다중혈관 관상동맥 환자에서 y-문합을 이용하여 양쪽 내흉동맥만을 사용한 우회술의 조기 성적

[신간의 별자리x] 우리/미술, 그리고 ‘슬픔의 박물관’

Applications in Theranostics Guanying Chen,*,†,‡ Hailong Qiu,†,‡ Paras N. Prasad,*,‡,§ and Xiaoyuan Chen* †School of Chemical Engineering and Technology, Harbin Institute of Technology, Harbin, Heilongjiang 150001, China ‡Department of Chemistry and the Institute for Lasers, Photonics, and Biophotonics, University at Buffalo, State University of New York, Buffalo, New York 14260, United States Department of Chemistry, Korea University, Seoul 136-701, Korea Laboratory of Molecular Imaging and Nanomedicine, National Institute of Biomedical Imaging and Bioengineering, National Institutes of Health, Bethesda, Maryland 20892-2281, United States

Upconversion Nanoparticles: Design, Nanochemistry, and Applications in Theranostics

High-performance gas sensors prepared using p-type oxide semiconductors such as NiO, CuO, Cr2O3, Co3O4, and Mn3O4 were reviewed. The ionized adsorption of oxygen on p-type oxide semiconductors leads to the formation of hole-accumulation layers (HALs), and conduction occurs mainly along the near-surface HAL. Thus, the chemoresistive variations of undoped p-type oxide semiconductors are lower than those induced at the electron-depletion layers of n-type oxide semiconductors. However, highly sensitive and selective p-type oxide-semiconductor-based gas sensors can be designed either by controlling the carrier concentration through aliovalent doping or by promoting the sensing reaction of a specific gas through doping/loading the sensor material with oxide or noble metal catalysts. The junction between p- and n-type oxide semiconductors fabricated with different contact configurations can provide new strategies for designing gas sensors. p-Type oxide semiconductors with distinctive surface reactivity and oxygen adsorption are also advantageous for enhancing gas selectivity, decreasing the humidity dependence of sensor signals to negligible levels, and improving recovery speed. Accordingly, p-type oxide semiconductors are excellent materials not only for fabricating highly sensitive and selective gas sensors but also valuable additives that provide new functionality in gas sensors, which will enable the development of high-performance gas sensors.

Highly sensitive and selective gas sensors using p-type oxide semiconductors: Overview

Photovoltaic (PV) technologies for solar energy conversion represent promising routes to green and renewable energy generation. Despite relevant PV technologies being available for more than half a century, the production of solar energy remains costly, largely owing to low power conversion efficiencies of solar cells. The main difficulty in improving the efficiency of PV energy conversion lies in the spectral mismatch between the energy distribution of photons in the incident solar spectrum and the bandgap of a semiconductor material. In recent years, luminescent materials, which are capable of converting a broad spectrum of light into photons of a particular wavelength, have been synthesized and used to minimize the losses in the solar-cell-based energy conversion process. In this review, we will survey recent progress in the development of spectral converters, with a particular emphasis on lanthanide-based upconversion, quantum-cutting and down-shifting materials, for PV applications. In addition, we will also present technical challenges that arise in developing cost-effective high-performance solar cells based on these luminescent materials.

Enhancing solar cell efficiency: the search for luminescent materials as spectral converters

Cesium lead halide (CsPbX3) perovskite nanocrystals (NCs) have demonstrated extremely excellent optical properties and great application potentials in various optoelectronic devices. However, because of the anion exchange, it is difficult to achieve white-light and multicolor emission for practical applications. Herein, we present the successful doping of various lanthanide ions (Ce3+, Sm3+, Eu3+, Tb3+, Dy3+, Er3+, and Yb3+) into the lattices of CsPbCl3 perovskite NCs through a modified hot-injection method. For the lanthanide ions doped perovskite NCs, high photoluminescence quantum yield (QY) and stable and widely tunable multicolor emissions spanning from visible to near-infrared (NIR) regions are successfully obtained. This work indicates that the doped perovskite NCs will inherit most of the unique optical properties of lanthanide ions and deliver them to the perovskite NC host, thus endowing the family of perovskite materials with excellent optical, electric, or magnetic properties.

