.J. Hamilton,R. Postle +1 more
TL;DR: In this article, an experimental study is reported of the pure bending and recovering properties of wool plain-knitted fabrics for bending in the two principal directions of the fabric in two different directions.