Journal ArticleDOI
The estimation of cement film thickness by an in vivo technique.
J W McLean,J A von Fraunhofer +1 more
About:
This article is published in British Dental Journal.The article was published on 1971-08-03. It has received 1023 citations till now.read more
Citations
More filters
DissertationDOI
An in vitro evaluation of the marginal integrity of CAD/CAM interim crowns compared to conventional interim resin crowns
Journal ArticleDOI
Analysis of The Reproducibility of Subgingival Vertical Margins Using Intraoral Optical Scanning (IOS): A Randomized Controlled Pilot Trial
Edoardo Ferrari Cagidiaco,Edoardo Ferrari Cagidiaco,Fernando Zarone,Nicola Discepoli,Tim Joda,Marco Ferrari +5 more
TL;DR: In this paper, the authors evaluated the capability of an IOS (Intra Oral Scanner) device, used in standardized conditions, to detect margins of abutments prepared with knife-edge finishing line located at three different levels in relation to the gingival sulcus.
Journal ArticleDOI
Effects of build orientation on adaptation of casting patterns for three-unit partial fixed dental prostheses fabricated by using digital light projection.
TL;DR: In this paper, a 3-unit partial fixed dental prosthesis with mandibular left second premolar and second molar abutment teeth was scanned and virtually designed with a computer-aided design software program.
Journal ArticleDOI
In vitro accuracy of digital and conventional impressions in the partially edentulous maxilla
Moritz Waldecker,Stefan Rues,Junior Sinclair Awounvo Awounvo,Peter Rammelsberg,Wolfgang Bömicke +4 more
TL;DR: In this paper , the authors compared the dimensional accuracy of conventional impressions (CI) with that of digital impressions (DI) in a partially edentulous maxilla with six prepared teeth.
Journal ArticleDOI
Influence of Sequential CAD/CAM Milling on the Fitting Accuracy of Titanium Three-Unit Fixed Dental Prostheses
TL;DR: In this paper, the fitting accuracy of fixed dental prostheses (FDP) after sequential CAD/CAM (Computer Aided Design/Computer-Aided Manufacturing) fabrication was investigated.