Recent startling interest for lanthanide luminescence is stimulated by the continuously expanding need for luminescent materials meeting the stringent requirements of telecommunication, lighting, electroluminescent devices, (bio-)analytical sensors and bio-imaging set-ups. This critical review describes the latest developments in (i) the sensitization of near-infrared luminescence, (ii) “soft” luminescent materials (liquid crystals, ionic liquids, ionogels), (iii) electroluminescent materials for organic light emitting diodes, with emphasis on white light generation, and (iv) applications in luminescent bio-sensing and bio-imaging based on time-resolved detection and multiphoton excitation (500 references).

/pdf/lanthanide-luminescence-for-functional-materials-and-bio-1w9cppwf8r.pdf

Lanthanide luminescence for functional materials and bio-sciences

Upconversion luminescent materials: advances and applications.

Photovoltaic (PV) technologies for solar energy conversion represent promising routes to green and renewable energy generation. Despite relevant PV technologies being available for more than half a century, the production of solar energy remains costly, largely owing to low power conversion efficiencies of solar cells. The main difficulty in improving the efficiency of PV energy conversion lies in the spectral mismatch between the energy distribution of photons in the incident solar spectrum and the bandgap of a semiconductor material. In recent years, luminescent materials, which are capable of converting a broad spectrum of light into photons of a particular wavelength, have been synthesized and used to minimize the losses in the solar-cell-based energy conversion process. In this review, we will survey recent progress in the development of spectral converters, with a particular emphasis on lanthanide-based upconversion, quantum-cutting and down-shifting materials, for PV applications. In addition, we will also present technical challenges that arise in developing cost-effective high-performance solar cells based on these luminescent materials.

Enhancing solar cell efficiency: the search for luminescent materials as spectral converters

The structure

Synthesis, Luminescent Properties, and Biomedical Applications Shili Gai,†,‡ Chunxia Li,† Piaoping Yang,*,‡ and Jun Lin*,† †State Key Laboratory of Rare Earth Resource Utilization, Changchun Institute of Applied Chemistry, Chinese Academy of Sciences, Changchun 130022, P. R. China ‡Key Laboratory of Superlight Materials and Surface Technology, Ministry of Education, Harbin Engineering University, Harbin, 150001, P. R. China

Recent Progress in Rare Earth Micro/Nanocrystals: Soft Chemical Synthesis, Luminescent Properties, and Biomedical Applications

Luminescent layers for enhanced silicon solar cell performance: Up-conversion

Erbium-doped sodium yttrium fluoride (NaYF4:Er3+) up-conversion phosphors were attached to the rear of a bifacial silicon solar cell to enhance its reponsivity in the near-infrared. The incident wavelength and light intensity were varied and the resulting short circuit current of the solar cell was measured. A close match between the spectral features of the external quantum efficiency and the phosphor absorption is consistent with the energy transfer up-conversion process. The peak external quantum efficiency of the silicon solar cell was measured to be (2.5±0.2)% under 5.1 mW laser excitation at 1523 nm, corresponding to an internal quantum efficiency of 3.8%.

/pdf/application-of-nayf-4-er-3-up-converting-phosphors-for-50jh0qr1wn.pdf

Application of NaYF 4 : Er 3 + up-converting phosphors for enhanced near-infrared silicon solar cell response

Silicon nanostructures for third generation photovoltaic solar cells

Efficiency enhancement of solar cells by luminescent up-conversion of sunlight

A silicon-based optoelectronic device that exhibits an enhanced response to subbandgap light is described. The device structure consists of a bifacial silicon solar cell with an up- converting (UC) layer attached to the rear. Erbium-doped sodium yttrium fluoride (NaY0.8F4 : Er0.2 3+) phosphors are the optically active centers responsible for the UC luminescence. The unoptimized device is demonstrated to respond effectively to wavelengths (lambda) in the range of 1480-1580 nm with an external quantum efficiency (EQE) of 3.4% occurring at 1523 nm at an illumination intensity of 2.4 W/cm2 (EQE = 1.4 times 10-2 cm2/W). An analysis of the optical losses reveals that the luminescence quantum efficiency (LQE) of the device is 16.7% at 2.4 W/cm2 of 1523-nm excitation (LQE = 7.0 times 10-2 cm2/W), while further potential device improvements indicate that an EQE of 14.0% (5.8 times 10-2 cm2/W) could be realistically achieved.

Avi Shalav

Papers

Luminescent layers for enhanced silicon solar cell performance: Up-conversion

Application of NaYF 4 : Er 3 + up-converting phosphors for enhanced near-infrared silicon solar cell response

Silicon nanostructures for third generation photovoltaic solar cells

Efficiency enhancement of solar cells by luminescent up-conversion of sunlight

Enhancing the Near-Infrared Spectral Response of Silicon Optoelectronic Devices via Up-Conversion