scispace - formally typeset
Journal ArticleDOI

Simultaneous Active and Reactive Power Control of Superconducting Magnet Energy Storage Using GTO Converter

Toshifumi Ise, +2 more
- 01 Jan 1986 - 
- Vol. 1, Iss: 1, pp 143-150
Reads0
Chats0
TLDR
In this article, a gate turn-off thyristor (GTO) converter is used to control reactive power in a superconducting magnet energy storage (SMES) in the wide range between lagging and leading phases.
Abstract
By using GTO's (Gate Turn-Off Thyristor) in place of ordinary thyristors in a conventional six pulse Greatz bridge converter, forced commutation is possible, so in the usage of ac-dc power conversion the reactive power of not only lagging but also leading phase can be absorbed. This feature enables superconducting magnet energy storage (SMES) to control reactive power in the wide range between lagging and leading phases. By virtue of this control ability , SMES will be applicable for a power system stabilyzer. A GTO converter which mainly consists of six GTO's was developed and tested. In this GTO converter, the energy stored in leakage inductances of the transformer is handled by voltage clipper circuit. Then, by using two sets of these GTO converters, we carried out some experiments of simultaneous active and reactive power control of SMES. The experiments on the developed control system were successfully performed and the ability of controlling reactive power in the wide range between lagging phase and leading phase was verified.

read more

Citations
More filters
Journal ArticleDOI

Energy storage systems for advanced power applications

TL;DR: In this article, the performance benefits of adding energy storage to power electronic compensators for utility applications are discussed. But, they do not represent energy sources, they provide valuable added benefits to improve stability power quality, and reliability of supply.
Journal ArticleDOI

An Overview of SMES Applications in Power and Energy Systems

TL;DR: In this article, the authors provide an overview and potential applications of the superconducting magnetic energy storage (SMES) technology in electrical power and energy systems, and a comparison is made among these three types of SMES.
Journal ArticleDOI

Application of superconducting magnet energy storage to improve power system dynamic performance

TL;DR: The application of superconducting magnet energy storage (SMES) to the stabilization of a power system with long-distance bulk power transmission lines which has the problem of poorly damped power oscillations is presented in this paper.

Commissioning tests of the Bonneville Power Administration 30 MJ superconducting magnetic energy storage unit

H. J. Boening, +1 more
TL;DR: A 30 MJ (8.4 kWh) superconducting magnetic energy storage (SMES) unit with a 10 MW converter has been installed and commissioned at the Bonneville Power Administration (BPA) substation in Tacoma, Washington as mentioned in this paper.
Journal ArticleDOI

Comparative performance evaluation of SMES–SMES, TCPS–SMES and SSSC–SMES controllers in automatic generation control for a two-area hydro–hydro system

TL;DR: In this article, the automatic generation control (AGC) of an interconnected two-area multiple-unit hydro-hydro system is presented. But the authors did not consider the effect of load disturbances on the system frequency.
References
More filters

Commissioning tests of the Bonneville Power Administration 30 MJ superconducting magnetic energy storage unit

H. J. Boening, +1 more
TL;DR: A 30 MJ (8.4 kWh) superconducting magnetic energy storage (SMES) unit with a 10 MW converter has been installed and commissioned at the Bonneville Power Administration (BPA) substation in Tacoma, Washington as mentioned in this paper.
Journal ArticleDOI

Commissioning Tests Of The Bonneville Power Administration 30 MJ Superconducting Magnetic Energy Storage Unit

TL;DR: A 30 MJ (8.4 kWh) superconducting magnetic energy storage (SMES) unit with a 10 MW converter has been installed and commissioned at the Bonneville Power Administration (BPA) substation in Tacoma, Washington as discussed by the authors.
Journal ArticleDOI

Superconducting magnetic energy storage for BPA transmission line stabilization

TL;DR: In this article, a 30 MJ (8.4 kWh) Superconducting Magnetic Energy Storage (SMES) unit with a 10 MW converter is installed at the Tacoma Substation to provide system damping for low frequency oscillations of 0.35 Hz.
Related Papers (5)