J
Joseph Doetsch
Researcher at ETH Zurich
Publications - 113
Citations - 2629
Joseph Doetsch is an academic researcher from ETH Zurich. The author has contributed to research in topics: Ground-penetrating radar & Aquifer. The author has an hindex of 27, co-authored 111 publications receiving 2167 citations. Previous affiliations of Joseph Doetsch include Lawrence Berkeley National Laboratory & Aarhus University.
Papers
More filters
Journal ArticleDOI
Zonation for 3D aquifer characterization based on joint inversions of multimethod crosshole geophysical data
TL;DR: In this article, a methodology for aquifer characterization based on structural joint inversion of multiple geophysical data sets followed by clustering to form zones and subsequent inversion for zonal parameters was developed.
Journal ArticleDOI
The seismo-hydromechanical behavior during deep geothermal reservoir stimulations: open questions tackled in a decameter-scale in situ stimulation experiment
Florian Amann,Florian Amann,Valentin Gischig,Keith F. Evans,Joseph Doetsch,Reza Jalali,Benoît Valley,Hannes Krietsch,Nathan Dutler,Linus Villiger,Bernard Brixel,Maria Klepikova,Anniina Kittilä,Claudio Madonna,Stefan Wiemer,Martin O. Saar,Simon Loew,Thomas Driesner,Hansruedi Maurer,Domenico Giardini +19 more
TL;DR: The In situ Stimulation and Circulation (ISC) experiment at the Grimsel Test Site in Switzerland as discussed by the authors was designed to address open research questions in a naturally fractured and faulted crystalline rock mass, and two hydraulic injection phases were executed to enhance the permeability of the rock mass.
Journal ArticleDOI
3D crosshole ERT for aquifer characterization and monitoring of infiltrating river water
Ilaria Coscia,Stewart Greenhalgh,Niklas Linde,Joseph Doetsch,Laurent Marescot,Thomas Günther,Tobias Vogt,Alan G. Green +7 more
TL;DR: In this paper, a 3D crosshole electrical resistivity tomography (ERT) is used to define the main lithological structures within the aquifer (through static inversion) and to monitor the water infiltration from an adjacent river.
Journal ArticleDOI
Constraining 3-D electrical resistance tomography with GPR reflection data for improved aquifer characterization
TL;DR: In this paper, surface-based ground penetrating radar (GPR) and electrical resistance tomography (ERT) data have been recorded on an exposed gravel bar within a restored section of a previously channelized river in northeastern Switzerland to characterize an underlying gravel aquifer.
Journal ArticleDOI
Full-waveform inversion of cross-hole ground-penetrating radar data to characterize a gravel aquifer close to the Thur River, Switzerland
Anja Klotzsche,Jan van der Kruk,Giovanni Angelo Meles,Joseph Doetsch,Hansruedi Maurer,Niklas Linde +5 more
Abstract: Cross‐hole radar tomography is a useful tool for mapping shallow subsurface electrical properties viz. dielectric permittivity and electrical conductivity. Common practice is to invert cross‐hole radar data with ray‐based tomographic algorithms using first arrival traveltimes and first cycle amplitudes. However, the resolution of conventional standard ray‐based inversion schemes for cross‐hole ground‐penetrating radar (GPR) is limited because only a fraction of the information contained in the radar data is used. The resolution can be improved significantly by using a full‐waveform inversion that considers the entire waveform, or significant parts thereof. A recently developed 2D time‐domain vectorial full‐waveform cross‐hole radar inversion code has been modified in the present study by allowing optimized acquisition setups that reduce the acquisition time and computational costs significantly. This is achieved by minimizing the number of transmitter points and maximizing the number of receiver positions. The improved algorithm was employed to invert cross‐hole GPR data acquired within a gravel aquifer (4–10 m depth) in the Thur valley, Switzerland. The simulated traces of the final model obtained by the full‐waveform inversion fit the observed traces very well in the lower part of the section and reasonably well in the upper part of the section. Compared to the ray‐based inversion, the results from the full‐waveform inversion show significantly higher resolution images. At either side, 2.5 m distance away from the cross‐hole plane, borehole logs were acquired. There is a good correspondence between the conductivity tomograms and the natural gamma logs at the boundary of the gravel layer and the underlying lacustrine clay deposits. Using existing petrophysical models, the inversion results and neutron‐neutron logs are converted to porosity. Without any additional calibration, the values obtained for the converted neutron‐neutron logs and permittivity results are very close and similar vertical variations can be observed. The full‐waveform inversion provides in both cases additional information about the subsurface. Due to the presence of the water table and associated refracted/reflected waves, the upper traces are not well fitted and the upper 2 m in the permittivity and conductivity tomograms are not reliably reconstructed because the unsaturated zone is not incorporated into the inversion domain.