scispace - formally typeset
Open AccessJournal ArticleDOI

Performance of partially replaced collapsible soil - Field study

Naema A. Ali
- 01 Sep 2015 - 
- Vol. 54, Iss: 3, pp 527-532
Reads0
Chats0
TLDR
In this article, the behavior and performance of compacted sand replacement over treated collapsible soil by prewetting and compaction are investigated in the form of plate loading tests conducted over improved collapsing soil.
Abstract
Soil collapse occurs when increased moisture causes chemical or physical bonds between the soil particles to weaken, which allows the structure of the soil to collapse. Collapsible soils are generally low-density, fine-grained combinations of clay and sand left by mudflows that have dried, leaving tiny air pockets. When the soil is dry, the cemented materials are strong enough to bond the sand particles together. When natural soil becomes wet, moisture alters the cementation structure and the soil’s strength is compromised, causing collapse or subsidence. Based on soil type and density, the potential for encountering collapsible soils throughout most of the project alignment is low. Conditions in arid and semi-arid climates like Borg El Arab, near Alexandria Egypt favor the formation of the most problematic collapsible soils. The behavior and performance of compacted sand replacement over treated collapsible soil by pre-wetting and compaction are investigated in the current study. Field investigation was performed in the form of plate loading tests conducted on compacted sand replacement over improved collapsible soil. Field plate load tests program was developed to explore the effect of compacted sand replacement thickness on collapsibility potential. Treated collapsible soil was replaced with imported cohesionless soil with variable thickness up to footing width. Results proved that the improvement of collapsible soils by sand/crushed stone replacement is possible to control/mitigate their risk potentials against sudden settlement when exposed to water. Replacement soil increases the rate and reduces the amount of footing settlement. For compacted collapsible soils, partial replacement by compacted sand/crushed stone layers decreases collapsibility potential risk. Results also, introduce the development of practical, economical and environmentally safe geochemical methods for collapsible soil stabilization and collapsible risk mitigation.

read more

Citations
More filters
Journal ArticleDOI

Enhancing mechanical behaviors of collapsible soil using two biopolymers

TL;DR: In this paper, two types of biopolymers (xanthan gum and guar gum) were used in this study due to their stable behaviors under severe conditions and their availability with reasonable prices.
Journal ArticleDOI

Experimental study of barrier effect on moisture movement and mechanical behaviors of loess soil

TL;DR: In this paper, the effect of coarse sand barrier on the water infiltration was investigated, and it was concluded that the existence of capillary barrier could effectively decrease the possibility of moisture movement and improve the mechanical behavior of loess soil in terms of strength and deformation.
Journal ArticleDOI

Feasibility of using electrokinetics and nanomaterials to stabilize and improve collapsible soils

TL;DR: In this article, an innovative method for stabilization and improvement of Gorgan loessial soil is presented, which uses electrokinetics and nanomaterials to instigate additives to move through soil pores, as an in situ remedial measure.
Journal ArticleDOI

Evaluation of Using Different Nanomaterials to Stabilize the Collapsible Loessial Soil

TL;DR: In this paper, the effect of three kinds of nanomaterials, including nano-silica (NS), nano-clay (NC) and nano-calcium carbonate (NCC), on the properties of a loessial collapsible soil was investigated.
Journal ArticleDOI

Stabilization of problematic soil by utilizing cementitious materials

TL;DR: In this paper, the behavior of treated host soil by four cementitious materials including cement, quicklime, gypsum and NaCl was determined by applying indirect and direct methods, and the results show that the addition of 6% quicklime will have the greatest effect on the reduction in collapsibility.
References
More filters
Journal ArticleDOI

Review of collapsing soils

TL;DR: In this article, it was shown that most of the collapse occurs at optimum clay content (10% in one case) and moisture content (between 13% and 39%) and that the amount and rate of collapse is a function of grain shape, grain size, existing moisture content, kinds and amounts of clay present, void ratio, adsorbed ions, etc.
Journal ArticleDOI

Evaluation and Control of Collapsible Soils

TL;DR: In this article, the authors investigate the effect of the soil type, compaction water content, initial dry unit weight and applied pressure at wetting on collapse potential, 138 single-oedometer tests were conducted on eight different soils.
Journal ArticleDOI

Loess improvement methods

TL;DR: In this paper, the present-day state of the methods of improvement of loess soils as a base and material for engineering constructions is discussed, and the applicability of these methods, their recent development as well as typical case histories have been discussed.
Journal ArticleDOI

Geotechnical Properties of Problematic Soils Emphasis on Collapsible Cases

TL;DR: In this paper, a series of laboratory tests were conducted to evaluate the collapsibility rate of collapsing soils in a semi-arid area, and some properties of soils such as dry density and liquid limit are helpful to estimate collapsibility potential of soils.
Proceedings ArticleDOI

Performance of Reinforced Collapsible Soil

Sherif Soliman, +1 more
TL;DR: In this paper, experimental investigation was carried out on prototype set-up to simulate the case of a surface rigid strip footing resting on collapsible soils, where geosynthetic layers were placed at the interface between the replaced and the collapsible soil layers and within the replaced soil layer.
Trending Questions (1)
How problems in field study affect performance?

The field study found that partially replacing collapsible soil with compacted sand can improve its performance by reducing settlement and increasing bearing capacity.