Doping Lanthanide into Perovskite Nanocrystals: Highly Improved and Expanded Optical Properties

Quantum cutting can realize the emission of multiple near-infrared photons for each ultraviolet/visible photon absorbed, and has potential to significantly improve the photoelectric conversion efficiency (PCE) of solar cells. However, due to the lack of an ideal downconversion material, it has merely served as a principle in the laboratory until now. Here, the fabrication of a novel type of quantum cutting material, CsPbCl1.5 Br1.5 :Yb3+ , Ce3+ nanocrystals is presented. Benefiting from the larger absorption cross-section, weaker electron-phonon coupling, and higher inner luminescent quantum yield (146%), the doped perovskite nanocrystals are successfully explored as a downconverter of commercial silicon solar cells (SSCs). Noticeably, the PCE of the SSCs is improved from 18.1% to 21.5%, with a relative enhancement of 18.8%. This work exhibits a cheap, convenient, and effective way to enhance the PCE of SSCs, which may be commercially popularized in the future.

Cerium and Ytterbium Codoped Halide Perovskite Quantum Dots: A Novel and Efficient Downconverter for Improving the Performance of Silicon Solar Cells.

A 2D surface plasmon photonic crystal (SPPC) is achieved by implanting gold nanorods onto the periodic surface apertures of the poly(methyl methacrylate) (PMMA) opal photonic crystals. On the surface of the SPPC, the overall upconversion luminescence intensity of NaYF4 :Yb(3+) , Er(3+) under 980 nm excitation is improved more than 10(3) fold. The device is easily shifted to a transparent flexible substrate, applied to flexible displays.

Local Field Modulation Induced Three‐Order Upconversion Enhancement: Combining Surface Plasmon Effect and Photonic Crystal Effect

Intracellular pH sensing is of importance and can be used as an indicator for monitoring the evolution of various diseases and the health of cells. Here, we developed a new class of surface-functionalized MXene quantum dots (QDs), Ti3C2, by the sonication cutting and hydrothermal approach and further explored their intracellular pH sensing. The functionalized Ti3C2 QDs exhibit bright excitation-dependent blue photoluminescence (PL) originating from the size effect and surface defects. Meanwhile, Ti3C2 QDs demonstrate a high PL response induced by the deprotonation of the surface defects. Furthermore, combining the highly pH sensitive Ti3C2 QDs with the pH insensitive [Ru(dpp)3]Cl2, we developed a ratiometric pH sensor to quantitatively monitor the intracellular pH values. These novel MXene quantum dots can serve as a promising platform for developing practical fluorescent nanosensors.

Ratiometric photoluminescence sensing based on Ti3C2 MXene quantum dots as an intracellular pH sensor

Localized surface plasmon resonances (LSPRs) are achieved in heavily doped semiconductor nanoparticles (NPs) with appreciable free carrier concentrations. In this paper, we present the photonic, electric, and photoelectric properties of plasmonic Cu2–xS NPs/films and the utilization of LSPRs generated from semiconductor NPs as near-infrared antennas to enhance the upconversion luminescence (UCL) of NaYF4:Yb3+,Er3+ NPs. Our results suggest that the LSPRs in Cu2–xS NPs originate from ligand-confined carriers and that a heat treatment resulted in the decomposition of ligands and oxidation of Cu2–xS NPs; these effects led to a decrease of the Cu2+/Cu+ ratio, which in turn resulted in the broadening, decrease in intensity, and red-shift of the LSPRs. In the presence of a MoO3 spacer, the UCL intensity of NaYF4:Yb3+,Er3+ NPs was substantially improved and exhibited extraordinary power-dependent behavior because of the energy band structure of the Cu2–xS semiconductor. These findings provide insights into the na...

Wen Xu

Papers

Doping Lanthanide into Perovskite Nanocrystals: Highly Improved and Expanded Optical Properties

Cerium and Ytterbium Codoped Halide Perovskite Quantum Dots: A Novel and Efficient Downconverter for Improving the Performance of Silicon Solar Cells.

Local Field Modulation Induced Three‐Order Upconversion Enhancement: Combining Surface Plasmon Effect and Photonic Crystal Effect

Ratiometric photoluminescence sensing based on Ti3C2 MXene quantum dots as an intracellular pH sensor

Observation of Considerable Upconversion Enhancement Induced by Cu2–xS Plasmon Nanoparticles