There is, I think, something ethereal about i —the square root of minus one. I remember first hearing about it at school. It seemed an odd beast at that time—an intruder hovering on the edge of reality.

Usually familiarity dulls this sense of the bizarre, but in the case of i it was the reverse: over the years the sense of its surreal nature intensified. It seemed that it was impossible to write mathematics that described the real world in …

I and i

Single-layer metal dichalcogenides are two-dimensional semiconductors that present strong potential for electronic and sensing applications complementary to that of graphene.

/pdf/electronics-and-optoelectronics-of-two-dimensional-2jbqr1unvw.pdf

Electronics and optoelectronics of two-dimensional transition metal dichalcogenides.

Energy harvested directly from sunlight offers a desirable approach toward fulfilling, with minimal environmental impact, the need for clean energy. Solar energy is a decentralized and inexhaustible natural resource, with the magnitude of the available solar power striking the earth’s surface at any one instant equal to 130 million 500 MW power plants.1 However, several important goals need to be met to fully utilize solar energy for the global energy demand. First, the means for solar energy conversion, storage, and distribution should be environmentally benign, i.e. protecting ecosystems instead of steadily weakening them. The next important goal is to provide a stable, constant energy flux. Due to the daily and seasonal variability in renewable energy sources such as sunlight, energy harvested from the sun needs to be efficiently converted into chemical fuel that can be stored, transported, and used upon demand. The biggest challenge is whether or not these goals can be met in a costeffective way on the terawatt scale.2

http://pubs.acs.org/doi/pdf/10.1021/cr1002326

Solar Water Splitting Cells

Ultrathin two-dimensional nanosheets of layered transition metal dichalcogenides (TMDs) are fundamentally and technologically intriguing. In contrast to the graphene sheet, they are chemically versatile. Mono- or few-layered TMDs - obtained either through exfoliation of bulk materials or bottom-up syntheses - are direct-gap semiconductors whose bandgap energy, as well as carrier type (n- or p-type), varies between compounds depending on their composition, structure and dimensionality. In this Review, we describe how the tunable electronic structure of TMDs makes them attractive for a variety of applications. They have been investigated as chemically active electrocatalysts for hydrogen evolution and hydrosulfurization, as well as electrically active materials in opto-electronics. Their morphologies and properties are also useful for energy storage applications such as electrodes for Li-ion batteries and supercapacitors.

http://nanotubes.rutgers.edu/PDFs/nchem_TMDs_2013.pdf

The chemistry of two-dimensional layered transition metal dichalcogenide nanosheets

We present a method for calculating the stability of reaction intermediates of electrochemical processes on the basis of electronic structure calculations. We used that method in combination with detailed density functional calculations to develop a detailed description of the free-energy landscape of the electrochemical oxygen reduction reaction over Pt(111) as a function of applied bias. This allowed us to identify the origin of the overpotential found for this reaction. Adsorbed oxygen and hydroxyl are found to be very stable intermediates at potentials close to equilibrium, and the calculated rate constant for the activated proton/electron transfer to adsorbed oxygen or hydroxyl can account quantitatively for the observed kinetics. On the basis of a database of calculated oxygen and hydroxyl adsorption energies, the trends in the oxygen reduction rate for a large number of different transition and noble metals can be accounted for. Alternative reaction mechanisms involving proton/electron transfer to ...

/pdf/origin-of-the-overpotential-for-oxygen-reduction-at-a-fuel-jdt5gxiyj8.pdf

Origin of the Overpotential for Oxygen Reduction at a Fuel-Cell Cathode

Negative surface energy - Clearing up confusion - Response

Strategies for improving the performance of nonprecious metal catalysts for the oxygen reduction reaction (ORR) can facilitate the cost-effective deployment of fuel cell devices. Electrocatalyst performance is typically improved via two approaches: increasing the number of active sites and increasing the intrinsic activity of the active site. Herein, we utilize these two methods of improving performance for MnSb2O6, which we have recently shown to be a promising ORR catalyst due to improvements in per-metal-site activity in the antimonate framework. First, electrode engineering is used to investigate the role of mass and conductive support loading in the observed ORR performance and selectivity. The apparent 2-electron selectivity is found to decrease with increases in mass and/or conductive support loading, indicating that rotating ring disk electrode studies do not necessarily measure the intrinsic selectivity of the catalyst. Second, theoretical calculations are used to identify Cr, Fe, and Ni as promising first-row transition metals for improving the intrinsic activity of MnSb2O6. Experimentally, the addition of Cr results in 3-fold and 2-fold increases in the mass and specific activities at 0.7 V vs the reversible hydrogen electrode, respectively. This enhancement is attributed to the modulation of the active site structure and Mn oxidation state with the addition of Cr. Through these studies, we gain insight into the intrinsic and extrinsic factors that govern ORR performance. 

Strategies for Modulating the Catalytic Activity and Selectivity of Manganese Antimonates for the Oxygen Reduction Reaction

In this work, we show using density functional theory calculations that controlling the spin state of the surface of magnetic metals has a substantial effect on their chemical properties. For a range of adsorbates, the adsorption energy is shown to be stronger on non-spin polarized surfaces than on spin polarized ground state surfaces. This is true for Fe, Co, and Ni surfaces, and the result is the same for three commonly used exchange–correlation functionals. We further discuss the origin of the effect in terms of the surface electronic structure and show that a simple model based on the d-band model of adsorption can explain the effect. Finally, we discuss how spin effects may be used to control surface reactivity and provide guidance on how to alter the surface spin state, e.g., adding a metal promotor. 

Spin Effects in Chemisorption and Catalysis

In this paper, the authors study the correlation between the catalytic activiyies of hydrotreating catalysts and their position in the periodic table.

Jens K. Nørskov

Papers

Negative surface energy - Clearing up confusion - Response

Strategies for Modulating the Catalytic Activity and Selectivity of Manganese Antimonates for the Oxygen Reduction Reaction

Spin Effects in Chemisorption and Catalysis

Experimental and theoretical studies of periodic trends and promotional behaviors of hydrotreating catalysts

Understanding Electrocatalysts for Low-Temperature Fuel Cells